Whether calculating the load of heating or cooling, it is generally neglected that the contribution of nocturnal radiation to the thermal surroundings of buildings.
无论是采暖还是制冷，在传统简化计算方法中一般都不考虑夜间辐射的影响。
The peak shaving parameter limit is important to the choice of heating system capability, and is relate to heat load distributing and economic question.
调峰的参数界限是供暖系统装机容量选择的重要参数，关系到系统运行时的负荷分布与经济性。
This paper presents the application of heating load prediction and predictive control in the heat supply system for energy saving and high grade heat supply.
为了节能和优质供热，提出将负荷预报和预测控制施加于供热系统中。
The paper introduces a method for calculating the heating load of initial station or heating station of hot oil pipeline, and gives proof to it.
为此，介绍了一种热油管道首站或加热站加热负荷的计算方法，以合理确定管道首站和中间站的热负荷。
In this article, the calculation of heating load, the selection of heating system and how to charge are discussed.
文章就热负荷的计算，供暖系统的选择及热费收取等方面进行了探讨。
The principle was established with designing the capability of heating equipment according to the peak heating load in greenhouse and deciding fuel store by total heating load in a period of time.
确立了依据最大采暖负荷设计采暖设备的容量，依据期间采暖负荷决定每个采暖期的燃料储备的原则，并给出了温室供热系统的设计程序。
And the heating load is data base of the actual operation of solar heating system.
并将计算得出的逐时采暖负荷作为太阳能采暖系统实际运行工况负荷侧的数据基础。
Heating area is the closely-aligned round coils. Heating area is arranged sufficiently to reduce the surface heat load of pipe and handle the heat transfer oil safely.
受热面采用密排圆盘管，受热面布置充足，降低管子表面热负荷，是导热油使用更安全。
According to Grey Forecasting theory, this paper presents two sets of Grey System Model which can be applied to forecast heating load — GM (1, 1) and Grey Correction Model.
本文根据灰色预测理论，提出了两种适用于供热负荷预测的灰色系统方法——GM(1,1)法和灰色校正模型法。
According to the national request of northern winter heating design, heating load is calculated in this paper.
按照国家关于北方地区冬季采暖设计的要求，进行了采暖负荷计算。
Presents respectively the theoretical calculating methods of peak load regulating in direct and indirect geothermal district heating systems.
介绍了直接式和间接式地热供热系统调峰负荷的理论计算方法。
It is necessary to count heat load caused by heat transfer between househould for heating systems of individual househould heat metering, and the heat load is one basis of choosing radiator.
对于分户热计量采暖系统，必须计算户间传热引起的热负荷，并将这一热负荷作为散热器选型的依据之一。
Use of these materials could shift heating or cooling load of power supply from peak period to off-peak period, lowering the cost of power supply for users.
运用这种相变储能建材，可将电力供给峰期时的加热或制冷负荷转移到谷期，使用户降低使用费用。
One of importance for heating systems is to predict the hourly load changes of heating systems.
分析了供热系统负荷变化的各种扰量，提出利用人工神经网络对供热负荷进行预测的方法。
The simulated dynamic heating load will guide the choice of auxiliary heat scheme and the equipments in the passive solar buildings.
室内负荷的动态模拟结果为被动式太阳能建筑的辅助能源运行方案、设备选择提供依据。
The characteristics of cooling and heating load of school buildings are discussed, the cooling and heat sources that are applicable to heating and cooling within school buildings are introduced.
探讨了校园建筑冷、热负荷的特点，介绍了适用于校园建筑供暖、供冷的冷热源。
Optimization of some parameters such as the location and the orientation of the excited aperture is performed in accordance with the requirements of improving the heating uniformity for the load.
根据改善加热均匀性的要求对激励口的位置和取向等参数进行了优化。
However, During the design of heating engineering, determining the orientation correction factor to the heating load is very important.
然而在进行采暖工程设计时，确定采暖热负荷的朝向修正率是非常重要的。
Adjust the proportion of combustion need to automatically adjust according to load and display the power of the size of fire-power, intelligent heating more comfortable.
比例调节燃烧，根据负荷需要自动调节燃烧功率并显示功率大小，智能化的供暖更加舒适。
By replacing natural circulation with ejecting circulation, the circulating water in each loop can be increased and match with the heat load of related heating surface.
将热水锅炉的水循环由自然循环改为引射循环，强制提高回路的循环水量，使各回路的循环水量分布与其受热面的热负荷相匹配。
The water flow rate should be adjusted appropriately to cope with the heating load of each zone.
应该适当调节水的流速来满足每个区域的热负荷。
In underground water source heating pump air-conditioning system of one guesthouse project, the heating pump unit does not always run at full load status.
某宾馆工程地下水源热泵空调系统中，热泵机组在实际运行中不总处于满负荷运行状态。
Combined with practical engineering examples, the ratio of cooling load and heating load of cogeneration system is discussed.
结合工程实例，讨论了城市冷热联供的冷、热负荷比例。
Using the exergy analysis method, the conception of energy quality character was presented, which indicated the discretion of electricity, gas, coal, steam and hot water, cooling or heating load etc.
基于热力学第二定律的分析方法，按照能质系数的概念确定了电、天然气、煤、蒸汽、热水等各种形式的建筑用能及建筑物耗冷量、耗热量的能源品位高低；
The boiler is designed multipass structure with large volume and heating surface area, several times of ordinary boiler. Load variation ratio should not be less than 2 times .
垃圾锅炉设计成多烟道结构，体积庞大，受热面积数倍于普通锅炉，且负荷变化率不小于2。
The correlation between the heating load of building and the solar heat collection of solar collector system was analyzed in the climate region of Xining, the capital of Qinghai province in Chino.
结合西宁地区的气象资料，计算太阳能系统集热量与建筑热负荷之间的相对关系；
The main purpose of this paper is to the principles of the circuit and the shaking machine. load calculation. the choice of the motor and the heating-wire power for dissolving trunk of manna alcohol.
本文主要介绍甘露醇溶解箱电路及晃动机械的工作原理，载荷计算、电机、电热丝率的选取。
A study of crack prevention under tensile load is performed on an aluminum alloy 2a12 specimen with an oblique spatial crack by using electromagnetic heating online.
选择带有空间斜裂纹的2a12铝合金试件进行了拉伸载荷作用下电磁热在线止裂研究。
Considering the load characteristics of the solid-state induction heating power supply, the resonant inverter load matching schemes are compared and analyzed in this paper.
详细分析了固态高频感应加热装置的动态负载匹配方案；阐述了动态匹配的原理；描述了动态匹配的控制电路。
Considering the load characteristics of the solid-state induction heating power supply, the resonant inverter load matching schemes are compared and analyzed in this paper.
详细分析了固态高频感应加热装置的动态负载匹配方案；阐述了动态匹配的原理；描述了动态匹配的控制电路。
应用推荐