In this paper the mathematical model of this hybrid suspension system is induced, its characteristics are analyzed, and a controller is designed to ensure its fixed suspension gap.
本文建立了该混合悬浮系统的数学模型，分析了它的一些性质，采用定气隙控制指标，设计了使系统稳定的控制器，并对所设计的控制器进行了仿真。
On the basis of this, the integrated finite element model of motorcycle has been established including frame, engine, suspension, wheel, rider and oil box etc.
并基于此，建立整车的有限元模型，包括车架、发动机、悬架、轮胎、乘员、油箱等。
This paper deals with magnetic Suspension system and its operating principle and mathematic model set up.
本文介绍了磁悬浮系统的组成以及它的工作原理，建立了数学模型。
By introducing guiding effect of suspension, side-slip of tires, and the concept of effective road input, a vehicle vibration model of 15 DOFs is set up.
通过引入悬架导向作用、轮胎侧偏效应及有效路形概念，建立了15自由度整车振动模型。
A model of the integrated dynamic control system of electric power steering (EPS) and active-suspension is set up according to the principle of vehicle system dynamics.
文章根据汽车系统动力学原理，建立了汽车电动助力转向和主动悬架集成控制的动力学模型。
A handling simulation multibody model of a midibus is built using ADAMS/VIEW after we consider the steer system, front and rear air suspension.
在详细的考虑转向机构、前后空气悬架、车身等部件的基础上，利用ADAMS/VIEW软件建立了某中型客车的操纵稳定性多体模型。
According to the fundamental principle of vehicle dynamics, this paper established a full car model of Active Suspension System (ASS) and Electric Power Steering System (EPS).
本文根据车辆动力学基本原理，建立了主动悬架与电动助力转向系统的整车模型。
The model provides the basis for dynamic behavior analysis, process predictive control and optimization of VCM suspension polymerization.
此模型为氯乙烯悬浮聚合过程的动态特性分析、过程预测控制和优化提供了基础条件。
The finite element model of the free vibration for the rigid suspension catenary and pantograph is set up.
建立刚性悬挂接触网的自由振动有限元模型，计算其固有频率和振型。
With the 4 degree freedom half vehicle model, dynamic optimal design method of semi active control in automobile suspension is investigated.
建立了具有4自由度的半汽车模型，研究了汽车悬架系统半主动控制的动态优化方法。
The rigid body model of single suspension magnet are established with flux density as state variable and the system stability is analyzed with flux feedback control.
建立以磁场强度为状态变量的单悬浮电磁铁刚体模型，分析磁通反馈控制下系统的稳定性。
A fuzzy logic controller was developed for the suspension system, based on a damping-controlled (semi-active) suspension system model.
在基于阻尼控制的半主动悬架系统模型基础上，设计了悬架系统模糊逻辑控制器。
Based on the suspension model of a homemade car with 5-degree freedom and a road surface model in time domain, the nonlinear spring and damping parameters were optimized in time domain.
针对国产某微型轿车，在建立汽车悬架系统5自由度模型和时域路面模型基础上，对悬架系统的线性弹簧和非线性阻尼参数进行了优化。
This paper discusses how to control a two axes magnetic suspension flexible beam system, which is a simplified model for magnetic bearing.
讨论了双轴磁悬挂柔性梁系统的控制问题，该系统是磁悬浮轴承的简化模型。
Kinematic model is an issue exists in suspension rigid body does not take into account the deformation of the deformation of rubber bearing gap between the various structures.
运动学模型中存在的一个问题是未考虑悬架刚体的变形、橡胶支承的变形及各结构之间的间隙。
In this paper, a finite element model for the analysis of the pipeline suspension bridge was set up with considering the initial internal force and verticality of the staying cable.
本文建立了悬索管桥分析的有限元模型，并考虑了悬索管桥恒载产生的初始内力、拉索垂度等几何非线性因素。
Three-dimension finite element model is built according to the actual structural characteristic of suspension pipe bridge.
按照悬索式管桥的实际结构特点，建立了三维有限元模型。
The results show that using suspension grade (SG) model makes the calculation and analysis results of the suspension velocity of particle more accurate.
结果显示，采用悬浮分级模型提高了颗粒悬浮速度的分析和计算精度。
Kinetic model of piecewise-linear nonlinear suspension system is established, the analytic solutions of suspension system with dominant and assistant springs are derived by means of KB Method.
以研究主、副簧组成的悬架系统出发，建立了分段线性非线性悬架系统的动力学模型，运用KB方法求出了此类系统运动的解析解。
In this paper, FEM is used to establish the calculating model of beam axle of compound suspension. After verification by experiment, the model is employed for stress analysis of beam axle.
本文用有限元方法建立复合式悬架车桥的计算模型，经试验验证后，用于车桥横梁的应力分析。
Integrating with dynamic function, the hydrodynamic inducement of sediment suspension and a conceptual model for nutrient release from sediment in large shallow lake were suggested.
结合水动力作用，提出了大型浅水湖泊水动力作用导致底泥悬浮，从而使得底泥中的可溶性营养物质释放这一内源释放的概念性模式。
The finite element method was applied to model the complex suspension chassis and the component mode synthesis superelement theory was applied to reduce the dimension of the chassis dynamic model.
建立了复杂悬浮架有限元模型，利用模态综合动力凝聚超单元方法生成较低维数的悬浮架动力学模型。
The paper presents an active suspension experiment system with pneumatic artificial muscle as actuators according to the 1/4 suspension mechanism model.
以气动肌肉作为新型执行器，创建基于1/4悬架模型的汽车主动悬架系统。
But even the least - expensive model comes with a specially laminated windshield that helps keep the cabin quiet, and the agile suspension that holds the road so well.
不过即便是最便宜的车型也配备了特殊处理过的夹层挡风玻璃，有助于保持车厢内的安静，灵敏的避震器赋予了车子良好的抓地性能。
Some results are provided concerning an example of a spacial suspension model to show efficiency of this method.
结合一个悬架空间问题的应用实例给出了一些计算结果以说明分析方法的实用性和有效性。
The physical model and mathematical model are established for a multi spindled hydropneumatic balanced suspension.
建立了多轴油气平衡悬架的物理模型和数学模型。
The physical model and mathematical model are established for a multi spindled hydropneumatic balanced suspension.
建立了多轴油气平衡悬架的物理模型和数学模型。
应用推荐