In the case of FDDI, the FC field is placed in the Least Significant Byte of this field.
在FDDI的情况下，FC字段被放置在这个字段的最低有效字节中。
Little-endian means that the least significant byte has the lowest address (the word is stored little-end-first).
而little -endian意味着最低位字节存储在最低地址(按低位优先的顺序存储字)。
Encoding ELFDATA2LSB specifies 2's complement values, with the least significant byte occupying the lowest address.
ELFDATA2LSB编码指定了2的补数值，最小有意义的字节占有最低的地址。
When you cast the integer into a single byte, only the least significant byte (0x00 to 0x7f) will be copied as a hex value to the single-byte array.
将这个整数造型为一个单字节时，只有最低有效位字节（0x00到 0x7f）会作为十六进制值拷贝到单字节数组。
Big-endian means that the most significant byte is stored at the lowest memory address and the least significant byte is stored at the highest memory address.
Big -endian是将高位字节存储在内存的低地址中，将低位字节存储在内存的高地址中。
Little-endian means that the least significant byte is stored at the lowest memory address and the most significant byte is stored at the highest memory address.
Little - endian是将低位字节存储在内存的低地址中，将高位字节存储在内存的高地址中。
Basically, the first word is the preferred word, and then the other alignments are on the least-significant byte or halfword of that word.
基本上，第一个字就是首选字，而其他字对齐到最低有效字节或半字上。
Count the number of ones in each byte of the 8-byte block; if the number of ones is even, make it odd by setting the least significant bit to one.
统计8字节块中每字节中的1的个数，如果1的个数为偶数，那么就设置最低位为1使它成为奇数。
That is to say, on the x86 system, the least-significant byte (the smallest values) are stored in the first byte of ll; on the Power Architecture system, they're stored in the last.
这就是说，在x86系统上，最低位字节(最小值)首先存储在ll的第一个字节中；在PowerArchitecture系统上，它们则存储到最后。
If the number of ones in a byte is already odd, you will set its least significant bit to a zero.
如果一个字节中1的个数已经为奇数，那么就将它的最低位设置为零。
Remember, the LQD instruction only loads from 16-byte boundaries. It will therefore ignore the four least significant bits during the load, and just load an aligned quadword from memory.
记住，lqd指令只能从16字节边界加载，所以它会在加载期间忽略最低有效的四位，而只会从内存加载已对齐的四字。
The least significant bit of the cmd byte is the phase indicator, which is used to differentiate a new command from the retransmission of an old one.
命令字节的最小位是相位指示器，是用来区分一个新的命令还是老命令的重传。
The least significant bit of the cmd byte is the phase indicator, which is used to differentiate a new command from the retransmission of an old one.
命令字节的最小位是相位指示器，是用来区分一个新的命令还是老命令的重传。
应用推荐