In a network that may span multiple IP subnets, you may want to limit which servers are responsible for handling queries to a specific subnet to allow for the load to be spread among multiple servers.
在可能跨越多个ip子网的网络中，您可能希望限制哪些服务器负责处理针对特定子网的查询，以允许在多个服务器之间分配负载。
Adjusting the Load Interval (the frequency of SNMP polling) will further limit this impact.
调整LoadInterval (SNMP轮询的频率)将进一步限制这种影响。
Performance analysis conducted at that load indicates that the XPages runtime itself did not limit the scaling of concurrent users on this application.
在此负载水平上的性能分析显示，XPages运行时本身不限制应用程序并发用户的增加。
The final test occurred Apr. 21 when the wing and trailing edges were subjected to their limit load of around 2.5g, the highest loads expected to be seen in service.
根据4月21最终试验的结果，机翼和后缘的承受的极限负荷为2.5g左右，而实际最高负荷只能在实际服役的时候才能知道。
The limit load of a defective cylinder is a very important input in a structural integrity assessment of a pressure vessel or pipe using R6 type procedure.
在使用R 6方法的压力容器和管道结构完整性评估过程中，含缺陷圆筒的极限载荷是一个非常重要的输入参量。
Analysis and comparison between the finite element analysis and experiment results for stress intensity factor, limit load, and flexibility factor were performed.
从应力系数、极限载荷和柔度系数三个方面对有限元计算结果和试验结果进行对比分析。
Its efficiency was demonstrated by computing the limit load factor and the collapse state for some plane stress and plain strain problems.
通过计算平面应力和平面应变问题的极限荷载因子和相应的坍塌机构，验证了算法的有效性。
The failure plane and then the limit load are calculated by overloading analysis.
利用大坝超载分析寻求破坏面，从而得出破坏的极限荷载。
Based on the deformation theory of linear hardening materials, a simplified finite element analysis method is proposed to calculate the limit load of structures.
基于线性硬化材料形变理论，本文提出了一种计算结构极限载荷的有限元简化算法。
At last a numerical method to obtain the limit load of structure is given.
最后提出了一种求解结构极限荷载的数值方法。
For simply supported annular plate under linear load, the limit load analysis was investigated by applying unified strength theory.
对于线性荷载作用下外简支环板，引入统一强度理论，进行了极限荷载分析。
Based on the minimum curvature radius definition and mid value theorem, the pape gives the method of determining the limit load of pile foundation through extreme value analysis.
文章根据最小曲率半径定义和中值定理，通过极值分析方法来确定桩基极限荷载。
The limit load of local thinning elbow is different from the straight pipe.
局部减薄弯头与直管的极限载荷不同。
The limit load calculation of welding piping tees under the action of the in plane bending moment was derived based on the limit analysis.
基于极限分析的观点，推导了工业中焊制三通在面内弯矩作用下的极限载荷估算式。
This paper presents a new method to calculate the limit load of thick wall cylinder and thick wall spherical shell based on Yus Unified Strength Theory and a Unified solutions are obtained.
采用俞茂宏统一强度理论分析了厚壁圆筒和厚壁球壳的极限荷载，得出了统一解形式。
The analysis and contrast of deformation pattern, state of stress, plastic deformation history, plastic limit load and limit load of elastic buckling are analyzed and contrasted.
最后对三种结构型式的拱顶储罐的变形方式、应力状态、塑性变形历史、塑性极限压力、弹性失稳临界压力进行了分析与对比。
Analysis and comparison between the finite element analysis and experiment results for stress concentration factor, limit load, burst pressure and failure location were performed.
从应力集中系数、极限压力、爆破压力和爆破失效位置四个方面对有限元计算结果和试验结果进行对比分析。
It plays a significant role in the analysis of pressure vessel and design of pipes that limit load is adopted as an important parameter to reflect bearing capacity of the structure.
将结构的极限载荷作为反映结构承载能力的一个重要参量，在压力容器及管路的分析设计中具有重要的意义。
Certain perceptual knowledge to critical load, limit load, waveforms redistributing, which all belong to the stiffened panel with initial defects, have been got.
对带有初始挠度加劲薄板的临界载荷、极限载荷、波形的重新分布有了一定的感性认识。
The approximate formula for limit load is found when the fraction angle is less than the half conical one.
在摩擦角小于半锥角的情况下，给出了极限承载能力的近似计算公式。
In this paper the reason and criterion of the application of the model to plastic limit analysis are discussed, and an algorithm of computing plastic limit load is given.
文中讨论了该模型适用于全塑性分析的机理和判据，还设计了一个确定塑性极限载荷的算法。
In this paper, the method of asymptotc for structural limit analysis is proposed by the high limit theorem for limit load.
本文根据极限荷载的上限定理，提出了结构极限分析的递近法。
Moreover, these limit load formulae can provide reference for the engineering designeers.
所给出的极限载荷公式可供工程设计人员参考。
Under just one loads of internal pressure, this article calculates plastic limit load and studies the law of changes with influential factors.
在内压荷载作用下计算了含半椭圆裂纹厚壁弯管的塑性极限荷载并研究了其随影响参数的变化规律。
A new method to determine the limit load of reinforced concrete deep beam when sheared was presented by upper-bound method based on reinforced concrete plasticity theory.
本文以钢筋混凝土塑性理论为基础，用上限方法确定了钢筋混凝土深梁剪切破坏时的极限荷载的计算方法。
The research contents and results were as follows:(1) With FEA method, the effects of various groundsill character, pedestal angle and ground pressure on the limit load of buried pipe were studied.
通过有限元计算分析，研究了不同地基性质、支座包角和地面载荷对埋地管道极限载荷的影响。
Coupling beams' yielding load and limit load also was enhanced when more diagonally reinforcement was included.
连梁的屈服荷载和极限荷载均随纵向钢筋配筋量的增加而增大，随斜筋配筋量的增大亦增大。
When the tensile strain reaches the limit load, the force of tension suddenly becomes very small, because clusters structures change.
当拉伸应变达到承载极限，继续拉伸，力突然变的很小，这是因为团簇发生了结构变化。
When the tensile strain reaches the limit load, the force of tension suddenly becomes very small, because clusters structures change.
当拉伸应变达到承载极限，继续拉伸，力突然变的很小，这是因为团簇发生了结构变化。
应用推荐