A voltammeter is a device for measuring voltage or amperage.
伏安计是用于测量电压和安培数的仪器。
Applications for Measuring Voltage from High Resistance Sources: Capacitor dielectric absorption and electrochemical measurements.
各种高阻源电压测量的应用：电容器的介电吸收和电化学测量等。
CVT is a signal sampling device which is widely used to carry out an energy metering, measuring voltage and relay protection in high-voltage power network at home and abroad.
电容式电压互感器是广泛应用在国内外高压电网中的一种用以进行电能计量、电压丈量和继电保护的信号取样装置。
Simply spin it slowly by hand, and start measuring voltage, starting with one coil, and being certain that the voltage increases with each additional coil which is wired in series.
只需旋转，慢慢的手，并开始测量电压，从一个线圈，被确定的电压增加，每增加线圈是有线系列。
The experimental results show that the probe has good frequency response characteristics which meet the requirement of measuring voltage distribution of thyristor in converter valve.
实验结果表明，这种探头有较好的频率响应特性，能满足换流阀晶闸管电位分布测量的需要。
Switching and measuring voltage sources with high internal impedance are subject to a number of errors, including offset currents, stray leakage paths, and electrostatic interference.
切换和测量具有高内阻的电压源会受各种误差的影响，包括偏移电流、寄生漏泄通路，以及静电干扰。
A voltage measuring transformer decreases voltage from 330 kV to 100 kV for protective circuit.
电压测量变压器将电压从300千伏降低到100千伏以保护电路。
This section details how to make surface and volume resistivity measurements with these test fixtures, as well as the Alternating Polarity and Alternating Voltage techniques for measuring resistivity.
本节详细介绍如何使用这些测试夹具来进行表面电阻率和体电阻率的测量，以及测量电阻率时使用的变换极性和变换电压的技术。
A good safety practice is to expect that hazardous voltage is present in any unknown circuit before measuring.
一个良好的安全实践是在测量之前假设所有位置电路上都存在危险电压。
The advantages of this method are that it's fast and, depending on the power supply voltage and insulating materials, it allows measuring extremely high resistance.
这种方法的好处是速度非常快，根据电源电压和所用绝缘材料的情况，使用这种方法可以测量阻值极高的电阻。
The leakage current can be determined by applying a known voltage and measuring the current between either path to ground or path to path.
通过施加一个已知的电压，然后测量通路至地或通路至通路的电流，即可确定漏泄电流。
This may require using a high current switch card for sourcing and a low voltage switch card for measuring.
这就可能需要利用一个大电流开关卡来提供电流，一个小电压开关卡用于测量。
This effect can be measured in either the time domain by observing the rate of decay of voltage or in the frequency domain by measuring phase shifts between sinusoidal currents and voltages.
这个效应可以在时间域通过观测电压的衰变率来测量，也可以在频率域通过正弦电流和电压之间的相变来测量。
The leakage current will decay exponentially with time, so it's usually necessary to apply the voltage for a known period (the "soak" time) before measuring the current.
泄漏电流随时间呈指数衰减，所以通常需要在一个已知的时间期间内施加电压(浸润时间)，然后再测量电流。
Adding current and voltage sourcing capabilities to a measuring instrument provides an extra degree of versatility for many low level measurement applications.
在测量仪器上附加电流和电压源功能，为各种低电平测量应用提供了额外的灵活性。
Measure the reverse breakdown voltage by sourcing a specified re verse current bias, then measuring the voltage drop across the diode.
通过施加规定的反向偏流，然后测量二极管两端的电压，即可测得反向偏置电流。
Some electrometers and picoammeters, however, have a built-in voltage source and are capable of measuring the resistance directly.
然而，有的静电计和皮安计内部装有电压源，能够直接测量电阻。
High impedance voltage switching may be necessary in applications such as monitoring electrochemical cells and measuring semiconductor resistivity.
在有些应用中，例如监测电化电池和测量半导体的电阻系数，则可能必须进行高阻抗电压切换。
Measuring the voltage coefficient of a high resistance requires sourcing a voltage and measuring a low current.
测量高电阻的电压系数需要输出电压并测量小电流。
Here, an electrometer ohmmeter is forcing a current (IR) through the unknown resistance (RS) and then measuring the voltage (VM) across the DUT.
静电计欧姆计的电流激励(IR)流过未知电阻(RS)，然后测量dut上的电压(VM)。
"Our sensor is measuring both voltage, current and power and we're going to use the solar panel and connect it to it to measure how much solar energy our solar panel absorbs," Rebecca said.
瑞贝卡说：“我们的传感器可测量电压、电流以及电量，我们将利用太阳能电池板，并衡量太阳能电池板吸收了多少太阳能。”
For measuring the electric performance parameters of light sources, measuring the voltage, current, power and power factor.
用于测量光源的电性能参数，测量电压、电流、功率、功率因数。
In an electric power system, the following parameters often need measuring: voltage, current, power factor, power, reactive power and apparent power.
电力系统中常需测量电压、电流、功率因数、有功功率、无功功率和视在功率等参数。
Because the voltage measuring error increases when phase to phase short circuit occurs, distance relay protection will act improperly.
但是短线路在两相短路时，由于测量电压的误差会放大，可能引起距离保护的超越。
By measuring current voltage characteristics and observing light emission of these diodes, electron emission feature of these diamond powder cold cathodes were investigated.
通过该结构电流电压特性的测量和发光特性的观察研究了金刚石粉末冷阴极的电子场发射性能。
These theoretical results are consistent with the experimental results. They may provide a theoretical basis for designing and measuring the voltage effect of PTC ceramics.
这些结果与已有实验结果相符，它们为PT C陶瓷电压效应的设计与测量提供了理论基础。
When measuring the leakage current with this setup, the voltage bias is applied to all the diodes simultaneously through the normally closed contact of each relay.
当利用这一配置测量漏流时，通过每个继电器的常闭触点同时向所有的二极管施加偏压。
Step five: tune the final stage power transistor quiescent current, the current value of the power tube by measuring the voltage of the emitter resistance Converter and get.
第五步：调末级功率管的静态电流，该电流值可以经由过程测功率管的发射极电阻的电压换算而得到。
The simulated electrode method is analyst and a method for ~measuring impulse voltage distribution of transformer windings without core is built.
分析了模拟电极法，提出了一种测量变压器线圈冲击分布的方法即不插铁测量。
The simulated electrode method is analyst and a method for ~measuring impulse voltage distribution of transformer windings without core is built.
分析了模拟电极法，提出了一种测量变压器线圈冲击分布的方法即不插铁测量。
应用推荐