The preparation method is as follows: the conductive macromolecular nano powder is mixed with the curing agent to obtain mixed curing agent;
制备方法为：先将导电高分子纳米粉末与固化剂混合得到混合固化剂；
Mixed efficient jianshuiji USES steam curing of concrete, concrete should have the necessary structure strength to warming, steaming raise system should be determined by test.
掺高效减水剂的混凝土采用蒸汽养护时，混凝土应具有必要的结构强度才能升温，蒸养制度应通过试验确定。
To compare the impact of coloring agents on resin curing, the experiment was carried out to study the curing layer depth of resin mixed with different kinds of coloring agents under laser scanning.
研究了混入不同着色剂的液态光敏树脂在激光扫描照射下树脂单层固化厚度的变化规律，比较了不同着色剂对树脂固化程度的影响。
The results showed that the nanotubes mixed rapidly into the rubber with little temperature increase during the mixing. The curing reversion of rubber composites was also reduced.
研究表明，与传统炭黑增强样品相比，碳纳米管在橡胶中的混入速度快，温升幅度小，混炼胶的硫化返原现象减轻。
Objective: To investigate the effective observation of curing the circular mixed hemorrhoid with piercing stripping outside and pricking inside plastic operation.
目的：研究分段外剥内扎整形术治疗环状混合痔的疗效观察。
In this article, a novel liquid crystalline epoxy resin was synthesized, and curing behavior and mixed with bisphenol-A epoxy resin were investigated.
本文合成了一种新型液晶环氧树脂，并对其固化及改性普通双酚- A环氧树脂进行了较系统的研究。
In mixed combining method process, the sulphur went along with material and fuel into the system, long term in abundance for serious influence of the curing kiln and evaporator's operation.
混联法生产过程中，随原料、燃料带入系统的硫，长期富集，给熟料窑、蒸发器等设备的操作造成了严重的影响。
The composite material powder is mixed with curing liquid, and then the composite material can be used by injection.
将复合材料粉末与固化液调和后即可注射使用。
The medicine is essentially used for curing internal and external hemorrhoids, lotus hemorrhoids, mixed hemorrhoids, rectocele, anal fistula, hematochezia and perianal swelling.
内痔、外痔、莲花痔、混合痔、脱肛、肛瘘、便血、肛周襄肿。
Lacquer, thinner, curing agent and other materials enter the mixer main body to be mixed through the four inlets and enter a spray gun from the outlet to be sprayed.
油漆、稀料和固化剂等原料通过这四个进口进入混合器主体混合，混合后通过出口进入喷枪进行喷漆。
Lacquer, thinner, curing agent and other materials enter the mixer main body to be mixed through the four inlets and enter a spray gun from the outlet to be sprayed.
油漆、稀料和固化剂等原料通过这四个进口进入混合器主体混合，混合后通过出口进入喷枪进行喷漆。
应用推荐