The main goal of these tests is to ensure that the software does not crash in conditions of insufficient computational resources such as memory or disk space.
这些测试的主要目的是确保软件在计算资源（比如内存或磁盘空间）不足的情况下不会崩溃。
The main target is to start the server, run the tests, then stop the server.
主要的目标是启动服务器、运行测试，然后停止服务器。
Although the chosen combination of tests extensively utilizes the four main resources, it may only be executing a small subset of the kernel.
尽管所选的测试组合充分地利用了四种主要资源，它也有可能只是执行了内核的一小部分。
More often than not, if they do write tests, they're typically very simple, covering the method's main functional aim.
而且如果需要编写测试，通常都是十分简单、覆盖方法的主要功能目标的测试。
Tests indicate that main cause for sealing failure is that rigidity of the rear cover is too low.
试验结果表明，导致密封失效的主要原因是后端盖刚度设计过低。
Tests the main performance index of the detector and proves that the working condition of the detector is more stable.
对小型测溶氧仪的主要性能指标进行了一系列测试，证明小型测溶氧仪的工作状态比较稳定。
SNC has finished wind tunnel testing and conducted some main propulsion system and reaction control system tests.
SNC已完成风洞测试，并进行了一些主推进系统、反应控制系统的测试。
This is the main entry point for your unit tests. It has some custom configuration that might be unfamiliar, but it's not something you'll need to edit.
这是单元测试的主要入口点。它有一些你不熟悉的自定义配置，不过你并不需要编辑这里的任何东西。
Finally, scheduling and precautions for verification tests of the calibration pressure of main steam safety valve under 83 % FP power level are given.
最后，给出在83 %FP以下的功率运行下进行主蒸汽安全阀定值校验试验的窗口安排与注意事项。
Acceleration, displacement and strain response from seismic tests for all main parts of the three types of heat exchangers were measured under both conditions with and without water.
在有水和无水条件下进行了该三台热交换器的地震响应试验，测得了热交换器中各重要部件的加速度、位移和应变响应值。
Reserve the main branch for integration and tests.
保留主要分支以便进行整合和测试。
It is composed of the following three modules: emphases of each chapter, typical examples and comprehensive tests. It includes main knowledge points of course.
该课件包括各章重点、典型例题和综合测试三大模块，涵盖了课程的主要知识点。
Static and dynamic calibrations and actual cutting tests have confirmed that the main performance figures of the dynamometer meet the specifications recommended by CIRP.
经静态及动态的标定和实际的切削试验证实，该测力台的主要性能指标符合CIRP的规定。
The paper introduces the development background and design target of KM186diesel engine, optimization design of main components and perfect data from many tests.
本文介绍了KM186型柴油机的开发背景及设计目标，主要零部件的优化设计过程以及通过大量试验所获得的各项良好指标。
Laboratory tests and analyses were carried out to investigate the relationship between the main drilling parameters and their drilling effects.
对行星表土钻头钻进效果和主要钻进参数的关系进行了试验分析。
The tests to produce the cement with high carbon fly ash instead of clay are made, and the main technology and cement proportioning options are presented in this article.
本文对高碳粉煤灰代替粘土生产水泥进行了试验研究，提出了生产操作的主要技术方法和水泥配料方案。
Based on field investigation and lab tests, the main failure form of the sand loess slope and its impact factors on the northern loess Plateau are summarized in this paper.
基于野外调查和室内试验分析，阐述了黄土高原北部砂黄土边坡破坏的主要形式及其影响因素。
The paper outlined the main structure and working principle of the system and verified its effectiveness through numerical simulation and engineering tests.
本文概述了系统的主要结构与工作原理，并应用数值仿真和实际工程试验验证考核了系统的有效性。
The results of high and low temperature tests and indication measurement as well as the observing data and main engineering parameters (e. g. cell temperature) during the flights are given.
给出了环境模拟试验和指标测试的结果，以及在飞行中得到的观测数据和主要工程参数的变化情况。
Recently, the main tests for the interface characteristics of reinforced soil are pullout test and shear test.
目前，国内外对于加筋土的界面特性试验仍然以直剪试验与拉拔试验为主。
It is considered that the main cause of unstable flame of the boiler in operation results from the unreasonable design of the burner through tests.
通过试验，认为锅炉燃烧器设计不合理是造成该炉在运行中着火不稳的主要原因。
Cyclic loading-unloading tests of Fangshan marble specimens were made using a conventional triaxial testing machine and the main test results are presented in this paper.
本文介绍了作者们在常规三轴试验机上对房山大理岩试件做的循环载荷试验以及主要的实验结果。
The structure of the BES main drift chamber and arrangement of cosmic ray tests have been described briefly. The main test results of the chamber performance have been given.
简要描述了北京谱仪(BES)主漂移室的结构和宇宙线实验安排，给出利用宇宙线测试主漂移室性能的主要结果。
Activated carbon fibre was selected through tests as an optimum adsorbent for butyl acetate in gas. The main factors affecting the adsorption performance were studied.
通过试验选择活性炭纤维作为吸附剂，吸附气体中醋酸丁酯。对影响其吸附性能的主要因素进行了研究。
The results of commercial tests showed that the main reason of temporary deactivation of catalyst was the adsorption of organics and covering of organics on the active sites of the catalyst.
工业试验结果表明，大分子有机物吸附和覆盖了催化剂活性中心是催化剂暂时性失活的主要原因。
This paper describes the industrial tests on the main gas parameters having impact on TRT power, the flow rate, pressure, temperature and dust content of the gas into turbine.
本文对影响TRT功率的主要煤气参数，进入透平机的煤气流量、煤气压力、煤气温度、煤气含尘量进行了工业实验。
The tests should allow the attainment of high-resource utilization levels for main kernel areas, such as the CPU(s), memory, I/O, and networking.
测试应该可以得到CPU（s）、内存、I/O和网络等主要内核区域的高水平的资源利用率。
In order to get included in our main tests, vendors must fulfill various conditions and minimum requirements.
为了能参加我们的测试，供应商必须满足各种各样的条件和最低限度的要求。
The measurement of dielectric loss angle is one of the main methods in the preventive tests for the insulation of electrical equipment.
电气设备绝缘预防性试验中的介质损失角正切的测量，则是一种使用较多而且对判断绝缘较为有效的方法。
The measurement of dielectric loss angle is one of the main methods in the preventive tests for the insulation of electrical equipment.
电气设备绝缘预防性试验中的介质损失角正切的测量，则是一种使用较多而且对判断绝缘较为有效的方法。
应用推荐