It is an inevitable result due to material yield, weakening or plastic variation.
它是材料屈服、弱化或塑性变化的必然结果。
The results show that the increasing of material yield strength has a great influence on the flange cracking.
结果表明,材料屈服强度的增加对翻边开裂有很大影响。
The technological design makes use of symmetry and adopts the two mould process, which increases material yield ratio.
文章利用对称性,采用左右合模工艺,提高材料利用率。
In 2012, the OLED panel will have a 50% higher material cost and 30% lower yield than LCD panels.
而在2012年,OLED面板的材料成本则比lcd面板高50%,良率则比后者低30%左右。
By pressing at very much higher temperatures lower pressures are required as the yield strength of the material is lower.
由于很高温度下材料的屈服强度较低,因此只需较低压力就能挤压。
Supported by the belief that people never yield in spite of reverses will have greater power than those who appear to be invincible material force.
由百折不挠的信念所支持的人的意志,比那些似乎是无敌的物质力量具有更大的威力。
Jinan 17. a strong gluten wheat, was taken as an experimental material to study the effect of nitrogen application methods on grain yield and quality.
以优质强筋小麦济南17为材料,研究氮肥不同施用量、基追比和追氮时期对小麦籽粒产量和品质的影响,分析了产量与品质的关系。
Beyond the yield point, the material will continue to deform, but with less stress than before, because the material has begun to yield.
超过屈服点之后,材料会继续变形,但是因为材料开始屈服,应力会减小。
The plastic theory of composite material include three criterions: the yield criterion, the flow rule and the hardening rule.
复合材料的塑性理论通常包括三方面准则:屈服准则、流动准则和强化准则。
Yield strength elongation-strain corresponding to yield strength of material.
屈服强度伸长—对应于材料屈服强度的应变。
Forage maize SAUMZ1 is a new material of forage maize with high yield, excellent quality, strong resistance and extensive adaptability.
玉米草saumz 1是一个产量高、饲用品质优良、多抗、适应性广的多年生优质饲用玉米新材料。
Deformation velocity has no obvious effect on the flow of material, initial yield stress and flow stress.
变形速度对材料流动、初始屈服应力、流动应力影响不明显。
A chemical additive or inert material used to decrease the density or increase the yield of a cement slurry.
减小水泥浆密度或增加水泥浆产率所用的化学添加剂或惰性材料。
So the erect panicle type population has a bigger dry material production capacity and higher biological yield, these are the physical basis of high economic yield.
因此,直立穗型水稻群体物质生产能力较强,生物产量较高,这是其最终经济产量较高的物质基础。
The stress is very complex and may reach to a peak value exceeding the yield stress of the material.
其应力分布非常复杂,而且有超过材料屈服应力的应力峰值。
Because of the lower yield point of rotor material, the local plastic deformations are found during operation at rate speed.
由于转子材料屈服点较低,在额定转速时,局部会出现塑性形变。
The conventional photoelastic modes and procedures suffice to indicate whether or not the yield point of the material of the prototype will be exceeded.
常用的光弹性模型和方法能够指明原型材料的屈服点是否将被超过。
The influences of catalyst, solvent, temperature and raw material on the yield of TPP are investigated. The yield of TPP increases from 30.0% to 49.5%.
研究了催化剂、溶剂、温度、原料等因素对四苯基卟啉收率的影响,收率由30.0%提高到49.5%。
It was biggest that the production of peanut dry material influence on the economic yield at after full bloom.
盛花后干物质的生产对花生经济产量的影响最大。
The void - containing material model is based on Sun' s material model. Its yield surface consists of a combination of isotropic expansion and kinematic translation.
该含微孔材料模型扩充了孙毅的材料模型,其屈服面由膨胀和运动平移组合而成。
The development work done by Wuhan steel with welding material for submerged arc welding, gas yield welding and manual welding of pipeline steel with high performance is introduced.
介绍了武钢在高性能管线钢埋弧焊、气保焊及手工焊焊接材料开发方面所作的工作。
This paper makes the optimum autofrettage analysis of thick-walled cylinder of the material with different yield strength in tension and compression base on the Mohr's yield criterion.
本文运用莫尔屈服准则对承受内压的拉压屈服强度不同材料的厚壁圆筒进行了自增强分析,得到了依赖于材料拉压比的厚壁圆筒的最佳弹塑性界面半径、最佳自增强内压。
This experiment investigated the effect of combining application of different ameliorative material and fertilizer to the biological yield and quality of alfalfa and Leymus chinensis.
本试验采用不同改土物料与化肥配合施用对人工建植草地苜蓿和羊草生物产量和品质影响进行了研究。
The quantity of material or the percentage of theoretical yield anticipated at any appropriate phase of production based on previous laboratory, pilot scale, or manufacturing data.
预期产量在以前实验室、中试规模或生产数据的基础上,预计任何适当的生产阶段的物料的量或理论产量的百分比。
The temperature-controlling programme, reaction material ratio and reaction time on the quality and yield of the product were also investigated systematically.
同时,还探索了分段控温程序、物料配比、反应接触时间等对产品质量和产率的影响。
For reinforced concrete structure construction with seismic fortification, the yield-strength ratio of steel bar is a very important material quality index.
对于有抗震设防的钢筋混凝土框架结构施工,钢筋屈强比值是个十分重要的材料质量指标。
The concepts of raw material utilization ratio, product yield ratio, product qualification ratio as well as the importance for the enterprise are discussed.
本文阐述了肉制品生产中原料利用率、产品出品率和产品合格率的概念及其在企业中的重要性。
Methods Employing the stepwise glycosylation strategy, the target compounds were prepared via 10 steps of reactions using diosgenin as the starting material with an overall yield of 15%.
方法以薯蓣皂素为起始原料,采用逐步糖苷化策略,经10步反应制得目标化合物,总收率约为15%。
The analysis has primarily three aspect influencefactor:Production control system, ecosystemterm with cultivation technique measure influenceraw material quantity with the yield.
分析主要有三方面影响因素:生产管理体制、生态条件和栽培技术措施影响原料质量和产量。
The analysis has primarily three aspect influencefactor:Production control system, ecosystemterm with cultivation technique measure influenceraw material quantity with the yield.
分析主要有三方面影响因素:生产管理体制、生态条件和栽培技术措施影响原料质量和产量。
应用推荐