If an axial load rated bearing is the best, why are they less reliable than the sealed cartridge bearing?
如果额定轴向载荷轴承是最好的，他们为什么不可靠的轴承密封墨盒比？
The up jarring section takes use of hydraulic mechanism, the jarring force can be adjusted according to up elevating load but can not exceed the max. load for tool load rated.
上击器采用液压原理，其震击力可由上提力的大小自由调节，但使用时不允许超过工具限定的最大负荷。
The boiler can combust stably at the rated load scope of 30~100% when burning the design coal.
本锅炉在燃用设计煤种时锅炉能够在30～100%额定负荷范围内稳定燃烧。
In order to test the working ability of the equipment under rated load, the load test can be carried out according to the percentage increasing mode of the design center.
小型加工中心负荷试验主要是为了检验设备在额定负荷下的工作能力，负荷试验可按加工中心设计功率的百分比递增方式顺序进行。
Apply150% rated load at rated power factor and measure the time required for the inverter protective devices to operate.
在额定功率因素上施加150%额定负荷，并测量逆变器保护装置启动所需时间。
Traditionally, the vehicle overload is defined as the load that exceeds its rated load.
传统意义上车辆的超载是指车辆当前负荷高于该车型的额定载荷。
Load matching is intended to make induction heating power to the rated output power, and improve efficiency.
负载阻抗匹配的目的是为了使感应加热电源能够输出额定功率、提高效率。
For accelerated stress testing, the load resistance may be selected to draw a level of current higher than the rated current of the power supply.
对加速性应力试验，所选的负载电阻要能够吸收比电源额定值较高的电流。
The pump is rated pressure pump work for the highest allowable pressure, but their work is determined by external pressure load, pump life are directly related to their work pressure.
泵的额定压力是指泵连续工作时的最高许用压力，而其工作压力则决定于外部负载，泵的寿命与其工作压力直接相关。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另一台容量大的电动机。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另 一台容量大的电动机。
The fact is that when HSY is operated at rated load, magnetic loss is rather high, and efficiency drops compared to PMSY.
励磁输入和效率励磁输入和效率事实上，HS y额定负载运行时励磁损耗相当大，与PMSY相比效率下降。
Aiming at the problem of net-shell connector's rated load not meeting the requirement of overhead transmission line construction, a special traction tube was developed to help with tension stringing.
针对网套式连接器的额定载荷目前还不能满足架空输电线路工程施工要求这一问题，为方便张力放线试制了一种专用的牵引管。
The temperature coefficient of modulus of elasticity of sensing element material result in temperature effect on rated output of strain gauge load cell.
应变式负荷传感器额定输出温度影响是由于弹性体弹性模量的温度系数引起的。
Total rated load is 130 kg, 25 kg on the sturdy, suspended rear rack, designed particularly for the high stresses of trike riding.
共有额定载荷为130公斤，25公斤的彪悍，暂停后货架，专为高骑三轮车特别强调。
Test results have indicated that under rated load, the heat efficiency of the new burner is 30 ~ 50% higher than that of the ordinary ones.
测定结果表明，这种燃烧器在额定负荷下的热效率比目前常用的燃烧器提高30—50%。
When motor carries 30% rated load, the system efficiency may raise about9%.
当电机运行于30%额定负载时，可提高效率9%左右。
The flue dust emission concentration from heavy rated capacity boilers was high when different low rated capacity boilers worked under the similar load.
在相近低负荷条件下运行的不同出力的锅炉，额定出力大的锅炉烟尘排放量大。
Tipping load is an important index to evaluate loader's stability and at the same is one of essential bases to determine rated operating load of the basic machine.
倾翻载荷是衡量装载机稳定性的一个重要指标，同时也是确定整机额定工作载荷的主要依据之一。
Load Stability: 2000 hours at rated power.
稳定负载：额定功率下2000小时。
Load Life: 2000 hours at rated power.
负载寿命：额定功率下2000小时。
This allows 100% of the slings rated Working Load Limit to be achieved.
这样一来，便可100%地达到吊索的额定工作负荷极限。
Most engines in industrial use are rated to run at a constant speed, irrespective of the load they carry.
工业上使用的大多数发动机都以恒定速度运转，而与发动机承受的负荷无关。
IPS automatically shutdown if overload exceeds 120% of normal value for 10 seconds, IPS automatically resume work if overload comes to rated load.
当负载超过120%时，10秒后，IPS自动关闭输出；当负载恢复到额定负载后，IPS自动恢复正常工作。
To selection of the optimum type transposition from the test results at rated load and overload operation are compared and analyzed in the paper.
比较分析了在额定和超发工况下的试验结果，以便按照具体情况选择最佳方案。
The operating conditions are those steady state conditions, such as the one with rated load, the one after load regulation and the one after field regulation.
运行状态包括额定负荷、负荷调节后的稳态及励磁调节后的稳态。
At the same time, leakage magnetic coefficient of commutating pole is calculated and analyzed by magnetic flux in itself and gap at rated load.
同时，利用额定负载时换向极身中的磁通与穿过气隙的总磁通，对换向极漏磁系数进行了计算与分析。
At the same time, leakage magnetic coefficient of commutating pole is calculated and analyzed by magnetic flux in itself and gap at rated load.
同时，利用额定负载时换向极身中的磁通与穿过气隙的总磁通，对换向极漏磁系数进行了计算与分析。
应用推荐