The creep rate of the composites is 2 ~ 3 orders lower than that of Mg matrix alloy.
硼酸镁晶须增强镁基复合材料比基体镁合金的蠕变速率低2 ~3个数量级。
It was found that the waste glass particles are distributed uniformly in matrix alloy.
结果表明，玻璃颗粒较均匀地分布于基体中，与基体发生界面反应；
The interface between reinforcement and matrix alloy is very clean, there is no interfacial reaction.
增强体与基体合金界面非常洁净，没有任何界面反应。
In addition, because of introduction of particle reinforcements, adhesion resistance of composites is obviously improved and better than that of matrix alloy.
增强相的加入显著提高了材料的耐磨性，使得复合材料的抗粘着能力明显优于基体合金。
The experiment shows that the bonding intensity between diamond and metal coat has been improved and the holding retention of the coated diamond in matrix alloy has also b…
试验表明，金刚石与金属膜层的结合强度有了提高，镀膜金刚石在胎体合金中的包镶牢固程度随之得到提高。
This paper reveals the effects of particle on superplasticity ofparticle reinforced composites. The addition of particle into matrix alloychanged the superplastic behavior of the alloy.
本文介绍了颗粒增强复合材料超塑性中颗粒的作用：与基体材料相比超塑行为被改变；
Experimental results showed that, due to the addition of modification or refinement elements, the changes in the structure of the composite were identical with that of unreinforced matrix alloy.
试验表明，变质和细化元素的添加对该金属基复合材料组织的影响与相应的基体合金一致。
Microstructure, plasticity and mechanical properties at room temperature of the nano particle reinforcement aluminum matrix composites fabricated by in situ reaction and matrix alloy were studied.
用原位合成法制备了纳米颗粒增强铝基复合材料，研究了复合材料微观组织、室温拉伸强度、塑性，并与基体合金进行比较。
The temperature of solid solution treatment affected not only the degree of the second phase dissolved in the matrix alloy, but also the recovery and recrystallization processing level of the alloy.
固溶处理温度的高低不仅影响第二相在基体中的溶解程度，还影响合金的回复再结晶过程进行的程度。
The results show that the fine, spherical and dispersed inclusion contained Si is in favored of refining matrix crystals and optimizing internal microstructure of the alloy.
结果表明，细小、球形而又弥散分布的含硅夹杂相有利于细化基体晶粒，改善材料的内部微观组织结构。
The visible spectrum characteristics of the copper matrix and component in Cu-based alloy were(studied) with computerized digital simulation processing technique.
对铜合金可见光谱线进行了计算机数字模拟处理，研究了基体元素铜和各成分元素的可见光谱特征。
The method was developed for the matrix determination and the component analysis by the character line in Ni-based alloy based on digital simulation.
在镍基合金可见光谱计算机模拟基础上，研究利用镍元素及成分元素特征谱线进行基体鉴别和成分元素分析的方法。
By purifying the alloy melt, refining matrix grain and carbide, it is possible to increase the impact toughness of the Cr-alloyed white cast iron.
通过净化合金液，细化基体晶粒，细化碳化物可使铬合金白口铸铁的冲击韧性提高。
By electron diffraction analysis, it is identified that the alloy phase has a face center orthogonal structure and there are some orientation relationship between the Mg matrix and the alloy phase.
通过电子衍射分析确定出该合金相具有面心正交结构，与镁基体间存在着一定的取向关系。
The results show that the wettability of the mixed ceramic powders on TC4 alloy matrix is better than that of the A-W powders on it at the same temperature.
结果表明：在相同温度下，混合陶瓷粉对TC4合金基体的浸润性优越于A-W生物活性陶瓷粉；
The hardness of the alloy and the electrical potential in matrix increase with the content of chromium.
研究结果表明：随着含铬量的增加，硬度提高，基体电极电位增加；
The rupture mode of the composite at room and elevated temperature depends upon the work-hardening characteristics of the nickel alloy matrix.
复合材料常温和高温的拉伸断裂模式与基体相的形变强化特性有关。
The composite's interface can prevent cracks from propagating and the alloy elements in the matrix are favourable to formation of good interface to improve the composite's wear resistance.
复合材料的界面可阻滞裂纹扩展，基体中的合金元素有利于形成良好的界面，改善复合材料的耐磨性。
Excellent wear resistance of the coating is mainly due to the alloy carbide with obvious wear resistance. The alloy carbide is distributed on the matrix of solid solution.
涂层具有较高耐磨性的原因主要是固溶体的基体上分布有块状合金碳化物，具有较好的耐磨性。
The selection of analysis line and the determination of alloy element content were studied. The method has been developed for the examination of the matrix and alloy element in cobalt-based alloy.
对看谱分析用谱线的选择和成分元素的分析进行了讨论，探索了钴基合金基体及牌号鉴别方法。
This invention discloses an alloy with Mg element as the matrix and the use as a fixer for fractures.
本发明公开了一种镁元素为基质的合金及作为骨折内固定器的应用。
The ultrasonic dilution mechanism was analyzed through studying the fabrication process of the Zn-Al alloy matrix composites by high-intensity ultrasonic dilution of XD composites.
对高能超声稀释原位反应烧结块制备锌铝合金基复合材料过程进行了研究，简要分析了超声稀释机理。
Holding primary hardness, magnetism and plating properties of matrix, protection performance of steel was improved by combining the Zn - Fe alloy electroplating and phosphating technology.
为了保持基体金属硬度、磁性以及电镀层性能等均不变，将锌铁合金电镀工艺与磷化工艺进行了组合，以提高钢铁件的防护性能。
In the neighbourhood of the unhealed porosities the alloy matrix appeared to be embrittled and in certain cases cleavage fracture was observed.
未锻合疏松周围的合金基体有一定变脆倾向，有时可以观察到解理断口。
When the homogenization temperature increases further, more equilibrium phases are dissolved and the matrix, and the conductivity of the alloy decreases.
均匀化温度愈高，平衡相溶解愈充分，合金的电导率下降愈多。
When the homogenization temperature increases further, more equilibrium phases are dissolved and the matrix, and the conductivity of the alloy decreases.
均匀化温度愈高，平衡相溶解愈充分，合金的电导率下降愈多。
应用推荐