Powder can be spread onto a tray and then solidified in the required pattern with a squirt of a liquid binder or by sintering it with a laser or an electron beam.
将粉末洒向一个托盘，然后用一小盘液体粘合剂把粉状物按需要的形状进行固化，或者用激光器或电子束管将其烧结成所需形状。
The possibility of forming connection rods of engines by "warm pressing and liqUid phase sintering on boundary of particles " is explored in theory and experimentally.
通过理论和实践分析，探讨了采用“温压技术和颗粒界面液相烧结技术”生产发动机连杆（典型零件）的可能性。
The material is never fully molten, although there might be a small volume fraction of liquid present during the sintering process.
该材料是永远不会完全熔化，虽然有可能是一个体积小，液体目前在烧结过程中的一小部分。
Steel-bonded cemented carbide powder processed by explosive compaction was successfully bonded to the surface of carbon steel through liquid phase sintering.
采用液相烧结法将爆炸压实后的钢结硬质合金粉末复合在碳钢表面，成功获得覆层材料。
The liquid synthesis of nanocrystals titania at low temperature, due to avoiding the sintering process, brings superior physical and chemical properties.
低温液相合成晶态纳米二氧化钛由于避免了高温煅烧过程，可望赋予其更优越的特性。
Extracting alumina from coal refuse, sintering cement clinker directly from residues and circulating waste gas and liquid is a unusual technology for utilization of coal refuse.
从煤矸石中提取氧化铝，并用残渣直接煅烧硅酸盐水泥熟料，同时作废气、废液循环，是煤矸石资源开发利用的新工艺。
The sintering type of the billet is an instaneous sintering with a little quantity of liquid.
表面复合层压坯的烧结形式是小液相量瞬时液相烧结。
Liquid content had great effect on the sintering, the more liquid contained, the faster the sintering rate obtained.
液相含量对致密有明显影响，液相量越高，烧结速率越快。
WC steel-bonded cemented carbide powders being compacted by explosive compaction were bonded to the surface of carbon steel using liquid phase sintering.
采用液相烧结法将爆炸压实后的WC钢结硬质合金粉末复合在碳钢表面，对不同烧结温度下的界面组织和抗剪强度进行了研究。
Ternary boride based cermet cladding material was prepared by in situ reaction and liquid phase sintering technology in vacuum furnace.
在真空烧结炉中通过原位反应液相烧结工艺制备出三元硼化物基金属陶瓷覆层。
The liquid phase sintering process of steel based carbide - iron bimetal composite was researched.
研究了液相烧结钢结硬质合金-铁双层复合材料的生产工艺。
The scanning electron microscope analyses proves that the bonding mechanism of this process is liquid phase sintering, the change of surface freedom energy is the motivity for sintering.
扫描电镜分析证实，此复合粉末体系的激光烧结是基于液相烧结机制，表面自由能的改变是其烧结的原动力。
The results indicated that the composites were densified primarily through liquid phase sintering.
结果表明，复合材料主要是通过液相烧结而得到致密化的。
The liquid phase sintering model was discussed to explain the experimental result.
本文运用液相烧结模型对实验结果进行了探讨。
Mullite - cordierite composites with various mullite contents and microstructures were prepared by liquid phase sintering and by hot pressing.
由热压和液相烧结方法制得了具有各种莫来石含量和显微结构的莫来石—堇青石复合体。
The results show that the liquid phase sintering necessary for coating stability can be realized by gradient designing, the viscous flow of ordinary liquid ph...
结果表明，采用梯度设计可实现涂层稳定成形所需的液相烧结，避免了常规液相烧结时涂层的粘弹性流动。
The effect of electrocast zirconia and monocline zirconia and two types of binders(anhydrous and un-hydroxyl resin and liquid paraffin)on the sintering of fired magnesia-calcia brick are investigated.
研究了电熔氧化锆、单斜氧化锆和两种结合剂（无水无羟基树脂和液体石蜡）对烧成镁钙砖烧结性能的影响。
Steel-bonded cemented carbide powder mixture(TLMW50) processed by explosive compaction was successfully bonded to the surface of carbon steel through liquid phase sintering.
采用液相烧结技术成功地将爆炸压制后的钢结硬质合金混合粉末（对应国家牌号TLMW50）复合在碳素钢的表面。
And WC grains are grown up based on the grain rotation combination mechanism and local liquid-phase sintering in the early stages of sintering.
烧结早期WC晶粒长大是在晶粒旋转合并机制与局部液相烧结机制共同作用下完成。
The coating with high bond strength was synthesized by means of treatment of the gradient liquid phase sintering or medium temperature reactive sintering.
通过梯度液相烧结或中温反应烧结处理，热喷涂层具有很高的结合强度。
A ternary boride cermet clad material was fabricated on the Q235 steel substrate by means of the vacuum liquid phase sintering technique.
采用真空液相烧结法，在Q 235钢表面制备三元硼化物基金属陶瓷覆层材料。
The new PM technology has been introduced, such as superfine powder manufacture, rapid solidification processing, mechanical alloying, liquid phase sintering, rapid consolidation etc.
本文叙述了新的PM技术如超细粉制造技术、快速凝固制粉技术、机械合金化技术、液相烧结技术、快速固结技术等。
The experiment results are explained based on the theory of liquid-phase sintering and the model of Schottkey barriers.
依据液相烧结理论和双肖特基模型对实验结果进行了讨论。
The sintering of the dopedbariumtitanate include solid-solid sintering and solid-liquid sintering.
掺杂钛酸钡陶瓷的烧结包括固-固烧结和液-固烧结。
The paper summarizes the effect of additives on the liquid phase sintering behaviour of the compact of austenitic stainless steel powder and the properties of resultant material.
综述了添加元素对奥氏体不锈钢粉末压坯液相烧结行为及材料性能的影响。
The results of experiment have been explained based on the theory of liquid-phase sintering and the model of Schottkey barriers.
依据液相烧结理论和双肖特基模型对实验结果进行了解释。
The mechanical properties of a tungsten heavy alloy were found mainly dependent on the particles size of raw tungsten powders and liquid-phase sintering temperature.
液相烧结态钨合金的力学性能主要与原始钨粉粒度及烧结温度有关。
Steel-bonded cemented carbide powders being compacted by explosive compaction were bonded to the surface of carbon steel using liquid phase sintering.
采用液相烧结技术成功地将爆炸压制后的钢结硬质合金粉末复合在碳素钢的表面。
Sintering, cooling high-voltage motors used starting current impact of small, smooth transition of liquid resistance buck starter.
烧结，冷却高压电机采用起动电流冲击小，过渡平稳的液态电阻降压起动。
The results showed that phosphate bioglass binder could form liquid phase to promote the materials sintering and reduce the sintering temperature.
结果表明磷酸盐生物玻璃粘接剂能形成液相而促进材料烧结，降低烧结温度。
应用推荐