测量空载电流。
It is indicated that dynamic property is changeable with load current.
指出系统的动态性能是随着负荷电流变化而改变的。
Can only be disconnected in the normal run-time load current switching.
仅能在正常运行时断开负荷电流的开关。
The load current is calculated from the supply voltage and the load power.
负载电流的计算应该根据工作电压和负载的功率计算。
The average of the line currents at rated voltage is the no-load current.
额定电压下线路电流的平均值即是空载电流。
The minimum load current is necessary for flawless operation with two-wire devices.
最低负载电流是必要的运作无误的两线设备。
Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
注4：负载电流静态电流增加，是指以地积比iload速冻。
Uniform distribution of load current is one of the key technique for paralleling operation.
如何平均分配负载电流是并联技术的一个重要方面。
Figure 3: LM5113 evaluation board efficiency versus load current at different input voltages.
图3：lm 5113评估板效率与负载电流不同的输入电压。
This paper presents a new method for measuring the power factor in nonsinusoidal load current.
该文论述了负载电流为非正弦波时功率因数测量的新方法。
The distorted load current then causes distorted bus voltages to appear throughout the system.
而畸变的负荷电流引起整个系统中母线电压畸变。
The load current is handled directly by the controller through semiconductor switching devices .
负荷电流由调节器通过半导体开关元件直接控制。
TEA1061 Pinout: Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
TEA1061引脚说明：注4：负载电流静态电流增加，是指以地积比iload速冻。
The output current is never influenced by power supply, realizing the invariableness of load current.
输出电流不受供电电压波动的影响，实现了电路的恒流功能。
Whereas if the switchgear load current is over 1250a is running, there is no necessary to keep the heater on.
但负荷电流1250a以上的开关柜在运行状态下，加热器可不投入。
The current distribution in fuses is discussed when high frequency components are present in the load current.
还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
An "Overcurrent relay" is a type of protective relay which operates when the load current exceeds a preset value.
过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
Additional capacitance will be required at the VS pins to handle load current peaks and potential motor regeneration.
在VS引脚处需要额外的电容来处理负载电流的峰值和电位电机的再生。
Its main transformer is made of imported cold rolled silicon steel, So its power loss is little with low no-load current.
该系列点焊机，主变压器均为进口冷轨硅钢片，因此，主变压器功耗小，各型空载电流小。
Interrupter circuit breaker has a strong ability to both cut off the load current, but also cut off the short-circuit current.
断路器具有很强的灭弧能力，既能切断负荷电流，也能切断短路电流。
Under this control strategy, the PWM converter output voltage characteristics is improved if load current vary and line voltage vary.
本文提出一种新的非线性控制方法，使得PWM开关变换器的输出电压，在负载干扰和电源电压干扰下，具有优良的动态特性。
Special load sharing techniques are employed in a parallel SMPS design to equally dis-tribute the load current among the parallel SMPS.
在并联开关电源设计中要采用特殊的均流技术，使并联联接的开关电源间负载电流能均匀分配。
Industry trends lean toward lower output voltages, more power, tighter power regulation, and faster response to changes in load current.
业界之发展趋势是要求更低的输出电压、更大的功率、更有效控制电源、以及对负载电流的转变有更快速的反应。
The results clearly show conduction losses are the function of semiconductor static characteristic, power factor, modulation depth and load current.
该表达式与器件静特性、功率因数、调制度及负载电流有关，利用其计算不同载波调制下通态损耗时只需改动导通占空比。
A new method for testing the load current and realizing the current limited control through testing the saturable voltage drop of MOSFET is introduced.
介绍了一种通过检测场效应功率晶体管饱和压降来检测负载电流，实现限流控制的新方法。
Therefore, additional instructions load current ammeter in the motor controller, which is a simple and practical method for indicating the maximum load.
为此，可在电机控制器上附加指示负载电流的安培计，这是一种简单而实用的方法用以指示达到最大负载。
The variables compared include the phase voltage and the phase current of the armature winding, the field current, the load current and the damper bar currents.
所比较的变量有电枢相电压和相电流、励磁电流、负载电流以及阻尼条电流。
The system consists of the AC input stage, single phase PFC, main inverter, output low-pass filter, auxiliary power supply, and load current sharing circuit, etc.
整个电源由输入电路、功率因数校正器、主逆变器、输出滤波电路、辅助电源、均流电路等部分组成。
The new control way can realize linear control for DC-bus voltage and get the fundamental component of the load current synchronously with a little of calculation.
该方法以电网电压为同步信号，在电网电压信号的过零点采样直流侧电容电压，并通过周期离散控制可以获得负荷电流有功分量。
In the multiple-loop control strategy for sinusoidal inverters based on load current feedforward, delay of the feedforward directly impacts the system's performance.
在基于负载电流前馈解耦的正弦波逆变器多环控制策略中，负载电流前馈作用的延迟直接影响着系统的性能。
应用推荐