The load current is handled directly by the controller through semiconductor switching devices .
负荷电流由调节器通过半导体开关元件直接控制。
An "Overcurrent relay" is a type of protective relay which operates when the load current exceeds a preset value.
过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
The load current is calculated from the supply voltage and the load power.
负载电流的计算应该根据工作电压和负载的功率计算。
It is indicated that dynamic property is changeable with load current.
指出系统的动态性能是随着负荷电流变化而改变的。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另 一台容量大的电动机。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另一台容量大的电动机。
Interrupter circuit breaker has a strong ability to both cut off the load current, but also cut off the short-circuit current.
断路器具有很强的灭弧能力，既能切断负荷电流，也能切断短路电流。
Additional capacitance will be required at the VS pins to handle load current peaks and potential motor regeneration.
在VS引脚处需要额外的电容来处理负载电流的峰值和电位电机的再生。
In theory, the decrease of the vacuum magnetic insulation transmission line inductance can heighten the energy transmission efficiency, can increase the load current.
理论计算表明，改造真空磁绝缘传输线，减小其自身电感，会提高能量传输效率，能够增大负载电流。
Can only be disconnected in the normal run-time load current switching.
仅能在正常运行时断开负荷电流的开关。
Uniform distribution of load current is one of the key technique for paralleling operation.
如何平均分配负载电流是并联技术的一个重要方面。
This paper presents a new method for measuring the power factor in nonsinusoidal load current.
该文论述了负载电流为非正弦波时功率因数测量的新方法。
To remove the influence on two-terminal fault location by load current and imperfect line model, an accurate fault location algorithm based on distributed parameter line model is proposed.
为消除负荷电流和线路模型不准确给双端量故障测距带来的影响，本文提出一种基于分布参数线路模型的精确测距算法。
Special load sharing techniques are employed in a parallel SMPS design to equally dis-tribute the load current among the parallel SMPS.
在并联开关电源设计中要采用特殊的均流技术，使并联联接的开关电源间负载电流能均匀分配。
From the view of switch utilization ratio, the theory gist is given for employing which circuit in condition with different total harmonic distortion of load current to correct harmonic current.
从开关利用率的角度，为不同负载电流畸变率情况下选取何种电路进行谐波补偿，提供了理论依据。
To remove the effect on two-terminal fault location by load current and imperfect line model, an accurate fault location algorithm based on distributed parameter line model is proposed in this paper.
为消除负荷电流和线路模型不准确给双端量故障测距带来的影响，提出一种基于分布参数线路模型的精确测距算法。
The new control way can realize linear control for DC-bus voltage and get the fundamental component of the load current synchronously with a little of calculation.
该方法以电网电压为同步信号，在电网电压信号的过零点采样直流侧电容电压，并通过周期离散控制可以获得负荷电流有功分量。
The minimum load current is necessary for flawless operation with two-wire devices.
最低负载电流是必要的运作无误的两线设备。
The current distribution in fuses is discussed when high frequency components are present in the load current.
还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
Based on the differences of harmonic testing point, there are two control ways for shunt active filters, that is, the way of load current sensing and the way of power supply current sensing.
并联型有源滤波器根据其谐波检测点的不同，有两种控制方法。即负载电流检测控制方法和电源电流检测控制方法。
The sensitivity of the proposed protection scheme is not impacted by the factors such as transition resistance, lightning stroke, fault type, load current and operating mode of power system.
该保护方案的灵敏度不受过渡电阻、雷击、故障类型、负荷电流、系统运行方式等因素的影响。
In the multiple-loop control strategy for sinusoidal inverters based on load current feedforward, delay of the feedforward directly impacts the system's performance.
在基于负载电流前馈解耦的正弦波逆变器多环控制策略中，负载电流前馈作用的延迟直接影响着系统的性能。
The algorithm does not need fault type identification, and its accuracy is not affected by fault resistance, system impedance, pre-fault load current and shunt capacitance.
算法无需故障类型判别，不受系统阻抗、故障电阻、负荷电流以及分布电容的影响。
Industry trends lean toward lower output voltages, more power, tighter power regulation, and faster response to changes in load current.
业界之发展趋势是要求更低的输出电压、更大的功率、更有效控制电源、以及对负载电流的转变有更快速的反应。
TEA1061 Pinout: Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
TEA1061引脚说明：注4：负载电流静态电流增加，是指以地积比iload速冻。
Here introducing the way that when the bus energral to use the load current to simulate the busbar fault so as to check the problem of circuit and to correct and solve it.
介绍了在母线不停电情况下，利用负荷电流模拟母线故障检查保护回路存在的问题。
Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
注4：负载电流静态电流增加，是指以地积比iload速冻。
Figure 3: LM5113 evaluation board efficiency versus load current at different input voltages.
图3：lm 5113评估板效率与负载电流不同的输入电压。
The results clearly show conduction losses are the function of semiconductor static characteristic, power factor, modulation depth and load current.
该表达式与器件静特性、功率因数、调制度及负载电流有关，利用其计算不同载波调制下通态损耗时只需改动导通占空比。
The results clearly show conduction losses are the function of semiconductor static characteristic, power factor, modulation depth and load current.
该表达式与器件静特性、功率因数、调制度及负载电流有关，利用其计算不同载波调制下通态损耗时只需改动导通占空比。
应用推荐