There was an error in writing the maximum connection speed.
在写最大连接速度时有一个错误。
Cannot read the maximum connection BPS rate from the media. INI file.
无法从媒体INI文件中读取最大连接BP S速率。
Use the minimum and maximum connection fields to configure the pool size.
使用minimumandmaximum connection字段来配置池大小。
Increasing the maximum connection pool size might help to alleviate the problem.
增大最大连接池大小可以帮助缓解此问题。
Never have a maximum connection pool size that is greater than the servlet engine thread count.
绝不要使最大的连接池大小大于servlet引擎线程的数量。
Maximum connection wait time - Shows the maximum time that an application was blocked waiting for a connection from the pool.
连接池最长等待时间：显示应用程序阻塞，等待连接池连接的最长时间。
This connection factory has the Maximum connections property set to 2, which means that only two connections can be created from this factory at any one time.
此连接工厂将最大连接属性设置为2，这意味着一次只能从此工厂创建两个连接。
WebSphere Application Server has a limit on the number of connections that can be created from a factory, specified by the connection factory's Maximum connections property.
WebSphereApplicationServer对连接工厂可以创建的连接数有一个限制，该限制由连接工厂的最大连接属性指定。
Construct maximum connection match tree identification algorithm with respect to the characters of observed star map and guide stars -star diagonal distance and connection.
根据观测星图和导航星所具有的特性- - -星对角距和连通性，构造了最大连通匹配树识别算法。
The session pool should be large enough to cover the Maximum Sessions value for any listener ports using the connection.
会话池应该大到能包含使用连接的任何侦听器端口的最大会话。
This suggests a value for the Maximum Sessions setting and, in turn, the size of the session pool associated with the listener port's connection.
这间接表明了最大会话设置值以及与侦听器端口的连接关联的会话池的大小。
This article explained the behavior of the maximum sessions property and its relationship to the message listener service thread pool, connection pool, and session pool.
本文解释了最大会话属性的行为及其与消息侦听器服务线程池、连接池和会话池的关系。
This parameter controls the maximum number of prepared statements cached by a connection pool.
该参数控制由连接池缓存的最大预编译语句数。
The maximum time the method will wait for a connection in this situation is specified by the connection pool's connection timeout property.
对于这种情况，该方法等待连接的最大等待时间是由连接池的连接超时属性指定的。
If your application has high concurrency and your maximum pool size is too small, your connection pool will often experience waiting.
如果应用程序有高并发，而最大池大小又太小，连接池就会经常等待。
Figure 1 shows the relationship between the connection pool, session pool, thread pool and the maximum sessions property.
图1显示了连接池、会话池、线程池和最大会话属性之间的关系。
Max idle time: the maximum time a connection may sit idle in the pool before being physically closed.
最大空闲时间：连接池中的连接被物理关闭前能保持空闲的最大时间。
Max pool size: the maximum number of connection that can be allocated from the pool.
最大池大小：连接池中可以分配的最大连接数。
Max wait time: the maximum time the pool will wait for a connection to be returned.
最大等待时间：连接池等待连接返回的最大时间。
DBI lets you set a maximum number of bytes to retrieve on each fetch using the LongReadLen connection attribute.
DBI让我们可以使用LongReadLen连接属性来设置每次fetch可以检索的最大字节数。
This parameter controls maximum and minimum number of JDBC connections in a connection pool.
该参数控制连接池中最大jdbc连接数和最小JCBC连接数。
This value should always be at least the same value specified as the maximum size of the JDBC Connection pool.
该值至少应与所指定的最大JDBCConnection pool大小相同。
To add a TCP Traffic Regulation Policy that covers only TCP port 23, and to set a maximum incoming connection pool of 256 with an available connections divisor of 3, enter the following command.
下面的命令添加一个TCPTrafficRegulation策略，它只控制TCP端口23，最大连接数量设置为256，可用连接除数设置为3。
By default, the WebSphere Application Server connection pool will have a minimum of one connection and a maximum of ten connections.
在缺省情况下，WebSphereApplicationServer连接池最少为一个连接，最多为十个连接。
Average, minimum, maximum, and standard deviation response time or connection time.
平均、最小、最大，以及标准偏差应答时间或者链接时间。
Recommendation: Adjust the maximum and minimum sizes of the connection pool.
推荐：请调整连接池的最大值和最小值。
In the maximum idle time field, enter the maximum time that a session can be idle before the Connection Manager clears the session's authentication token, forcing the client to re-authorize.
在Maximumidletime字段中，输入会话可空闲的最长时间，超过这个时间后，ConnectionManager将清理会话的认证令牌，迫使客户端重新授权。
In the maximum idle time field, enter the maximum time that a session can be idle before the Connection Manager clears the session's authentication token, forcing the client to re-authorize.
在Maximumidletime字段中，输入会话可空闲的最长时间，超过这个时间后，ConnectionManager将清理会话的认证令牌，迫使客户端重新授权。
应用推荐