The results show that the dynamic stability analysis can be replaced by quasi-static method with the static load multiplying an amplification factor in calculation.
结果表明：在实际计算中，可以将静载乘以某一“放大系数”作为计算荷载进行拟静力分析。
Analysis the basic factor of influencing quantity of expansion joint, including the seismic load and wind load, the calculating formula and measure of expansion amount.
分析桥梁伸缩装置伸缩量的基本影响因素，包括地震荷载和风荷载，国内外伸缩装置伸缩量的计算公式和方法。
Especially for the load factor, interference margin analysis, this article gives the situation of different cell load uplink budget.
特别是对负荷因子、干扰余量进行了分析，给出了不同小区负荷情况的上行链路预算举例。
Due analysis has been made and it is found that the nonlinear energy release rate of orthotropic plate with a, crack is dependent on the biaxial load factor.
本文分析双向加载下正交异性裂纹板的非线性能量率，指出所研究的裂纹板的非线性能量释放率与双向加载因子有关。
According to the factor analysis, the factor consists of four latitudes: studies load, companion's relationship, school life and teacher-student relationship.
根据因素分析得出，初中生学校心理压力源的因素由四个纬度构成：学业负担、同伴关系、校园生活、师生关系。
It is found from the analysis under special situation that the large axial load had obvious effect on dynamic interaction factor of group pile.
通过分析表明，在轴向力作用较大的情况下，动力相互作用因子的影响较为明显。
Our proposed limit analysis approach is conceptually simple: we simply aim to maximize the load factor under the same set of conditions that would apply to a holonomic analysis.
我们提出的极限分析方法是在概念上的简单：我们根本目的是最大限度地利用负荷因素根据同一套条件将适用于一个完整的分析。
Analysis and comparison between the finite element analysis and experiment results for stress intensity factor, limit load, and flexibility factor were performed.
从应力系数、极限载荷和柔度系数三个方面对有限元计算结果和试验结果进行对比分析。
Analysis and comparison between the finite element analysis and experiment results for stress concentration factor, limit load, burst pressure and failure location were performed.
从应力集中系数、极限压力、爆破压力和爆破失效位置四个方面对有限元计算结果和试验结果进行对比分析。
The total load factor is computed as the sum of the old total load factor and the current Loading Rate at the end of each successfully convergent nonlinear analysis.
在每次成功收敛非线性分析的最后，用旧的总荷载系数与当前荷载比的总和计算总荷载系数。
The paper puts forward impact factor analysis of the reliability in bulk power system using power flow tracing method on the basic of power flow tracing load-shedding model.
本文在潮流跟踪负荷削减模型基础上，提出了大电力系统可靠性影响因素分析的潮流跟踪法。
Double nonlinear factor was considered in the structure analysis. To calculate the ultimate bearing capacity, the equilibrium path of the load and displacement using arc-length method was traced.
结构分析考虑双重非线性情况，采用弧长法跟踪整个荷载—位移全过程的平衡路径，确定极限承载力。
From the analysis of the experiment results, it is indicated that the axial load ratio on behaviors of CFST subjected to compression-bending loads is the most significant effect factor.
对试验结果进行的分析表明，轴压比对钢管混凝土弯压构件受力性能的影响最为显著。
From the analysis of the experiment results, it is indicated that the axial load ratio on behaviors of CFST subjected to compression-bending loads is the most significant effect factor.
对试验结果进行的分析表明，轴压比对钢管混凝土弯压构件受力性能的影响最为显著。
应用推荐