This is zero. So again, in the ideal liquid mixture case, their molecules aren't interacting.
这是零，又一次，在理想液体混合物的情况下，它们的分子没有相互作用。
Of course, in the case of the ideal liquid mixture, there's no energetic interaction.
当然，在理想液体混合物的情况下，没有能量相互作用。
In some respects, the quark-gluon matter looks familiar, still the ideal liquid seen at RHIC, but we're also starting to see glimpses of something new.
从一些方面看，夸克——胶子物质看上去非常眼熟，和相对论重离子对撞机的理想液体一样，但我们还从中得以发现一些新的东西。
And in general, if we're going to deal with relatively small deviations from the ideal liquid mixture, the ideal solution, then we can start with a model like this.
通常，如果我们要，处理的相对于，理想液体混合物，理想溶液相差不多，那么我们可以从这样的模型开始。
So if we have an ideal gas, and certainly if we're going to assume an ideal liquid mixture, we can safely assume that it's an ideal gas above it.
那么如果我们有理想气体，当然如果我们设想，理想液体混合物，我们就能放心地，假设上面是理想气体。
在理想液体混合物中。
And this difference is what's going to determine how far the liquid mixture will deviate from the ideal solution case.
这个不同将决定，液体混合物与理想溶液的情况，会偏离多远。
What you saw is that in simple or ideal liquid mixtures, a result called Raoult's law would hold.
在简单或理想液态混合物中，会有一个叫拉乌尔定律的定理。
在理想的液体混合物中。
This paper, by referring to the "ideal liquid", proposed the viscous hydraulic design methods under the conditions of water-moving border of viscous layer of border.
提出了把“理想流体”作为参照量，以粘性边界层作为水流动边界条件的粘性水力设计方法。
In general, the saturated stream is regarded as the ideal gas for calculating the heat of gasification for the saturated liquid.
计算饱和液体的气化热通常是把该温度下的饱和蒸汽视为理想气体。
For pouring cup iron level control system, three segment controls are adopted according to three mathematics model of the ideal liquid curve in pouring cup.
对于浇口杯液位实时控制系统，根据浇注过程中浇口杯理想液位曲线的三段数学模型采用分段控制的方法。
This essay, by referring to the "ideal liquid" proposes the viscous hydraulic design methods under the conditions of water-moving border of viscous layer of border.
提出了把“理想流体”作为参照量，把粘性边界层作为水流动边界条件的粘性水力设计方法。
Conclusion BCD mixture is safe and is an ideal liquid embolic mixture.
结论：BCD合剂栓塞血管安全有效，是一种较为理想的液体栓塞剂。
These features make the EL5221 ideal for use as voltage reference buffers in Thin Film Transistor Liquid Crystal Displays (TFT-LCD).
上述特点使得作为在薄膜晶体管液晶显示器(TFT - LCD)的参考电压缓冲器的使用EL5221的理想选择。
The Neutral Beam Injection (NBI) system requires a clean high vacuum environment. The liquid helium cryocondensation pump with high pumping speed is an ideal vacuum obtain device.
中性束注入系统要求有洁净的动态高真空环境，大抽速液氦冷凝泵是满足此要求的理想真空获得设备。
It is an ideal equipment to change material direction of liquid crystal and powder material in conveying system.
作为固体晶粒、粉状物料输送系统中改变物料流向的理想设备。
Electrons on the outer surface of liquid helium form a nearly ideal two-dimensional electron system.
液氦外表面上的电子层构成一个近理想二维电子系统。
The ideal model of liquid chromatography in gradient elution was solved by using the characteristic approach on the assumption of a linear solvent strength model.
基于线性溶剂强度模型，应用特征线分析的方法求解梯度洗脱模式下的理想液相色谱模型。
Some illustration showed it is a new type of the ideal instrument, used in measure of liquid level under rigorous circumstances.
并结合应用实例表明它是在恶劣环境下检测液位的一种新型理想的仪表。
The double layer of liquid crystal system are mix structure of non linear, non ideal and non equilibrium.
膜系统的液晶态双层相是非线性非理想非平衡态的混合结构。
Low power rate on the surface of heating tube. Medium does not scale, congeal, sinter or carbonize on the surface, and so is ideal heating element for viscous, and heat sensitive liquid medium.
加热器管表面功率负荷低，介质不会在表面结垢、粘结、烧焦、碳化等，是粘性、热敏性液体介质加热的理想元件。
The utility model has the characteristics of small power consumption, safety, long service life, small volume and accurate rotate speed and is an ideal liquid (or gas) stirrer.
本实用新型具有功耗低、安全、使用寿命长、体积小、转速准确的特点，是一种较理想的液体(或气体)搅拌器。
Through analysis of the coupling problem between structure and ideal liquid, some researches were done on the dynamic responses of solid liquid coupling system using FEM.
通过对结构与理想流体耦合问题的分析，利用有限元方法对流固耦合系统动力响应进行了研究。
It is the ideal equipment in the pipe system adjusting or cutting liquid medium.
是管道系统中对流态介质进行合理调节或切断的理想设备。
The theoretical analysis and the finite element formulation are based on the assumption that liquid in the tank is an ideal fluid and the liquid flow in the tank is irrotational.
理论分析与形成有限元公式所作的基本假设是罐内液体为理想流体以及它的流动是无旋的。
Based on the study of the microscopic flow mechanism of liquid in packed column, a zone-stooge model is proposed, by which the efficiency of the column is simulated in the non-ideal flow state.
本文探讨了填料塔中液体微观流动机理，提出了多区多级模型，对填料塔在非理想流动状况下的塔效率进行了模拟。
Thus the lamellar liquid crystal system appears to be the ideal medium to acquire more MB monomers.
表明层状液晶体系是获取更多MB单体的理想介质。
This product uses the advanced fever to make the technology, use liquid gas reducing flame hard fire, is the ideal environmental protection product.
该产品采用先进烧造技术，利用液化气还原焰高温烧成，是理想的环保产品。
The packing has high extraction efficiency and low capacity, and is one ideal kind of liquid-liquid extracting packing.
该填料萃取效率高，容量低，是一种较为理想的液液萃取填料。
应用推荐