Smoothing curve method of plugging line inside triangle in the article is one of the plugging dots spline curve methods.
本文讨论的三角形内插线曲线光滑函数属于插值样条型的曲线光滑方法。
When fitting each contour line, the points measured by non - contact measuring system are as the top points about control polygon for forming EE spline curve.
在拟合每个轮廓线时，先用非接触测量系统测出的数据反算出ee样条曲线控制多边形的顶点。
Based on experimental data of engine, torque and oil consumption model of engine are established by method of spline interpolation. The optimum economy and power operation line of engine is obtained.
在实验数据基础上，利用三次样条插值构造了发动机转矩和油耗数学模型，确定了最佳经济性与最佳动力性工作线。
Then, focused on off-line interpolation calculation and the speed planning, the linear interpolation, circular interpolation, extended line interpolation and spline interpolation are discussed.
首先分析了离线轨迹规划的思路和策略，然后重点讨论了构成轨迹规划的两大核心技术：离线插补计算和速度规划。
Taking the rocker arm of trailer concrete pump as a typical example, application of nc electric-spark line-cutting to female spline machining is described.
以混凝土拖泵中的典型零件——摇臂为例，介绍数控电火花线切割在内花键孔加工中的应用。
If the normal section in the center of the tooth line is taken as a tooth measuring and design section, when spline hob is designed in a plane meshing, the tooth profile error is minimum.
如果以齿纹中点法剖面作为齿形检测和设计剖面，用平面啮合法设计花键滚刀时，则齿形误差最小。
If the normal section in the center of the tooth line is taken as a tooth measuring and design section, when spline hob is designed in a plane meshing, the tooth profile error is minimum.
如果以齿纹中点法剖面作为齿形检测和设计剖面，用平面啮合法设计花键滚刀时，则齿形误差最小。
应用推荐