If you process a request in a different thread which is running in another process context, you would not be able to read user mode memory across process boundaries.
如果你处理一个不同线程的请求，而这个线程却又运行在另外一个进程的上下文中，你也许不能正常的跨越进程分界线来读取用户态内存。
Because the bindings mode connection USES Shared memory, there is no overhead associated with transport over a network connection.
因为绑定模式连接使用共享内存，所以不存在与网络连接上的传输关联的开销。
This mode provides more protection, because the data is mirrored to another node, just in volatile memory instead of the non-volatile disk.
该模式提供更多保护，因为数据被镜像到另一个节点，这仅仅是针对易失性内存，而不是非易失性磁盘。
If there are users or applications connecting in bindings mode (using Shared memory), the operating system will authenticate them using an ID and a password.
如果有用户或应用程序以绑定模式连接(使用共享内存)，操作系统将使用ID和密码对其进行身份验证。
Line 18 in Listing 2 illustrates the memory indirect addressing mode.
清单2中的第18行演示内存直接寻址模式。
In this mode, the Write operation is acknowledged after the data is stored on the local disk and mirrored to the peer node's memory.
在这种模式下，写操作是在数据存储到本地磁盘并镜像到对等节点内存后被确认的。
The second value is the threshold for a memory pressure mode to begin to apply pressure to buffer usage.
第二个值是内存压力模式开始对缓冲区使用应用压力的上限。
Above the kernel, running in user mode, are the device drivers, each one running as a separate process tightly restricted by the memory management hardware to accessing only its own memory.
设备驱动处于内核之上，运行在用户态。每个驱动都作为单独的进程运行，受到内存管理硬件的严格约束，只能访问自己拥有的内存。
When the system is powered on again it reads information from the hard drive back into memory and should pick up where it left off, just like waking from sleep mode.
当系统重新启动时，它将有关信息从硬盘读入内存并恢复休眠前的状态，就像从睡眠模式醒来一样。
The most obvious addressing mode for accessing main memory is called direct addressing mode.
访问主存最显而易见的寻址模式称为直接寻址模式。
This register is used to limit the amount of memory that a partition can access in real mode.
这个寄存器用于限制分区在实模式中可以访问的内存量。
The memory (or semi -) synchronous mode is a variation of both synchronous and asynchronous.
内存异步模式(或半异步模式)是介于同步模式和异步模式之间的一个变体。
Memory leaks when resuming from sleep mode.
从睡眠模式中唤醒后，造成内存泄露。
Here, memory indirect addressing mode (line 33) is used to access the command table along with an offset in ESI (and EDI) and a multiplier.
这里使用内存间接寻址模式(第31行)访问命令表，还使用了ESI(和EDI)中的偏移量和一个乘数。
To resolve the problem, run UDF in an unfenced mode or reduce database Shared memory set to no more than 5 segments.
要解决这个问题，可以在unfenced模式下运行udf，或者将数据库共享内存减少至不多于5个段。
The Linux kernel operates in a virtual memory mode: for every virtual page there is a corresponding physical page of memory in the system.
Linux内核工作于虚拟内存模式：每一个虚拟页对应一个相应的系统内存的物理页。
The register indirect addressing mode uses a register to specify the whole address for the memory access. This is used for numerous situations, including, but not limited to
寄存器间接寻址模式使用一个寄存器来指定内存访问的整个地址。
RMM will also work over InfiniBand and Shared memory, and can operate in either multicast (one-to-many) or unicast (one-to-one) mode.
RMM也将在InfiniBand和共享内存之上运行，能够以多点广播(一对多)和单点广播(一对一)的模式进行操作。
Such as when the VM executes code in kernel mode; then VMWare has to carefully translate the memory mapping and permissions in order to simulate the VM's virtual CPU correctly.
比如，当VM以内核模式执行代码时；为了正确地仿真VM的虚拟cpu,VMWare必须谨慎地转换内存映射和权限。
Working on a 32-bit system, you can address 4 GB of memory, out of this 2 GB is typically reserved to the Operating System and 2 GB are allowed for each user mode process, such as w3wp.exe
工作在32位系统上，可以寻址4GB内存。
In register mode, rather than accessing the contents of main memory, you access registers.
在寄存器寻址模式中，我们也不会访问主存的内容，而是访问寄存器。
I've started the HSQLDB database in embedded mode using the memory-based database option.
我使用了基于内存的数据库选项在内嵌模式下开启了HSQLDB数据库。
The ppe does this through memory-mapped register access from kernel mode, while the SPE writes to its DMA channels from code running on the SPU.
PPE可以通过在内核模式中使用内存映射寄存器来发起dma传输，而SPE则可以使用在SPU上运行的代码来写入dma通道。
They need to be locked because the memory will be accessed by kernel-mode drivers and cannot be paged out for the duration of the access.
这是因为内核驱动程序需要访问这些内存，在此期间这些页面不能交换出去。
When you enable System cache mode on a computer that USES Unified Memory Architecture-based video hardware or AGP, you may experience a severe and random decrease in performance.
当您启用的计算机上使用统一内存架构的系统缓存模式视频硬件或AGP，您可能会遇到严重的性能和随机下降。
Low memory mode now reduces the scale of imported textures in a stricter manner.
低内存模式，现在使用更严格的方式降低导入模型的纹理尺度。
ENTer button. This button is used to program frequencies in memory. See the section PROGRAMMING MODE for more information on using the program operation.
确认按钮，用来对已编程的频率记忆，了解编程操作更多的信息请参看编程模式相关章节。
In development and test mode, HSQLDB USES an in-memory datastore.
在development和test模式下，HSQLDB使用内存中的数据存储。
Accumulator - Memory mode is fully switchable.
蓄电池-记忆模式是完全切换。
Accumulator - Memory mode is fully switchable.
蓄电池-记忆模式是完全切换。
应用推荐