The grain of armor steel can be refined by choosing different loading temperature and cooling velocity.
选择不同的加载温度和冷却速度可以达到组织细化的目的。
Change in atmospheric density and temperature plus dust loading. But be aware that the planet's spin and orbit are being modified.
大气密度和温度的变化加上尘埃负荷。但是要意识到地球的自转和轨道处于不断的修正中。
Control circuit through the loading or unloading coolant compressor and make the air-freeze agent in the heat exchanger compressed air temperature constant.
控制电路通过加载或卸载冷冻剂压缩机而使空气-冷冻剂热交换器中的压缩空气温度保持恒定。
The results show that the heating temperature and the ways of cooling and loading are of great influences on the bond performance of reinforced concrete.
结果表明，受热温度、冷却方式和加载制度对高温后钢筋混凝土的黏结性能有很大影响。
Then sensitivity analysis on the factors of temperature and traffic loading is conducted and a short-term rutting prediction model is developed.
分析过程中进行了路面车辙的温度和交通敏感性分析，并进行了针对其短期发生过程的预估模型研究。
Figure 1 shows the recommended watt loading for a square inch or square centimeter of radiating surface as a function of furnace temperature.
图1中指出了每平方英寸或者是每平方厘米辐射面积所能负荷的理想能量和熔炉温度的函数关系。
Test shows that loading and temperature are the most important test factor than the others.
结果表明：载荷和温度是试验诸因素中最主要的因素。
A quantitative relationship between dynamic fracture toughness and temperature and loading rate has been obtained through thermal activation analysis.
通过热激活分析，可以获得定量描述动态断裂韧性、温度及加载速率之间的关系。
Basically because of the cold storage of goods loading too high, too many reasons leading to the frequent operation of the refrigeration unit can not drop down the temperature of the car.
基本上都是因为冷藏车厢内货物装载的太高、太多的原因而导致的制冷机组频繁工作可车厢温度却降不下来。
High temperature low cycle fatigue (HLF) life prediction models have great significance for design of high temperature structure under cycLic loading.
高温低周疲劳(HLF)寿命预测方法对于承受变幅载荷的高温构件的设计具有重要意义。
An process of ion bombardment heat treatment for high dimension precision slender rods was discussed through treating the valves with different loading ways, heating temperature, and heating ways.
以气门的离子轰击热处理为研究对象，通过对装炉形式、处理温度及工艺方法等试验，探讨了尺寸精度要求较高的细长杆件的离子热处理工艺。
In this paper, the vertical deformations of tall building structures under loading and actions of temperature changes as well as shrinkage effects have been discussed.
在本文中，对高层建筑在荷载、变温及砼干缩等因素作用下的垂直变形进行了分析。
Shortterm shear behaviors depend on loading rate and test temperature while the shapes of the shear creep curve and the creep lives depend on test temperature and stress.
瞬时剪切行为存在加载速率、温度相关性；剪切蠕变曲线形状和蠕变寿命与温度及应力大小有关。
The results show that the sludge loading can be determined preferably according to the temperature and denitrification demand.
试验结果表明，污泥负荷的确定应根据温度和脱氮要求；
It prefers cohesive failure at high temperature, otherwise it tend to interface failure at high loading rate.
提高温度有利于出现内聚破坏，而提高实验速度则易于出现界面破坏。
For over-long reinforced concrete frame structure, temperature loading often leads to crack formation of the beams and plates.
对于超长钢筋混凝土框架结构，变温的作用常常导致混凝土梁和楼板的开裂。
It was found that the influence of the reaction condition was great, for temperature and MMC loading quantity both affected the action of the desorption.
结果表明：碳包铁的吸附性能受反应条件的影响较大，温度和载药量对释放率有一定的影响。
The effects of stirred velocity, chlorine flow rate, air auxiliary flow rate, solids loading, mean particle diameter and reaction temperature on global process rate are investigated and analyzed.
考察了搅拌速度、氯气流量、辅助空气流量、固体联二脲浓度、粒度及反应温度对过程速率的影响。 分析了影响过程速率的主要因素。
The relation of thermal and temperature of material is studied through thermal loading.
对热载荷加载研究了材料的应力与温度之间的关系。
The effect of impregnation method, impregnation solutions, loading content of Pt, reduction temperature and the carbon pre-treatment on the activity was discussed.
考察了浸渍方法、不同浸渍液、贵金属含量、还原温度、载体的预处理等因素对对氯硝基苯加氢还原反应的影响。
The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.
研究了变形速度，试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。
The results show that the fracture toughness of Kic increased with lower loading rate and higher test temperature and the incision depth has no significant impact on the test results.
结果显示，断裂韧度随加载速率降低和试验温度提高而增大，而切口深度对结果的影响不显著。
The influence law of temperature and pressure on gas well liquid loading were obtained by corresponding formula.
本文利用相应的模型公式进行理论计算得到温度、压力对气井连续携液影响规律。
This paper introduces the features of short - term loading, and then analyzes the impact of temperature, rainfall, and time on leading.
介绍了短期负荷的特点，深入分析了温度、降雨量、时间等因素对负荷的影响。
Based on the improvement of the test equipments at the laboratory and the design of autocontrol software, the test technique on cyclic non-proportional loading at high temperature was established.
通过对实验室现有试验设施的改进和自动控制软件的设计与编制，建立了完善的高温多轴非比例循环加载试验技术。
The influence factors of the reaction, such as calcination temperature of the catalyst, catalyst loading, reaction temperature, reaction time and the ratio of raw materials, were investigated.
探讨了催化剂烘培温度、催化剂用量、反应温度、反应时间、原料配比等因素对反应的影响。
It is point out that loading LOX via variable speed pump can reduce throttle losses as well as can reduce the LOX temperature raise.
指出采用调速泵加注可以消除因节流引起的能量损耗，降低液氧的温升。
The uniaxial time-dependent strain cyclic characteristics and ratcheting behavior of SS304 stainless steel were studied by cyclic loading experiments at room temperature.
对SS304不锈钢在室温单轴循环加载下的时相关棘轮行为和时相关应变循环特性进行了实验研究。
The uniaxial time-dependent strain cyclic characteristics and ratcheting behavior of SS304 stainless steel were studied by cyclic loading experiments at room temperature.
对SS304不锈钢在室温单轴循环加载下的时相关棘轮行为和时相关应变循环特性进行了实验研究。
应用推荐