• The paper analyzes the error in design of funneled bin, describes the correcting methods and derives the formula to determine the minimum discharge Angle of the bin.

    本文漏斗形料仓设计误取区阐述纠正方法推导出漏斗形料仓最小下料倾角确定公式

    youdao

  • On the basis of the studies above, the minimum power supply frequency favorable to uniform glow discharge was formulated.

    基础上,根据大气压下有利于均匀辉光放电放电条件,最终推算出有利于均匀辉光放电最小电源频率

    youdao

  • This control method has the advantages of producing minimum level oscillation, and of maximum response speed of the channel water mass to discharge change.

    控制法产生水位波动最小使水体流量变化最快反应速度

    youdao

  • Calculation shows that method of minimum residual error is better method to establishment of the discharge drawdown equations, and minicomputer can use simply in calculating process.

    计算表明最小建立稳定法涌水量经验方程一种较好方法计算过程微机上易于实现。

    youdao

  • Take effective measures to reduce the discharge to the minimum.

    采取有效措施排放降至最低水平。

    youdao

  • Since the nineteen eighties, China introduced emission trading to realize environment protection target and reduce pollution discharge with minimum social and economical cost.

    中国于二十世纪八十年代引入排污交易,其目的是希望能最低社会经济成本实现既定环境目标污染物减排目标。

    youdao

  • And then a method of partial discharge monitoring based on pulse current and a technique of fault diagnosis based on the minimum distance method to stator winding are presented.

    接下来提出采用脉冲电流完成定子放电故障信号采集,应用基于最小距离定子局部放电样本进行故障识别。

    youdao

  • Install 5 pipe diameters minimum downstream from pump discharge or elbows to avoid flow turbulence. Flow straighteners may be required in extreme cases.

    安装位置距出口下游最少应该有5管道直径的长度的位置。极端情况下可能需要安装流向矫直装置

    youdao

  • Pump discharge of oil with reasonable design, gear oil and back at work under minimum torque force bearing load, so small, wear small, pump with high efficiency.

    内有设计合理油槽,是齿轮工作中承受扭矩最小因此轴承负荷磨损小,泵效率

    youdao

  • Pump discharge of oil with reasonable design, gear oil and back at work under minimum torque force bearing load, so small, wear small, pump with high efficiency.

    内有设计合理油槽,是齿轮工作中承受扭矩最小因此轴承负荷磨损小,泵效率

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定