The task of a phase-lock receiver is to reproduce the original signal while removing as much of the noise as possible.
锁相接收机的作用是重建原信号而尽可能地去除噪声。
By simply pressing the Sync button on the receiver, the user can automatically lock any of 50 available UHF frequencies between the transmitter and receiver.
只需按下接收器上的同步按钮，用户可以自动锁定50至发射器和接收器可超高频频率。
Due to steady phase error, low-order PLL has a trouble in tracking frequency ramp signals, so that the receiver cannot lock carrier signals.
低阶锁相环跟踪频率斜升信号时产生的稳态相差致使环路失锁，接收机无法锁定载波信号。
It is shown that our analyzer has the ability to guide the receiver to lock on the carrier even when the carrier amplitude is smaller than that of the subsidiary lines of subcarriers.
分析表明，甚至在载波谱线低于副载波谱线时，该分析器也能把精密跟踪接收机引导到载波上而不致错锁。
Finally this expansion of the demonstration of the GPS receiver lost lock circumstances, the single frequency network adapter time synchronization of the impact.
最后本文扩展性的论证了GPS接收机失锁情况下，对本文所设计的单频网适配器时间同步所产生的影响。
A measurement system for gas dynamic concentrations based on TDLAS was constructed by using an auto-balanced photo receiver and a digital lock-in amplifier.
基于自平衡激光接收器和数字锁定放大器构造了TDLAS汽车尾气动态浓度测量系统。
This system is also equipped with "PILOTONE" and the latest "NOISE LOCK" dual-squelch circuit that will eliminate the random noise interference when the receiver is at its standby state.
本系统装备有“PILOTONE”和最新的“噪音锁”双重消杂音电路，当接收器在它的待命状态时，它可消除随机的噪音干扰。
This means that if a receiver can lock onto an incoming interface signal, then the audio word values are safe.
这意味着，如果一个接收器可以锁定传入接口信号，然后将音频字值是安全的。
Align the hex plate with the receiver on the head and gently press down until the lock clicks into place (figure 13).
然后将六角形快装板与云台上的对应处对齐，接着轻轻按下直到锁紧(图13)。
Means are then provided at an optical receiver to discover and lock onto floating wavelength grid of transmitted WDM signals and thereafter demultiplex the transmitted WDM signals for OE conversion.
然后，在光接收器处提供一些装置，以便发现并锁定发送过来的WDM信号的漂移波长栅格，这之后对发送过来的WDM信号进行多路分配以便于OE转换。
Means are then provided at an optical receiver to discover and lock onto floating wavelength grid of transmitted WDM signals and thereafter demultiplex the transmitted WDM signals for OE conversion.
然后，在光接收器处提供一些装置，以便发现并锁定发送过来的WDM信号的漂移波长栅格，这之后对发送过来的WDM信号进行多路分配以便于OE转换。
应用推荐