Building DTM model directly reflected rainwater load pressure in human active client area.
建立DTM模型，直观反映人类活动区域的雨水负荷压力；
And installed the overload protection, namely to ensure that motor and pump load pressure switch.
并安装了超载保护，即保证电机及油泵负荷的压力开关。
According to the structure invariance principle, a friction compensation controller is designed by choosing load pressure as the observed value.
基于结构不变性原理，以负载压力作为观测量，设计了摩擦力补偿控制器。
While the load pressure fluctuation, the load torque fluctuation and the rotational speed fluctuation mainly affect the steady performance of the system.
负载压力波动、加载转矩和转速的波动，主要影响系统的稳态性能。
In an ideal hydraulic system, the flow of the pump should just satisfy the load motion and the pump pressure is only a little higher than the load pressure.
较理想的系统应有能力在任何情况下使油泵流量恰好满足负载变化要求，而油压仅比负载压力略高一较小值。
A model were deduced, in detail, about servo pilot system according to the definition of load flow and load pressure were analyzed using simulink technology in theoretic.
推导了伺服调节器系统在负载压力、负载流量定义上的数学模型，并对其作了分析。
Then the aerodynamic pressure field obtained from the analysis of unsteady aerodynamics was transformed to the form of load pressure field which is suitable to the analysis of structure dynamics.
把非定常气动分析给出的压力场，转化为结构动力分析中的载荷压力场形式。
Load is the amount of pressure against a Web site.
负载是网站所承受的压力总量。
“It dumps its pressure load into the straps,” Dr.Schneider said.“Those two together make a very efficient design.
“压力负荷由凯夫拉纤维承担，”施耐德博士说，“纤维带再加上密封囊，这是一种非常有效的设计。”
We calibrated the Memknobs memory load, shown in Figure 3, to place the host under enough memory pressure to cause regular swapping activity.
我们校准Memknobs内存负载，如图3所示，将主机置于足够的内存压力之下，以产生定期交换活动。
Seating load and tightness is dependent on back pressure.
阀座密封负载和紧密性与反压力相关。
Load change in the engine intake manifold pressure changes that is when the spool displacement greater, gas output in response to faster.
在发动机负荷变化即进气管压力变化时，阀芯的位移更大，燃气输出量的响应更快。
The probability fatigue life - span of pressure vessel under the action of different cycle load is closely related to the cycle load with high stress.
承受不同循环载荷共同作用的压力容器，其概率疲劳寿命和在高应力水平上的循环载荷有着密切的关系。
High back pressure of exhaust manifold, rapid change in load, scavenge fire and so on.
高背压的排气系统，在负载快速变化，清除火灾等。
If the load exceeds the range of students, according to "adjust" evaporation pressure regulator.
如果负荷超过此范围，请根据《蒸发压力调节》进行调节。
The valve group is provided with the function of pressure compensation, which keeps the speed stable, not influenced by external load.
由于我司生产的抓斗阀组带压力补偿功能，流量跟外负载无关，速度不随负载波动。
The rings (for materials see Table 6.1) are heat-treated in different ways according to the strain on the gear rings and the contact pressure of the area carrying the highest load.
戒指(材料见表6.1)的热以不同的方式处理根据齿轮上的戒指，在载有最高负荷区接触压力的压力。
The overburdened heart may be carrying an extra pressure or volume load.
负荷过重的心脏，可能承担额外的压力负荷或容量负荷。
The pump is rated pressure pump work for the highest allowable pressure, but their work is determined by external pressure load, pump life are directly related to their work pressure.
泵的额定压力是指泵连续工作时的最高许用压力，而其工作压力则决定于外部负载，泵的寿命与其工作压力直接相关。
Instead of doing that deal, Jenson chucked himself into a team where Lewis was well established and would get a load of pressure, both from being in McLaren and by being Lewis's team-mate.
简森并没有那么做，他把自己送到一支刘易斯建立了良好基础的车队，并且在麦克拉伦车队以及成为刘易斯的队友都会压力很大。
The turbine DEH system adapts to prompt load drop, when the unit runs with transient house load to realize sliding pressure shutdown following the time required by turbine main equipment.
在汽机DEH系统适应快速降负荷的情况后，根据汽机主设备要求的时间短暂带厂用电负荷运行进行滑压停机。
And, essentially, is one kind of invalid ANSI flange sealed, it needs to put 50% of the bolt load for dummy blocks, and to be used for pressure load of only 50%.
而且，从根本上来说，ANSI法兰是壹种无效的密封，它需要把50%的螺栓负荷用于挤压垫片，而用于保持压力的负荷只剩50%。
Because of its excellent part load efficiency, many compressor unit is used mainly in the occasions for large displacement in high pressure piston compressor applications.
由于其出色的部分负荷效率，多压缩机机组主要应用于的场合为大排量中高压活塞式空压机应用领域。
Seating load and resultant tightness is dependent upon back pressure.
阀座密封负载和组合的紧密性是与返回压力密切相关。
We should gradually increase the pressure of the compressor and step into the full load operation.
我们应该逐渐的增加压缩机的压力，并逐步投入满负荷运行。
In static state characteristic test, pressure gain characteristic, runoff characteristic with load, runoff characteristic without load and leakage characteristic are completed.
在伺服阀静态特性方面，完成了伺服阀的压力增益特性、空载流量特性、负载流量特性及泄漏特性的测试。
The intramedullary pressure in trochanter major, femoral neck, center of head and load area of femoral head were measured respectively.
分股骨大粗隆、股骨颈、股骨头中心及股骨头负重区进行骨髓腔内压力测定。
The obtained blood pressure and blood flow, the geometrical sizes at no-load and load states, and the mean WSS and CS were compared between SHRs and WKYs.
同时比较SHR和WKY颈总动脉的平均血压和血流量、无载荷和载荷状态几何尺寸以及平均WSS和CS的特征。
The obtained blood pressure and blood flow, the geometrical sizes at no-load and load states, and the mean WSS and CS were compared between SHRs and WKYs.
同时比较SHR和WKY颈总动脉的平均血压和血流量、无载荷和载荷状态几何尺寸以及平均WSS和CS的特征。
应用推荐