The flow field of double-row annular cascades of hydraulic turbines is studied by means of digital analysis in combination with model tests.
采用数值分析与模型实验相结合的方法，对水轮机导水部件双列环列叶栅流场进行了分析研究。
The composition on general Analysis Software of steam turbine Thermal Performance Tests is introduced, and general calculation model of heater for steam turbine is given.
介绍了汽轮机组热力性能试验通用分析软件的组成，给出了汽轮机加热器的通用计算模型。
The theoretical analysis and numerical tests both show that this model strictly obeys the conservation law of mass and momentum.
理论分析和数值试验的结果都表明，本模型严格地满足质量守恒定律和动量定理。
Through the analysis of karst characters and study of simulated tests, the paper explores environment of formation and evolution of karst and hydrogeochemistry and hydrodynamic alteration model.
本文通过岩溶特征分析和模拟试验研究，探索了岩溶形成演化环境及水文地球化学和水动力学蚀变模型。
And the correctness of the above analysis has been proved by the quantitative calculation with the unbalanced response program of shafting and tests on a model rotor.
并且应用轴系不平衡响应程序进行定量的计算和通过模型转子试验验证了以上分析的正确性。
The property of the flow over a rectangular splitting-flow pier is studied by means of theoretical analysis combined with series of model tests.
本文通过理论分析和模型试验研究了越过矩形分流墩的水流流态及墩上游自由水面特性。
After a detailed analysis of multi-media network on remote satellite tests, a virtual special multi-media network model using IP exchange nets was proposed.
对于远程测试多媒体网络的需求进行了详尽的分析，提出了一种利用IP分组交换网建立虚拟专用网络的网络模型。
Some important dynamic responsive parameters are worked out about the reinforced earth structure under the impelling loads of train by model tests and analysis of dynamic characteristics.
通过对铁路加筋土挡墙在列车重复荷载作用下的室内模型试验和动力特性分析，得出了加筋土挡培在动力荷载作用下的一些重要动态响应参数。
Based on the study of predecessor, the in-situ test theories and consolidation characteristics of dredger soil under vacuum pressure were studied by theoretical analysis and model tests.
本文在总结前人研究成果的基础上，通过模型建立、理论分析和模型试验等方法对土的固结系数及渗透系数的原位测试理论和吹填淤泥真空固结特性进行了研究。
This paper describes the model tests of shallow water resistance and presents test result analysis of an inland river hydrofoil boat.
本文介绍对一艘内河水翼艇所作的浅水阻力模型试验及对试验结果的总结分析。
Airplane tail loads are difficult to determine accurately by means of model tests and theoretical analysis. In order to obtain reliable tail load data, it should be determined by flight tests.
用分析和模型试验方法难以确定可靠的尾翼载荷，所以要求通过飞行试验获取尾翼载荷数据，但因测载技术复杂，精确地测定尾翼载荷亦是困难的。
In this paper, the application of model parameters identification in dynamic tests of structural model are discussed and the associated theory and data analysis methods are also presented.
本文主要论述试验模态分析技术在建筑结构模型动态参数识别中的应用。
The erosion mechanism of highway subgrade along river bend is studied by using theory analysis and model tests.
着重对河湾路基侵蚀机理进行了理论分析与试验研究。
After thorough analysis these tests data, design a corresponding ARMA model.
深入分析寿命试验数据，并对其建立arma模型。
The settlement data of model tests are in general agreement with the calculated values on models of numerical analysis.
模型试验实测沉降量与用分层总和法、数值分析法计算结果接近。
Conclusion the ROC regression model can be effectively applied to the ROC analysis of continuous measurements in diagnostic tests.
结论文中给出的ROC回归模型可以有效地用于连续变量诊断试验数据的ROC分析。
The paper makes an analysis of the results of wind Tunnel tests on the ball model with hollow base.
本文给出了底凹弹丸模型风洞实验结果的分析。
With engineering tests, the numerical model and the correspondent analysis are proved to be effective in the engineering design of oil-gas separators.
随后进行的工程试验证明数值模拟所用的计算模型是有效的，相应的机理分析也是正确的。
The tests results show good forecast ability of the ECR analysis model and the feasibility of ECR in the practical rotor control.
通过对操纵响应试验结果的对比分析，证明了理论计算模型的正确性，同时也说明电控旋翼完全可用于旋翼操纵。
Established geological model of western XX oil fields, parameters statistical analysis and comparison tests proved modeling strategy adopted is right and the geological model established is reliable.
建立了西部XX油田的地质模型，通过统计参数对比分析和抽稀检验证明所采用的建模策略是对的，建立的地质模型是可靠的。
The accuracy of the proposed method is demonstrated with the displacement-controlled finite element numerical analysis and existing centrifuge model tests.
结合位移控制有限元数值模拟和既有离心模型试验结果进行对比分析，验证该方法的有效性。
After theoretical analysis, small scale model tests are done. Two slope angles: 1:1 and 1:1.2;
理论分析之后，作者进行了室内静力模型试验，模拟了两种边坡坡比：1：1和1：1．2；
Based on dimensional analysis, a number of dimensionless groups that governed the performance of the quay wall were investigated, identified and used to design and interpret centrifuge model tests.
基于量纲分析，首先研究确定了控制这种岸壁码头性状的无量纲项，然后，为研究这些无量纲项的相对重要性，设计了模型试验，并对试验结果分析解释。
Moreover, a finite element model is developed and verified against tests, and the results from the finite element analysis agree well with the experimental data.
采用有限元模型对试验进行了模拟验证，计算结果与试验结果吻合良好。
A drawing model of slumping salvage was designed, and a preliminary analysis on drawing salvage is performed through slumping salvage tests in swampy land.
设计了陷落体救助模型系统，进行了沼泽湿地陷落体救助室内试验研究，对救助拉拔过程进行了初步的探讨。
Model tests were conducted to verify the correctness of the quantitative analysis method.
通过模型桩验证了此量化分析方法的正确性。
A creep mathematical model of coal containing gas has been set up through creep tests and analysis under the condition of triaxial compression.
作者通过对含瓦斯煤样在三维受力状态下流变特性的研究，得出了含瓦斯煤样蠕变行为的数学模型，能够比较好地阐明突出的机理。
A "Separating model and support (SMS) method" for measuring support interference is proposed according to the analysis of the support interference for vehicle model wind tunnel tests in this paper.
基于传统的风洞试验支撑设备，设计了用于低速风洞测量大攻角模型支架干扰的组合支撑设备。
During the model test, integrity modal parameters are obtained via the single-input multi-output analysis method. The reliability of tests signals is also evaluated by the coherence function.
模态测试时，利用单点(多激振点)激励多点响应模态试验分析方法来获取完整模态参数，引入相关函数分析测试信号的可靠性。
During the model test, integrity modal parameters are obtained via the single-input multi-output analysis method. The reliability of tests signals is also evaluated by the coherence function.
模态测试时，利用单点(多激振点)激励多点响应模态试验分析方法来获取完整模态参数，引入相关函数分析测试信号的可靠性。
应用推荐