Meanwhile, the Penjing plants must be grown in greenhouses with mesh screening of less than 1.6 mm 2 years before export, and 0.6 mm 6 months before export.
同时，出口前2年须种植在网径小于1.6毫米的网室中，出口前6个月须种植在网径小于0.6毫米的网室内。
If you have high blood pressure, cutting back on booze could produce a small but significant drop of 2 to 4 mm Hg systolic (the top number) and 1 to 2 mm Hg diastolic (the bottom number).
如果你有高血压，那么当你减少饮酒量时，可以使心脏收缩压有很小但又有意义的下降，可以下降2- 4毫米汞柱(上面的数即分子数值)，以及心脏舒张压下降1 - 2毫米汞柱(下面的数即分母数值)。
You want to make holes close to the ribbon but not too close, give them room to breathe, maybe 1 or 2 mm.
针孔尽量靠近固定的带子，但也不要太靠近，要留一点空，大约一两毫米。
35 mm film has the dimensions 36 mm by 24 mm (3:2 ratio) - golden mean ration of 1.6 to 1 Points of intersection are recommended as places to position important elements in your picture.
35mm胶片尺寸为36毫米*24毫米（3：2的比率）-建议在你的照片中于黄金分割率1.6：1的交点处布局重要的要素。
Can you take a stainless cane with 3 mm in diameter and drill a hole of 2 mm alongside the cane at the depth of 3 cm?
你能否用一根直径为3mm的不锈钢棒，在旁边钻出一个直径为2 mm、深度为3cm的孔？
The chlorination is performed in a tubular reactor of Duran glass about 2 m high and 200 mm in diameter.
氯化处理是在一个管状的2米高200毫米直径的杜拉玻璃反应器中进行的。
They range from 2 25 mm long and are usually yellow, brown, red, or black.
他们从2月25日毫米长，通常是黄色，棕色，红色或黑色。
However, caution is advised if the alar base has been previously excised, if the alar base incisions extend more than 2 mm above the alar groove, and the lateral nasal artery is damaged bilaterally.
但是，对那些在术前已做过鼻翼基底切除， 鼻翼基底切口在鼻翼沟上方超过2毫米和双侧侧鼻动脉受损过的病例仍要保持警悌。
Clean sand requirement, there should be no sawdust, stones and other sundry, particle size between 1 ~ 2 mm, Fried dry before use.
砂粒要求洁净，不应有木屑、石块等杂物，粒径在1 ~2毫米之间，使用前要炒干。
These consist of a series of small ferrite cores of maximum diameter 2 mm.
这些由一系列最大直径为2毫米的小铁氧体磁心组成。
Inflorescences thyrses, either subpaniculate below and spicate-racemose above or with numerous, mostly 2-flowered branchlets, pedicels 1 – 2 (-16) mm.
花序为聚伞圆锥花序，既不及圆锥花序同时又超过穗状的总状花序，或者带有大量的大多生有2花的小枝，花梗1–2（16）毫米。
Start of volume production of the world's smallest drawn cup needle roller bearing (2 mm shaft diameter) for a motor application in electronics manufacturing.
开始批量生产世界上最小的制定杯滚针轴承(2毫米轴径)的电机中的应用电子产品制造。
The finer fraction (2 mm) of the samples was finely powdered in an agate mortar.
微细粒级的样品(2毫米)在玛瑙研钵中呈细粉末状。
The mill I use for this step is 2 mm in diameter.
轧机我使用的这一步是2毫米，直径。
Nuts ellipsoid to cylindrical, ca. 2 mm long, smooth, apex beaked.
坚果椭球形至长圆柱形， 长约2毫米，光滑，顶端具喙。
The seeds are about 2 mm in diameter, and may be colored from yellowish white to black.
芥菜籽直径约为2毫米，颜色从黄白色到黑色不等。
The notch, to be accurate, should not be wider than 2 mm.
精确地说，切口不能超过2毫米宽。
Gypsum used to simulate the fault material is of thickness 2 mm.
断层物质用2毫米厚的石膏模拟。
Surface mounted closers shall be full rack and pinion type, with pressure cast alloy shell, with no more than 53 mm (2 1/8") projection from the door surface."
表面安装式关门装置应是全齿条的和小齿轮型的，带压力铸造合金的外壳，从门表面突出不超过53毫米（2 1/8英寸）。
They differ in sizes, ranging from 2 mm to nearly 40 mm in length.
狼蛛的大小相差很大，体长从2毫米到40毫米都有。
They are singular, white, hard, round or oval shaped and about 1-2 mm in diameter.
他们是独特的，白，硬，圆形或椭圆形，约1 - 2毫米的直径。
We recommend working with a minimum wall thickness of 2 mm when the wall is connected to other walls on two or more sides, and 3 mm if it's only connected one side.
当模型的侧壁连接多个面的时候，我们建议使用的最小壁厚为2毫米，如果模型的侧壁没有与其它侧壁的连接，则用的最小壁厚应该为3毫米。
Thee mill (purple) I use for this step is 2 mm in diameter.
轧机（紫色）我使用的这一步是2毫米，直径。
The mesh size of pulverized metals is 0.01 - 2 mm, shapes - flaky, cube-shaped, needle-shaped, except for spherical.
粉碎金属的粒度为0.01-2毫米，形状——除了球状外，片状、立方形、针形。
Because the mill is only 2 mm in diameter I don't dare to go immediately to the right depth.
因为轧机是只有2毫米，直径我不敢去，立即到正确的深度。
Again the purple lines represent the 2 mm mill and axially the procedure is the same as described for picture 14.
再次紫色线代表2毫米轧机和轴向的程序是一样的描述图片14。
Point Blank 2 points, requires 20 points in MM "Reduces the minimum range of your ranged weapons by 1 yards" (to 2?
死区瞄准（2点）需要：20点射击系天赋使你用远程武器攻击时的最小攻击距离减少1/2码。
The average outside diameter of the end pieces is 10 mm, but can vary between 8 and 14 mm in intervals of 2 mm.
所述末端装置的平均外缘直径 为10毫米，但可以在相隔2毫米的间距在8毫米至14毫米之间变化。
Rear brakes: 2-piston calipers, 291 mm steel ventilated discs.
后轮制动器：2活塞卡钳，291毫米的钢制通风盘。
Rear brakes: 2-piston calipers, 291 mm steel ventilated discs.
后轮制动器：2活塞卡钳，291毫米的钢制通风盘。
应用推荐