Purpose: Low voltage output amplifier, audio muting, DC-DC converter.
用途：用于低电压输出放大，音频静音，直流-直流转换。
If the panel has a very low voltage output (less than 33 cells in series), it is an advantage to employ a Schottky diode in this place.
如果面板上有一个非常低的输出电压(小于33系列中的细胞)，这是一个优势，采用肖特基二极管，在这个地方。
The device's produced output voltage ended up being 1.1 volts, which is enough to run low-power sensors.
这个装置产生的输出电压最终是1.1伏，这足以带动一个低功耗感应器。
The results showed that the sinusoidal output voltage at high Q and non-sinusoidal output voltage at low Q were obtained respectively when the parameters of the load network got various.
结果显示，当放大器的负载网络取不同参数值时，分别得到高q值的正弦输出电压和低q值的非正弦输出电压。
The EL5221 is a dual, low power, high voltage rail-to-rail input-output buffer.
该EL5221是一个双通道，低功耗，高电压，轨对轨输入输出缓冲器。
Using the method of firing Angle prediction, steady sinusoidal output voltage with low harmonic components can be generated.
通过开关角预置方法，叠加出了谐波含量低的稳压正弦波输出。
There are soft switching conditions of all switches, low voltage stresses on the output diodes, and smaller input and output filters in this topology.
该拓扑具有所有功率开关均为软开关，输出二极管电压应力低和输入输出滤波器小的特点。
The analyses show that using a low equivalent series resistance (ESR) capacitor with a carefully determined value and raising switching frequency can decrease output voltage fall.
分析表明，采用合适电容值的低等效寄生电阻的滤波电容，并提高开关频率，可减小输出电压跌落。
It has been shown that the designed DC switching mode converter has a stable output voltage frequency, small ripple, high operating frequency and low power consumption.
结果表明，所设计的直流开关型变换器集成模块输出电压稳定、纹波小、工作频率，高、功耗低，且体积小。
Two circuits, characterized by high Power Factor and low output voltage, are proposed.
这两种电路都具有功率因数高、输出电压较低等特点。
Experiment results showed that the correction device of power factor could realize high power factor, low harmonic distortion and low ripple of output voltage.
通过实验结果表明，单级功率因数校正装置可以实现较高的功率因数、较低的总谐波畸变，而且输出电压纹波小。
It can achieve a fixed output of DC voltage in the universal input range of ac 80 ~ 265 V. It owns the advantages of high efficiency, low total harmonic distortion, PF near to 1.
该方案能在80 ~ 265V宽输入电压范围内得到稳定直流电压输出，具有效率高、总谐波畸变率低、功率因数接近为1等特点。
Simulation and experimental results show that the proposed converter has sine wave input current and output voltage, low harmonic content, adjustable power factor, and zero voltage commutation.
仿真和实验结果表明：所提出的变换器输入电流和输出电压为正弦，谐波小且输入功率因数可控，并可实现零电压换流。
In electronics, a circuit for converting AC voltage to low voltage DC in such a way that the output is regulated to minimize noise and voltage fluctuation.
在电子技术中，把交流电转换成低电压直流电的一种电路。这种电路的输出是经过调整的，使它的噪声及电压波动都很。
Experiment result showed, the topology can make the device get to high Power Factor (PF), low Total Harmonic Distortion (THD) of input current, low ripple of output voltage, and high efficiency.
实验结果表明，应用该电路拓扑的实验装置，其功率因数较高，输入电流的总谐波畸变较低，输出电压纹波小，而且整个装置的效率也比较高。
At low output voltage, the majority of the rated power of traditional adjustable linear power supply is wasted in the internal power supply and the conversion efficiency is low with huge volume.
传统的可调整线性电源在输出电压低时，电源的大部分额定功率耗费在电源内部，变换效率很低，而且体积庞大笨重。
The algorithm yields low common mode voltage and current, acceptable PWM ripple at the input and output of the inverter, and has no overvoltage problems unlike AZSPWM1.
该算法产量低共模电压和电流，在可接受哒PWM输入纹波 和输出哒逆变器，并没有过电压 提问题不要像AZSPWM1。
Output switch module is a low voltage PLC internal drive external signals into the switching signal output device and to achieve internal and external PLC electrical signal isolation.
开关量输出模块是将PLC内部低电压信号转换成驱动外部输出设备的开关信号，并实现PLC内外信号的电气隔离。
As improved, input buffer circuitry comprises a pull up stage to pull up the voltage of the differential amplifier output slightly higher during an output low condition.
作为改进，输入缓冲电路组成的阶段拉一拉期间的输出低的条件差分放大器的输出电压略高。
A real-world voltage source has a very low, but non-zero output impedance: often much less than 1 ohm.
一个真正的世界电压源具有非常低的，但不为零输出阻抗：通常远小于1欧姆。
The replica-amplifier gain enhancement technique is applied to improve the DC gain of the amplifier, which does not degrade the output swing and is very suitable for low-voltage applications.
为了提高运放的直流增益，采用了复制运放增益增强技术，这种技术的特点是在提高增益的同时不影响输出摆幅，非常适合低电压场合。
The output buffer has ability of switching the output voltage to be low level and high level in high-speed.
此输出缓冲器可快速地将输出电压切换为低电平和高电平。
The principle figures of input stage middle gain stage and output stage for a usual two stage low-voltage CMOS operational amplifier and their principal performance are presented in the paper.
给出了一种常用两级低电压CMOS运算放大器的输入级、中间增益级及输出级的原理电路图，并阐述其主要工作特性。
The high temperature materials, phased array sensor, and low current requirements stabilize the output signals over a wide range of input voltage, ambient temperature, or output frequencies.
高温材料，相控阵传感器，低电流的要求较稳定的输入电压，环境温度，或输出频率范围的输出信号。
When we use low-dropout switching power switching converter to reduce positive input voltage, we usually need an extra low - power negative output voltage.
在采用降压开关功率开关转换器降低正输入电压的同时，通常还需要一个额外的低功率负输出电压。
The MLV Series device provides a high output signal at a low operating voltage.
该MLV系列设备提供了在低工作电压下的高输出信号。
The ripple of output voltage is big with the low loads and need to be fixed to get low EMI.
其输出电压在轻载下纹波较大，可采取一定的措施。
The newly CUK controller realizes a kind of high efficiency, low cost and very low output voltage ripple negative bias voltage design.
介绍的新型CUK型变换器，旨在实现一种高效、低成本、输出电压纹波极低的负偏压设计方案。
The newly CUK controller realizes a kind of high efficiency, low cost and very low output voltage ripple negative bias voltage design.
介绍的新型CUK型变换器，旨在实现一种高效、低成本、输出电压纹波极低的负偏压设计方案。
应用推荐