The hot media flows through the dryer's thermal jacket to transfer heat to the drying chamber.
炎热的媒体夹克流经烘干机的热传递热量的干燥室。
Besides the minority of strong oxidizer outside, it can be used to seal hot water, overheating steam, heat transfer fluid, ammonia solution, hydrocarbons, low temperature liquids, and other media.
除少数的强氧化剂外，它能用于密封热水、过热蒸气、热传递流体、氨溶液、碳氢化合物、低温液体等介质。
A numerical approach based on finite volume method is proposed to study the procedure of coupled heat and moisture transfer in multilayered porous media under nonlinear boundary conditions.
提出了一种基于有限体积法预测非线性边界条件下多层多孔介质内的传热传湿过程的数值分析方法。
FT Series towers are of a counter flow design, carefully engineered with the optimum combination of heat transfer media, uniform air flow and even water distribution.
该产品属于逆流设计，采用最好的热传递介质，提供统一的空气流量和水质分配。
A mathematic model based on heat and mass transfer in porous media was established for the simulation of paper drying in dryer section of paper machine.
根据多孔介质干燥过程中的传热传质理论，结合纸机工作特点，建立了纸页的干燥过程物理模型和数学模型。
An approach to the thermal radiation of absorbing-emitting media, or weak absorbing media, e. g. burned gas, in the finite element analysis (FEA) of heat transfer is studied in this paper.
研究了有限元传热分析中有吸收—发射性介质(或称弱吸收性介质，例如燃气)参与辐射传热时的处理方法。
The research status on porous media flow and heat transfer was summarized. And a new research direction in heat transfer research of porous media flow was presented.
综述了在多孔介质流动与传热研究领域的现状，提出了多孔介质流动换热研究新方向。
Cold media is in the air conditioning refrigeration system heat transfer medium.
冷媒是空调制冷系统中传递热量的媒介。
One dimensional heat and mass transfer models were established from one piece of waste from each media respectively.
取其中的一片物料作为研究对象，分别建立了一维状态的热量质量传递数学模型。
Two algebraically explicit analytical solutions of the governing equation set for the coupled heat and mass transfer process of rapid drying in porous media are derived.
对多孔介质快速干燥过程的传热与传质耦合方程组导出了两套代数显式解析特解。
Many approximation methods have been proposed to solve radiative heat transfer problem in semitransparent media.
使用该方法分别求解了一维和二维半透明介质内的辐射换热问题。
The parameters involved in the heat mass transfer models in porous media were estimated.
对多孔物料的热量质量传递模型中涉及的参数进行了测算。
The results obtained provide a theoretical basis for the development and application of strengthening the heat transfer of granular media flowing in the corrugated plate heat exchanger.
这些研究结果为粉粒体波面板换热器强化传热的研究与开发提供了理论基础。
The other area concerns twofers flow and heat transfer in porous media as widely encountered in energy conversion and electronics cooling.
其二则为能量转换和电子冷却领域中常见的多孔介质两相流动问题。
In the process of heat and mass transfer in unsaturated porous media, the measurement and treatment for the "true" thermal conductivity is disputable due to the moisture migration.
在非饱和含湿多孔介质传热传质的过程中，由于湿分迁移的存在，使得真实导热系数的测量和处理存在争议。
The adsorption bed structure filling sorbent in tube and flowing heat transfer media out of tube was designed and the corresponding mathematical model was established.
设计了管内填充吸附剂，管外走传热介质的新型吸附床结构，建立了相应的数学模型。
The effects of heating ways, geometric surfaces and working media on hysteresis are studied in boiling heat transfer, and the ways of lessening hysteresis are proposed.
本文研究了沸腾传热过程中不同加热方式，不同几何结构表面和工作介质对沸腾滞后的影响，并提出了减少滞后对沸腾传热影响的措施。
Recently, energy conservation has become an area of active interest. This has led to an expansion in the fields of application of heat transfer media with a higher load capacity.
近来，能源的保护越来越备受关注，这导致了该领域大量需求该类导热油。
A wind tunnel experiment was performed to obtain equations for heat and mass transfer coefficients for the evaporative process through various thickness of rigid cellulose pad media.
针对各种厚度之刚性纤维水墙介质进行风洞实验以求得蒸发过程中热与质传系数。
The reaction kettle is electrically heated, takes heat transfer oil and water as heat transfer media and is a carrier reaction kettle suitable for a high-viscosity medium.
本发明采用电加热方式，以导热油、水为传热介质，适宜于高粘度介质的载体反应釜。
The reaction kettle is electrically heated, takes heat transfer oil and water as heat transfer media and is a carrier reaction kettle suitable for a high-viscosity medium.
本发明采用电加热方式，以导热油、水为传热介质，适宜于高粘度介质的载体反应釜。
应用推荐