低电流消耗。
Humidity may also degrade low current measurements.
湿度也能影响弱电流测量。
The low current error and measures were discussed also.
还讨论了小电流误差的问题及对策。
It can achieve unity power factor and low current distortion.
它可以实现单位功率因数和低电流畸变。
Some low current applications require switching through a matrix.
有些小电流应用需要通过矩阵进行切换。
Features include fast response, low driving voltage and low current consumption.
其功能包括快速响应，低驱动电压和低电流消耗。
These currents can degrade the accuracy of low current measurements considerably.
这种电流能够大大降低弱电流测量的准确度。
This current will cause errors in low current measuring or in high impedance circuits.
在测量小电流或高阻电路时，该电流会引起误差。
A number of error sources can have serious impacts on low current measurement accuracy.
若干误差源会对弱电流测量的准确度产生严重的影响。
Periodically perform this system check on only the crosspoints for low current switching.
对小电流切换的交叉点定期进行系统检查。
In general, low current matrix switching can become complex and is best explained by illustration.
总体而言，小电流矩阵切换可能会变得非常复杂，将通过图示进行说明。
Because the thyristors work instantaneously, low current thyristors are used, then cost is reduced.
晶闸管是瞬间工作，可采用小电流管，使成本降低。
Words: incoming abnormal abnormal switch, IR motor drive current, low current, resistance increased.
单词：来料异常，切换异常，IR电机驱动电流，电流偏小，阻值增大。
The offset current specification of the switch card should be as low as possible for switching low current.
对于切换小电流来说，开关卡的偏移电流指标应该尽可能小。
Measuring the voltage coefficient of a high resistance requires sourcing a voltage and measuring a low current.
测量高电阻的电压系数需要输出电压并测量小电流。
Experimental results shown that this system is of high precision, quick dynamic response and low current harmonic.
实验结果表明：该系统精度高，动态响应快，谐波电流小。
For this application, a single instrument provides both the voltage sourcing and the low current measurement functions.
对于这种应用，单台仪器提供了电压源和小电流测量功能。
A low current measurement system may also require significant settling time be fore the expected accuracy can be obtained.
对于小电流测量系统，也需要足够的稳定时间才能够获得预期的准确度。
According to small signal theory of automation theory, arc of low current TIG welding can be considered as a linear system.
依据自动控制理论中的小信号理论，小电流TIG焊的电弧具有线性系统的特征。
Low current measurement applications include capacitor leakage, low current semiconductor, light, and ion beam measurements.
弱电流测量的各种应用包括电容器的漏电、弱电流半导体、光和离子束测量等。
Further information on shielding low current, high resistance, and high impedance voltage circuits can be found in Section 5.
关于屏蔽小电流、高电阻和高阻电压电路的更多信息，可参考第5章。
Even high resistance paths between low current conductors and nearby voltage sources can generate significant leakage currents.
即使小电流导体和附件电压源之间的高阻通路也会产生明显的漏流。
Switching applications of high impedance circuits include low current, high resistance, and high impedance voltage applications.
高阻电路的切换应用包括小电流、高电阻和高阻抗电压应用。
A new type of automatic reclose controller is described in this paper. A new method of low current ground protection is provided.
叙述了一种新型的自动重合控制器，提出了一种小电流接地保护的新方法。
All the special techniques used to minimize interferences for low current multiplexing also apply to low current matrix switching.
小电流复用切换中所有用来减小干扰的技术也都适用于小电流矩阵切换。
Shielding may be essential in a switching system if a mixture of low current, high voltage, and high frequency signals are present.
如果切换系统中会混合出现小电流、高电压和高频信号，屏蔽则非常关键。
Model indicates that, at low current density and high methanol concentration, the methanol crossover poses a serious problem for a DMFC.
模型计算显示，在低电流密度和高浓度甲醇进料情况下，甲醇渗透将成为DMFC的一个严重问题。
This can be minimized by locating the high voltage channels away from the sensitive low current channels and by using well-shielded switches.
使高电压通道远离敏感的小电流通道，并使用良好屏蔽的开关，可将这种误差降至最低。
When measuring low current, electrostatic shielding (as discussed in Section 2.6.2) is the most common way to reduce noise due to AC interference.
在测量弱电流时，静电屏蔽(如第2.6.2节所讨论)是降低交流干扰引起的噪声的最常用的方法。
Applications such as measuring light with a photomultiplier tube generally require the use of a picoammeter due to the low current levels involved.
由于要测量的电流非常弱，所以用光电倍增管测量光的应用工作通常需要使用皮安计。
应用推荐