The Linux strace program lets you trace all the system calls that an application makes.
Linuxstrace程序允许您跟踪应用程序做出的所有系统调用。
Scenario 2 uses the strace utility in Linux that enables the tracing of system calls and signals to identify where a program is failing.
在第 2种情况中，我们使用了Linux 中的strace实用程序，它能够跟踪系统调用和信号，从而找出程序发生错误的地方。
The Linux install program will build all drivers needed into the initrd image so the Linux system can easily load the device drivers during boot.
Linux安装程序将把需要的所有驱动器构建到initrd映像中，以便Linux系统可以在启动时轻松地载入设备驱动器。
This entry USES an ext3 file system, which is supported in Linux kernel versions 2.4.16 and higher, and the order for file system check (FSCK) program is set to 2.
该条目使用一个ext3文件系统，这种文件系统在2.4.16版或更高版本的Linux内核中均受支持，文件系统检查(fsck)程序的顺序被设为2。
Wool and graduate student Ohad Ben-Cohen designed their two-phase program as a new line of defense for the Linux operating system.
Wool教授和研究生Ohad Ben - Cohen设计的两阶段程序作为防护Linux操作系统的一个新方向。
A value of 1 (for the Linux exit system call) is stored in EAX to request that the program exit.
EAX中存储的值是1（代表Linuxexit系统调用），这请求程序退出。
The main reason on a UNIX or Linux system is that the program was transferred in binary mode.
在UNIX或Linux上，主要原因是程序以二进制模式传输。
This sector contains a program called loader (for Linux it is usually LILO or GRUB); this actually boots the operating system.
此扇区包含名为loader的程序(对于Linux，它通常是LILO或GRUB)；实际上是此程序引导操作系统。
The hardware structure is given, relevant driver design under the embedded LINUX operating system and application program design are described.
给出了系统的硬件结构，描述了嵌入式LINUX操作系统下相关驱动程序的设计和系统应用程序的设计。
Last, the control software which includes driver program and application program are developed based on embedded operation system Linux.
控制器硬件包括通信模块、驱动模块、输入输出模块等，是在嵌入式系统基础上完成的。
Last, the control software which includes driver program and application program are developed based on embedded operation system Linux.
控制器硬件包括通信模块、驱动模块、输入输出模块等，是在嵌入式系统基础上完成的。
应用推荐