• This is already a good value because it guarantees that the optimizer, by using the quantile statistics, only has an estimated maximum error of 5% for the determined filter factors.

    这已经是一个较好的值,因为它可以保证优化器在使用分位数统计信息的情况下对确定过滤因子的估计误差最大只有5%。

    youdao

  • The horizontal cross section of the pyramid is square at any level, with each side measuring 229 m (751 ft) in length. The maximum error between side lengths is astonishingly less than 0.1%.

    金字塔的水平剖面在任何高度都是正方形,每面的长度也都是229米(751英尺),惊人地是,其最大的误差小于0.1%。

    youdao

  • Practical results show that the proposed method lowers both average error and maximum error and improves forecasting precision.

    对预测结果的分析表明,多点外推法不仅减少了平均误差,也使最大误差降低,能有效提高预测精度。

    youdao

  • Results show that data from the new sensor matches that from oven drying method, and the maximum error is less than 2%, which can meet the need of agrometeorological monitor.

    结果显示传感器测量数据与烘干法测量数据相吻合,最大误差不超过2%,满足农业气象探测的要求。

    youdao

  • The maximum error is less than 2% in dynamic real object tests.

    动态实物试验最大测量误差值小于2%。

    youdao

  • Comparing with experimental results, the maximum error is lower than 8%.

    与一系列实测结果比较,最大相对误差不超过8%。

    youdao

  • The accuracy of calculation result was analyzed, and the maximum error was given.

    对计算结果的精度进行了分析,给出了计算结果的最大误差。

    youdao

  • The maximum error between the calculated and the experimental results is within1.2K.

    母排和外壳温升的计算结果与实验结果吻合得很好,误差在1.2K之内。

    youdao

  • The maximum error of resistance measurement is within 0.3%, if proper measuring elements were chosen.

    当合理选用测量元件时,电阻测量的最大误差可在0.3%以下。

    youdao

  • The maximum error is about 5% The method can be used to analyze components with an arbitrary number of spiral turns.

    平面圆形螺旋电感器的计算值与实验值比较,最大误差约为5%。

    youdao

  • The model was trained with training sample aggregation. The maximum error between the forecasted and real value was 0.97%.

    用训练样本集对网络训练后,检验样本的预测结果与实际值最大误差为0.97%。

    youdao

  • According to the allowance of production, the maximum error of measurement is used to determine the accuracy of the instrument.

    根据生产所允许的最大测量误差来确定仪表的精确度。

    youdao

  • The sensitivities of error parameters were analyzed at the maximum error position, and accuracy synthesis was conducted by using Monte Carlo method.

    并对系统最大误差位置进行误差参数灵敏度分析。用蒙特卡洛法进行精度综合。

    youdao

  • If the ship appendage resistance is 10% of the naked hull ship resistance, the maximum error is then less than 1% of the naked hull ship resistance.

    假定船的附体阻力为裸船体阻力的10%,则最大误差小于裸船体阻力的1%。

    youdao

  • The maximum error between the integral results of the gated integrator and of oscilloscope is less than 5% of the scale range of the gated integrator.

    门控积分器与示波器测量对比,最大误差小于门控积分器满量程的5%。

    youdao

  • A new choice approach for embeddable position of audio watermarking scheme in the DCT domain based on research of IDCT maximum error modal is proposed.

    本文在DCT最大误差模型研究的基础上提出了一种新的音频水印嵌入位置选择策略。

    youdao

  • By using the method of maximum error, the paper deals with the analysis of the static error of the six-component force test stand of solid rocket motors.

    本文用最大误差方法,对固体火箭发动机六分力立式试验台的静态误差进行了分析。

    youdao

  • Experimental results indicated that maximum error of slotted orifice is less than 5%. The conclusion is available to the development of slotted orifice meter.

    实验结果表明槽式孔板测量误差小于5%,研究结果对槽式孔板流量计的开发具有一定借鉴意义。

    youdao

  • Compared with several normally used mathematical solution models, the new model has a maximum error of 7% in calculating DBRF, which has a higher solution precision.

    相较于几种常用的计算模型,新模型计算dbrf的误差不超过7%,具有更高的求解精度。

    youdao

  • The results show that the solid element model are accurate but modeling complex, the virtual beam element model has the maximum error about -2.3% compared with the solid model.

    计算结果表明:实体模型计算结果准确但建模复杂,与之相比,虚拟横梁单元模型的最大误差为-2.3%。

    youdao

  • The results indicated that the maximum error of the resonant frequencies be - tween the practical values and the theoretical ones was within 5%, meeting the design requirements.

    测试结果表明,该单片三轴硅微机械振动陀螺仪驱动模态的实际谐振频率与理论值之间的最大误差小于5%,满足设计要求。

    youdao

  • The result indicates that the error of the test for refractive index of polymer is less than 5%, while for volume percent of liquid crystal, the maximum error reaches about 10%.

    结果表明,对聚合物分散液晶聚合物折射率的误差在5%以内,而对液晶体积分数的测试误差较大,达到10%左右。

    youdao

  • It shows that the maximum error percentage is 14.77%, the two results are very coincident by analysis. The error of result can basically satisfy the needs of the generic projects.

    通过对比分析表明,两种分析方法的计算结果很接近,最大误差为14.77%,基本能满足一般的工程需要。

    youdao

  • The principle of the analog-digital composite compensation technique is described and the factors causing fitting errors arc analyzed. The formula for calculating the maximum error is derived.

    还叙述了模-数混合补偿技术的工作原理,分析了引起拟合误差的因素并推导出计算最大误差的公式。

    youdao

  • When the pump runs off the peak efficiency, the error of conversion method decreases in the large flow-rate region, while increases in the small flow-rate region, with a maximum error of 3.043%.

    水泵装置在非最优工况下变速运行时,大流量侧装置性能参数按相似律换算误差变小,在小流量侧换算误差增大,最大相对误差达3.043%。

    youdao

  • Article 3 When selling commodities, a retailer must use eligible instruments of measurement, and the allowed maximum error shall precede or be equal to the minus deviation of the commodities sold.

    第三条零售商品经销者销售商品时,必须使用合格的计量器具,其最大允许误差应当优于或等于所销售商品的负偏差。

    youdao

  • The results showed that the maximum error was less than 0.6%, indicating that the direct formulas of the quasi-linear function were much simpler, precise and wider than previous ones in applications.

    结果表明,准直线函数计算公式在工程常用范围内,计算临界水深的最大相对误差小于0.6%,准直线函数计算公式形式更为简单、精度较高、适用范围广。

    youdao

  • Maximum error is less than 2% and the engineering utilization requirements have been met.

    最大误差不超过2 %,可满足工程使用要求。

    youdao

  • Maximum error is less than 2% and the engineering utilization requirements have been met.

    最大误差不超过2 %,可满足工程使用要求。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定