Lifting platform mechanical press is a device designed for the application of very high force form, shape or cutting material, compression of solid, or liquid extraction.
升降平台机械压力机是一种装置设计的应用非常高的力的形式，形状或切割材料，压缩的固体，或液体提取。
During the pumping cycle the gas is in intimate contact with the sealing liquid and compression is nearly isothermal.
在抽运周期内，气体会与密封液和几乎等温的压缩气体紧密接触。
Due to compression process influence the air dew point of compressed air in the pipeline, run it will gradually decrease temperature, so the compressed air system always have liquid water.
由于压缩过程影响空气的露点，压缩空气在管线中运行时温度会逐渐降低，所以压缩空气系统中总是有液体水存在。
The liquid hydrocarbon recovered from casing head gas by adsorption, compression, or refrigeration. Casing head gas is the gas recovered at the surface from an oil well.
通过吸附作用、压缩作用或冷却作用，从套管头气回收到的液态烃，为一种汽油。套管头气是从地面上的一口油井所采到的气体。
The elastic plastic buckling analysis is completed on bucking load and buckling mode of thin wall cylindrical shells fully filled with liquid under axial compression.
对充满液体的薄壁圆柱壳经受轴向压缩时的屈曲载荷和屈曲模态进行了弹塑性屈曲分析。
After OG sludge was added to pelletizing mix , the liquid bonding phase appeared in pellet, so the pellet compression strength was increased greatly.
添加OG泥后，球团矿中出现了液相固结，球团矿抗压强度因此而大幅度提高。
Air in its liquid state, intensely cold and bluish, obtained by cooling and compression.
液态空气：处于液体状的空气，呈蓝色，极度冰冷，通过冷却和压缩而成。
The structure of saturated porous body with low permeability deforms under uniaxial compression load and the liquid in porous is compressed also.
低渗透率饱和岩石受单轴压力作用时，由于其本身结构的变形，使得孔隙的液体也受压。
The isothermal compression behaviors of MgCu-Y7Nd bulk amorphous alloy nearby the glass transition temperature (Tg) and at temperature in the supercooled liquid region are observed.
研究了MgCuY7Nd大块非晶合金在玻璃转化温度Tg附近及深过冷液相区的等温压缩变形行为。
The temperature reduces with the vapor vaporizing and the discharge vapor saturated. Water is refrigerant and cooling liquid in the special wet compression.
在系统中，水既为制冷剂又为冷却剂，这种压缩是一种特殊的湿压缩方式。
The content of the suspended substance in the upper layer and the liquid-solid compression ratio of the bottom layer were measured.
测试了沉降上层澄清水悬浮物含量，以及沉降底层的压缩液固比。
The influences of strain rate, liquid volume fraction and liquid viscosity on the deformation force of semi solid compression of metals between two parallel plates were investigated according to…
结果表明 ，液体粘度对变形力几乎没有影响 ，变形力随轴向应变速率绝对值的增加而增加 ，随液体体积分数的增加而明显减少。
The influences of strain rate, liquid volume fraction and liquid viscosity on the deformation force of semi solid compression of metals between two parallel plates were investigated according to…
结果表明 ，液体粘度对变形力几乎没有影响 ，变形力随轴向应变速率绝对值的增加而增加 ，随液体体积分数的增加而明显减少。
应用推荐