Thirdly, apply the mixed adhesive with a short brush, on dried joints surface.
用短毛刷将配合后的粘合剂分两次均匀涂刷在干燥的接头表面。
The service life of mixed adhesive each time shall be changed following temperature and mixed amount.
每次调胶量的使用期限随温度和混合量而发生变化。
Shaving board adhesive consists of mixed modified waste liquid and UF resins. Proper process can make the shaving board be of suitable strength and property density.
改性的麻杆黑液与自制脲醛树脂按一定比例调配作为刨花板粘合剂，选择适当的工艺条件，将麻芯与刨花的混合料压制成具有一定强度、适当密度值的板材。
This is the flooring carrier and consists of highly compressed wood fibers mixed with a synthetic resin adhesive.
这是地板的载体，由高度压缩的木质纤维与合成树脂粘合剂混合组成。
The selection principal of low toxic mixed solvent of CR adhesive is depended upon hydrogen bond index and solubility parameter of the solvent.
氯丁胶粘剂的低毒混合溶剂的选择原则是：根据溶剂的氢键指数及溶解度参数。
The structure of adhesive phase and transition layer in bright layers are mixed type of martensite.
白亮层中的粘结相以及过渡层的组织均为混合的马氏体组织。
A coatings containing polytetrafluoroethylene (PTFE) was prepared with polyphenylene sulfide (PPS) and polyimide (PI) as adhesive which were mixed with PTFE in a suitable solvent.
以聚笨硫醚(PPS)和聚酰亚胺(PI)为复合粘结剂与聚四氟乙烯(PTFE)混合于合适的溶剂中，制成含ptfe的涂料。
The adhesive, usually in granular form, is mixed with water and heated to form a paste which ultimately becomes a viscous fluid.
通常将呈颗粒状的粘着剂与水混合后加热成糊状，最终制成粘性流体。
Copper conductive adhesive is prepared by using modified resins and mixed resins as cohesive materials and Copper powders as conductive fillers.
以改性树脂和混合树脂为粘料，铜粉为导电性填料，并配以适当添加剂、固化剂制备铜导电胶。
Hot frit adhesive is mixed water radical adhesive is its representing.
热熔型胶粘剂和水基型胶粘剂正是其代表。
It is studied that the main influence factors on adhesive strength of CR adhesives, including mixed rubber, solvent, resin etc.
前言：研究了影响氯丁胶粘剂拉伸强度主要因素，探讨了混炼胶、溶剂、树脂等对氯丁胶粘剂拉伸粘接强度的影响。
It is studied that the main influence factors on adhesive strength of CR adhesives, including mixed rubber, solvent, resin etc.
研究了影响氯丁胶粘剂拉伸强度主要因素，探讨了混炼胶、溶剂、树脂等对氯丁胶粘剂拉伸粘接强度的影响。
Radar absorbing materials (RAM) are usually composites in which the absorber and matrix (adhesive) are mixed at appropriate proportion in practical application.
雷达吸收材料通常是由吸收剂与基体(黏合剂)混合形成的复合物。
Acacia extract is dissolved in water to prepare a solution with 40-50% concentration, which is uniformly mixed with said PUF resin and wheat flour to obtain a tannic adhesive.
它是将黑荆树栲胶溶于水中配成浓度为40 ~ 50%的溶液加入适量特制的低分子量活性PUF树脂和面粉，搅匀调制成单宁胶。
Acacia extract is dissolved in water to prepare a solution with 40-50% concentration, which is uniformly mixed with said PUF resin and wheat flour to obtain a tannic adhesive.
它是将黑荆树栲胶溶于水中配成浓度为40 ~ 50%的溶液加入适量特制的低分子量活性PUF树脂和面粉，搅匀调制成单宁胶。
应用推荐