For the same grain size and hardness in the unembrittled conditions, martensite has lower yield strength higher Charpy fracture energy and lower FATT due to finer mean carbide size.
在同样晶粒度和硬度，不添加杂质的条件下，马氏体有较低的屈服强度、较高的冲击断裂功以及较低的塑脆转变温度，这些都由于较细的平均碳化物尺寸引起。
The wide range of investigations shown shut lower yield strength, coarse grain size and metallurgical flaws were the basic causes for the earlier failure of superalloy for turbine disk.
广泛的研究表明，屈服强度低、粗晶粒尺寸、冶金缺陷的存在是造成涡轮盘用高温合金早期失效的主要原因。
By pressing at very much higher temperatures lower pressures are required as the yield strength of the material is lower.
由于很高温度下材料的屈服强度较低，因此只需较低压力就能挤压。
Yield strength of extrusion bar after forging process was much lower before peak aging and much higher after peak aging.
屈服强度峰时效前先锻后挤的低于直接挤压的，而峰失效后前者高于后者。
The pulps with light color, higher yield and strength properties, as well as lower bleachability can be obtained.
可获得本色浆色浅，得率和强度较高，漂率较低的纸浆。
The yield strength of vanadium bearing steel improves at lower temperature because of low phase transformation starting temperature.
含钒钢因相变开始温度低，其屈服应力快速增加的温度较低。
At lower annealing temperature obtain high strength and high yield ratio showed cyclic softening feature easily. That is detrimental to the using life of coiled tubing.
较低退火温度获得高强度、高屈强比易表现出循环软化特征，不利于提高连续油管的疲劳寿命。
Compared with the strip produced by conventional austenite rolling, the yield strength of the ferrite rolled strip was lower by about 20%, with same elongation and strain hardening exponent.
相对于常规奥氏体轧制，铁素体轧制薄板的屈服强度下降了20%左右，伸长率及应变硬化指数与之相当。
Compared with the strip produced by conventional austenite rolling, the yield strength of the ferrite rolled strip was lower by about 20%, with same elongation and strain hardening exponent.
相对于常规奥氏体轧制，铁素体轧制薄板的屈服强度下降了20%左右，伸长率及应变硬化指数与之相当。
应用推荐