• We should gradually increase the pressure of the compressor and step into the full load operation.

    我们应该逐渐增加压缩机压力逐步投入满负荷运行

    youdao

  • An additional axial preload tended to increase the pressure, the shear, and fiber strains essentially for all load scenarios.

    特别负荷方案中,一个附加向前负荷可以趋向增加压力切应力纤维强度

    youdao

  • Results With increase of the volume load and pressure load in the atrium, the atrial septal thickness increased, and the velocity of atrial septal motion increased or reduced.

    结果心房容量负荷压力负荷增加时,房间隔厚度增加运动速度减慢

    youdao

  • In horizontal well, frontal side casing string is usual bearing pressure. In horizontal hole section, with the length of casing increase, the hook load is decreasing on the contrary.

    水平井前端套管一般承受应力的,随着进入水平套管长度增加大钩载荷反而下降

    youdao

  • Line managers engaged in the work of the grassroots of the work load is getting heavier and heavier, the pressure faced by the increase.

    从事线管理工作基层行政人员的工作负荷越来越重,所面对工作压力越来越大

    youdao

  • Using multi-layer assembled out sleeve can increase the utmost load carrying capability of a hydraulic pressure sleeve coupling.

    液压联轴器外套采用多层筒组合式外套提高液压联轴器弹性极限承载能力

    youdao

  • The internal EGR rate is also reduced with increase in the engine load under the same engine rate and scavenging pressure.

    同一转速扫气压力内部EGR负荷增大而降低

    youdao

  • The result shows that load capacity and stiffness change proportionally with gas supply pressure, and with the increase of eccentricity, load capacity increases while stiffness DE - creases.

    结果表明轴承承载力刚度随着供气压力增大而增大,随着偏心率增大,轴承承载力增大,刚度降低。

    youdao

  • If the load suddenly decreases, the pressure in the inlet of pump will increase to 3-4 times as high as normal.

    负载突然降低液压泵进油压力比正常情况增加3—4

    youdao

  • Too much lip-axis will increase the load-side contacts, while the shaft is too small it will end lip of the seal contact surface pressure enough.

    过大增加端的接触载荷,则会使接触面上密封压力不够。

    youdao

  • Too much lip-axis will increase the load-side contacts, while the shaft is too small it will end lip of the seal contact surface pressure enough.

    过大增加端的接触载荷,则会使接触面上密封压力不够。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定