Measurements made using the micro-ohmmeter are always performed using the four-wire technique in order to minimize errors caused by test leads and connections.
使用微欧计进行电阻测量必须采取四线技术以使测试电缆和连接器带来的误差减至最小。
For most applications, the micro-ohmmeter or DMM is sufficient for contact resistance measurements.
对于大多数的应用来说，微欧姆计或数字多用表足以用来进行接触电阻的测量工作。
The pulsed drive mode, shown in Figure 1-24, allows the micro - ohmmeter to cancel stray offset voltages in the unknown resistance being measured.
图1 - 24所示的脉冲驱动模式使微欧姆计能够消除被测未知电阻上的寄生偏置电压。
This small resistance is normally measured with a DMM or a micro - ohmmeter.
这个小的电阻值通常用数字多用表或者微欧姆计来测量。
This small resistance is normally measured with a DMM or a micro - ohmmeter.
这个小的电阻值通常用数字多用表或者微欧姆计来测量。
应用推荐