The foamed pure Al was prepared by way of melt foaming process.
用熔体发泡法制备纯铝基泡沫铝。
SiC particle-reinforced aluminum foams were produced by melt foaming process, and their deforming activity under quasi-statistic pressing was analysised.
用熔体发泡法制备了碳化硅颗粒增强泡沫铝样品，分析了碳化硅增强泡沫铝在准静态压缩条件下的变形行为。
The foaming process of NFA was studied. The results show that the melt foaming process is actually a homeostasis process of bubble nucleation, growth, rheology and collapse.
对以NFA作发泡剂的熔体发泡过程分析表明，发泡过程实际上是熔体中气泡的形核、生长、流变和破裂的动态平衡过程。
There are three main interior structure defects in the preparation of aluminum foam with melt foaming process such as free-bubble-layer at the bottom, partial free-bubble-zone and heat crack.
泡沫铝常见的内部缺陷主要有底部无泡层、局部无泡区和内部热裂纹。
Then a small quantity of Talc was added to PP/HDPE blend in this study. Effects of the Talc content on the melt strength and microcellular foaming process of the blended system were investigated.
然后在PP/HDPE共混体系中加入少量滑石粉，研究滑石粉的含量对共混体系熔体强度及微孔发泡过程的影响。
Also FLUENT, which is the large scale CFD software, has been applied to imitate the foaming process of aluminum melt.
利用大型计算流体软件——FLUENT对熔体直通气体发泡法过程进行模拟。
The rolling process of closed-cell aluminum foam that was prepared by melt-foaming process was studied, as well as its deformation and failure behavior due to different pass reduction.
研究了采用熔体发泡法制备的闭孔泡沫铝材料的轧制过程，分析了不同道次压下量条件下泡沫铝的变形特点与破坏方式，探讨了影响泡沫铝轧制能力的主要因素。
The rolling process of closed-cell aluminum foam that was prepared by melt-foaming process was studied, as well as its deformation and failure behavior due to different pass reduction.
研究了采用熔体发泡法制备的闭孔泡沫铝材料的轧制过程，分析了不同道次压下量条件下泡沫铝的变形特点与破坏方式，探讨了影响泡沫铝轧制能力的主要因素。
应用推荐