The method then checks to see if the length value is less than or equal to 127.
然后这个方法检查长度值是否小于或者等于127。
Therefore, the number of bytes required in multi-byte format depends upon the length value.
因此，在多字节格式中所需要的字节数取决于长度值。
If the length value is greater than 127, I have to use multi-byte length notation, which USES at least 2 bytes of data.
如果长度值大于127，那么我必须使用多字节长度表示法，它至少使用2字节数据。
Therefore, if the length value is between 0 and 127, I can simply perform a bitwise and operation between the length and 0xff.
因此，如果长度值在0到127之间，那么我可以只执行该长度与0xff之间的一个按位AND操作。
I continue dividing the length value by 256 and incrementing the byte counter until the result of division yields a value less than 1.
我继续将长度值除以256并增加字节计数器，直到除得的值小于1。
The results of optometry, axial length value and the retinal change indicated the diagnosis of pathological myopia.
医学验光结果的变化、眼轴长度的变化、眼底表现符合高度近视的诊断。
This length value is set in the local environment, as shown in Listing 1 below, and it dynamically controls the following TCPIPClient Receive node.
该长度值在本地环境中设置，如下面的清单1所示，它将动态控制以下TCPIPClient Receive节点。
If the length value is less than 256, I will need a total of 2 length bytes — 1 byte to indicate that there is 1 more length byte and 1 byte to hold the actual length value.
如果长度值小于256，那么就需要总共2个长度字节——1个字节表明还有一个长度字节，1个字节包含实际的长度值。
If the length value is less than 256, I will need a total of 2 length bytes — 1 byte to indicate that there is 1 more length byte and 1 byte to hold the actual length value.
如果长度值小于256，那么就需要总共2个长度字节——1个字节表明还有一个长度字节，1个字节包含实际的长度值。
应用推荐