The volume of liquid inlet chamber is increased through the rotation of push rod, and the polymer liquid enters through the self pressure.
通过推杆的旋转使进液腔的体积增加，聚合物溶液通过自身压力进入。
The complex pump body in the pump is fabricated by that a pump body, a whorl casing, a liquid inlet pipe, and a cover plate are assembled.
泵中复杂泵体由泵体、涡壳、进液管及盖板等部分组装而成。
Both fluid liquid inlet and outlet are equipped on each gland, which connect to the fluid liquid channels for the frame and the cylinder sleeve through the port plates.
端盖上各有一个流体进出口，经过配流盘与机体的配流通道及缸套的流体通道相通。
The model was used to analysis the effect on the drop diameter when the primary velocity of the air or the relative position between the air inlet and liquid inlet was changed.
分析气流速度、液孔与气孔的相对位置对雾化滴径的影响，模拟结果与实验结果基本一致。
When in use, the indicating pointer of a valve plate is rotated to point to some branch pipe on the dial plate, and the liquid of the liquid inlet main pipe flows to the branch pipe.
使用时，转动阀盘指针对准刻度上的某一支管，进液主管的液体就流向该支管。
A separator capable of bearing the pressure is comprised, and a liquid inlet, a light component outlet, a heavy component outlet and an automatic regulating valve are arranged on the separator.
包括可承受压力的分离器，分离器上设置液体进口、轻、重组分出口以及自动调节阀。
The utility model discloses a centrifugal type filter applied to a dry cleaning machine, which mainly comprises a barrel body and a liquid inlet arranged on the lower side part of the barrel body.
本实用新型公开了一种可应用于干洗机中的离心式过滤器，其结构主要包括：桶体，在桶体的下侧部设置有进液口；
When a cylinder with this valve configuration is in the upright position, the inlet of the tube is immersed in liquid and the liquid phase will be removed.
当带有这种阀门配置的钢瓶处在垂直位置时，管子的入口浸在液体中，就可以提取液相产品。
Moreover this gradual contraction inlet may translate some pressure energy of liquid into kinetic energy and increase circumrotate speed. These play active actions on improving separation efficiency.
同时这种渐缩式入口方式，可将来液的一部分压能逐渐转化为动能，提高了旋流速度，对提高分离效率起到积极作用；
The article focuses on two ways to determine friction factors of the capliliary tube without backheating which inlet refrigerant is subcooling liquid.
本文针对无回热且进口处制冷剂为过冷液体的节流管介绍确定其沿程阻力系数的两种方法。
Liquid crystal display showing temperatures of outlet and inlet chill water-provides visualized and direct setting.
屏幕同时液晶显示冷水出口、冷水入口和设备设定温度。
Liquid enters the primary impeller through an inlet of the pump casing, foams mixed in the liquid are crushed and separated out under the action of the impeller.
液体通过泵壳体进口进入主叶轮，在叶片的作用下把混合在液里中的泡沫打碎并分离出来。
Hot gas Bypass Valve designed to allow only gas no liquid - to inlet of refrigerant compressor.
热气旁路阀设计，只允许任何液态气体-以进口制冷剂的压缩机。
The cooling liquid tank is also equipped with an inlet, the inlet is connected with the outlet of the dry washer.
冷却液箱上还有进口，该进口与干洗机的出水口相连。
Temperature difference between inlet and outlet reduces as liquid flux increasing.
随着液体流量的增大，滴滤塔的进出口温差减小。
If the grain size distribution of suspending liquid at inlet is identical, the change of inlet pressure and underflow port diameter can influence the separation efficiency.
在进料口悬浮液固相颗粒粒级分布相同的情况下，进料口压力和底流口直径的变化同样对分离效率产生影响。
The inlet structure and the level of machining accuracy is one of the key factors which decide the separation and using performance of the liquid-liquid separation hydrocyclone.
入口结构形式及加工精度的优劣是决定液—液分离水力旋流器分离性能及使用性能的关键因素之一。
Inlet valve and seat, due to open and close more frequently, the liquid flow rate is high, sealing will soon expire.
进液阀芯和阀座，由于开启关闭比较频繁，液体流速高，密封很快就会失效。
Vapor-liquid heat exchangers are often used to superheat the suction vapor of compressor and to subcool the inlet liquid of throttle valves in refrigerating system.
制冷循环中往往采用回热器，使压缩机吸气过热和膨胀阀入口液体过冷。
And first law efficiency of testing result also shows a maximum value for certain evaporating pressure. The reason is the gas-liquid two-phase at the expander inlet under high pump frequency.
循环第一定律效率随着蒸发压力的增加也存在最大值，其原因是由于较高压力和流量下膨胀机入口存在汽液两相现象。
If liquefied gas is to be withdrawn, the bottom of the cylinder must be elevated above the valve to allow the liquid phase to be in contact with the valve inlet.
如果要提取液化气体，必须把钢瓶底部提高到阀门以上，使液相同阀门入口相接触。
Whereas, the heat transfer of turbulence liquid film flow is not sensitive to liquid film inlet temperature.
湍流时，热量传递对液膜进口温度的反应不如层流敏感。
The experimental results show: firstly, the concentration of the concentrated sulfuric acid increases with increased inlet air flux, increased intet air temperature and decreased inlet liquid flux;
实验研究表明：硫酸浓缩液浓度随空气进口温度的升高、空气进口流量的增大以及稀硫酸进口流量的减小而增大；
The volumetric mass-transfer coefficient in packing increases with gas flow rate and rotating speed raises. Liquid flow rate and concentration of SO2 in inlet gas influences less on it.
转速和气体流量对旋转床填料层内的体积传质系数影响较大，流体流量和气相中二氧化硫浓度影响不大。
The volumetric mass-transfer coefficient in packing increases with gas flow rate and rotating speed raises. Liquid flow rate and concentration of SO2 in inlet gas influences less on it.
转速和气体流量对旋转床填料层内的体积传质系数影响较大，流体流量和气相中二氧化硫浓度影响不大。
应用推荐