Concerning the stipulation and statement for empirical formula and revised index in point loading strength test there are still some uncertainties in related specifications and manuals.
关于点荷载强度试验的经验公式及其修正指数的规定和论述，在相关的规范和手册中还有一些有待明确的方面，因此在岩土工程应用中存在着一定的局限性。
Automotive half shaft flange is a coupling part under the combined action of bending and torsion, its strength, loading and actual size have an uncertainty.
汽车半轴凸缘是受弯扭联合作用的联接零件，其强度、载荷及实际尺寸具有不确定性。
By strengthening under low amplitude loading, bend fatigue strength and life of gear teeth can be increased by 3.97 and 109 percents, respectively.
经过低幅载荷强化，该齿轮轮齿的弯曲疲劳强度提高了3.97%，弯曲疲劳寿命提高了109%。
The effects of repeated loading on the fatigue shear strength of partially prestressed concrete beams are studied.
本文探讨重复荷载对部分预应力混凝土梁疲劳抗剪强度的影响。
The effect of loading rate on concrete splitting tensile strength for different lateral stresses is studied.
系统地探讨了有侧应力作用时，混凝土在不同加载速率下的劈拉强度规律。
Based on substantial experimental data, the effects of loading rates on the strength, fracture toughness and fragmentation efficiency of rock materials are discussed in this paper.
本文以充分的实验结果为依据，讨论了加载率对岩石材料的强度、断裂韧度和破碎效果的影响。
The change of strength with loading rate is primarily due to the variation of cohesion with loading rate.
且强度变化主要是由于粘聚力随加载速率变化引起的。
Supports shall be of strength and rigidity to suit loading, service and installed in manner which will not stress unduly the building construction.
管（道支）架要有一定的强度及刚性，与其荷载和服务相适应，并且其安装不应对建筑结构产生过度应力。
The compressive deformation and strength of the concrete under different loading rates and lateral stresses are studied systematically in the paper.
系统地探讨了有侧应力作用时，混凝土在不同加载速率下的受压变形和强度特性。
This controller is applied to the structural strength loading control system, which is the experimental system of a variable swept aircraft wing.
该控制器应用于变后掠机翼的结构强度加载控制系统之中。
There are more requirements for the strength of ro ro ship vehicle deck because of its loading characteristics.
由于滚装船装载车辆的特点，对车辆甲板强度提出了较高要求。
Under the repeated loading of the cranes, the fatigue strength of the columns is insufficient, and fatigue failures occurred.
在吊车荷载反复作用下，疲劳强度不足，因而出现疲劳破坏。
The effect of dynamic shear and tensile strength of tungsten heavy alloys on the fracture mode of fragmentation under explosive loading was investigated.
研究钨合金动态抗拉和抗剪强度对爆炸加载下破片宏观断裂模式的影响。
By Analyzing the economy for consolidation and the strength of soft clay during consolidation, the optimal design of the parameters of sand well and the loading schedule (project term) is proposed.
经过排水固结法的经济分析及软土排水固结过程中的强度分析，提出了砂井参数及加载计划(工期)的优化设计方法。
Stress of soft rock in deep mining is close to strength limit state, rock is sensitive to outer disturbed loading, research project was put forward in order to study rock rheology disturbed effects.
深井软岩的应力状态接近于岩石强度极限状态，对外部扰动载荷十分敏感，为了研究这种高应力状态下岩石表现出的力学特性，提出了岩石流变扰动效应这一研究课题。
When the biaxial nominal stresses are equal to each other, the mathematical relationship between loading strength and porosity can be also gained for the foamed metals under biaxial equal loads.
当双向承受的名义应力相等时，还可得到泡沫金属在双向等荷承载条件下的载荷强度与孔率的数学关系。
The influence of different cooling conditions and different heating loading paths on the strength of concrete is presented.
不同降温方式、升温-加载途径对混凝土强度的影响；
The relationship between loading and strength is established through the statistic characteristics of random loading.
通过随机载荷的统计特性建立强度与随机载荷的关系。
This paper also presents a reduction factor of strength required for checking shock strength based on the test results of embedded elements under low period repeated loading.
文章还根据预埋件在低周反复荷载作用下的试验结果，提出了在进行抗震强度验算时所需的强度折减系数。
Considering the system errors of gear drive and teeth synthetic flexibility, the loading point of bending strength was studied.
考虑系统误差和轮齿综合柔度，对齿轮弯曲强度的计算力点进行研究。
To the large ship, the relationship between the ultimate strength and the loading capacity is almost linear.
对于大中型船舶，载重量与极限强度基本保持线性关系。
With the increase of solids loading, the particle density increases and the bending strength of green body decreases for the network polymer accounting for only a small amount of the composition.
随着固相体积分数的增加，单位面积的颗粒分布密度增大，网络高分子在成分中只占少量，坯体抗弯强度降低。
The change law of organic loading in the course of high strength organic wastewater treatment by expanded granular sludge bed (EGSB) was studied.
研究了厌氧颗粒污泥膨胀床(EGSB)反应器处理高浓度有机废水过程中的有机负荷变化规律。
Static loading tests of 35 specimens were carried out to study the shear strength of concrete filled steel tube (CFST) columns.
为建立钢管混凝土柱的受剪承载力计算式，完成了35根试件的静力加载试验。
The compressive properties of saturated and dry concretes including strength, elastic modulus and peak strain under different loading rates are studied by experiments.
在准静态及中低加载速率下，开展了饱和与干燥混凝土力学性能变化的试验研究。
No significant difference in the strength degradation among all static loading specimens and no inner cone cracks occurred in static loading specimens.
不同加载时间下的静态加载试件强度下降的差异无统计学意义，同时不伴随内锥状裂纹的产生。
Different loading rate gives different uniaxial tensile strength.
加荷速率不同，单轴抗拉强度值也不同。
The tubular backbone is the main loading member of motorcycle frame, which needs reliable strength calculation when designing.
摩托车车架主管是摩托车的主要承载构件，设计时要进行可靠的强度计算。
Long fiber thermoplastic technology allows the fibers, to maintain a length sufficient to provide structural strength at lower fiber loading.
长纤维热塑性技术允许在较低的纤维负载下纤维维持足以提供结构强度的长度。
With test results of five specimens of exterior joints of rein- forced concrete frames subjected to low cyclic loading, the shear strength of these joints is discussed.
本文介绍五个钢筋混凝土框架过节点试件在低周反复荷载下的试验结果。
应用推荐