Mean time to failure is the average continuously operational period — i.e. the average period between the end of one failure and the beginning of the next.
平均失效到达时间是连续运行期间的平均值——也就是说，在结束一个失效和开始另外一个之间的平均周期。
This provides an availability figure based on mean time to failure information in days, and mean time to recover information in hours.
它提供了一个基于数天内的平均失效时间信息和数小时内的失效恢复信息的可用性特性。
The goal of any good systems administrator is to avoid being a victim of the mean time between failure value of hardware and find a way to mitigate the risk of a disk failure.
所有好的系统管理员的目标是避免成为硬件平均故障间隔时间的受害者，并找到一种方式来减轻磁盘故障的风险。
You should also note that success criteria can change with time, and just because certain objectives were not achieved, this does not necessarily mean that the project was a failure.
你可能同时也会注意到成功的标准随时间而改变，并且仅仅是因为某些目标没有实现，但是这并不意味着项目的失败。
Failure doesn't mean that you sit down and never throw in another attempt because throwing in the towel only means that you quit for this time not for all time.
失败并不是说你就只能坐在板凳上，在也不去企图尝试了。因为扔条毛巾(认输)仅仅是说你放弃了这一次，而不是永远放弃。
If you have mean time to failure and mean time to recovery information, enter that and the spreadsheet will calculate the availability for you in the "Calculated availability contributions" lines.
如果有平均失效到达时间和平均恢复时间信息，输入到表格中将计算出“计算出的可用性贡献”行。
This will slightly increase the time it takes to track, but can often mean that trackers exist for longer before their matching score drops below the failure threshold.
这将会稍微增加时间跟踪，但往往意味着追踪点带你存在更长时间，在他们匹配得分低于阈值的失败。
Using the property of Markov at the points of replacement period, a model of determining the optimal period is developed with objective of maximizing the mean time to first failure of system.
利用在更换周期点上具有的马尔可夫性质，以系统首次故障前平均工作时间最大为目标建立了确定最佳更换周期的模型。
Multi-factors defined in CC are replaced by MTSF(mean time to security failure) as the metric of vulnerability complexity.
把CC评估标准定义的多个变量映射为以平均安全时间为参数的度量指标。
The proportional allocation factor and the allocation formulae expressed in terms of failure rates and mean time between failures respectively are given.
给出了分别以失效率、平均故障间隔时间表达的分配比例因子及分配公式。
The reliability lab ship fuel oil donkey boiler controlled by relay control system is evaluated using counting method, and mean time to failure (MTTF) of the control circuit is educed.
对采用继电器控制系统进行控制的某实验室船舶燃油辅助锅炉，采用计数法进行可靠性评估，得出控制电路的平均无故障时间。
Failure doesn't mean you have wasted time and life, but suggests that you have a reason to start afresh.
失败并不意味着你浪费了时间和生命，而是表明你有理由重新开始。
By regulating the cathode temperature and applying the combined exhaust techniques, the mean time of no-failure operation of this picture tube is lengthened more than four times.
通过调整阴极温度和采用“联合排气工艺”，黑白显象管的平均寿命提高了四倍以上。因此，早期失效的问题基本得到解决。
In order to recommend proper stocking levels, ShanghaiSuperCTRL Automation co., Ltd. USES a theoretical calculation based on Mean Time Between Failure (MTBF).
为了建议适当的库存量，业控自动化使用一个基于故障平均时间间隔的理论计算。
Failure doesn't mean—You have wasted your time;
失败并不意味着你功夫白费；
Failure doesn't mean—You have wasted your time;
失败并不意味着你功夫白费；
应用推荐