The high-aspect-ratio flying wing eliminates vertical tail and conventional rudder, and uses instead a split drag rudder with large deflection as its directional control surface.
大展弦比飞翼布局飞机取消了垂尾和常规方向舵，通常采用大偏角的开裂式方向舵作为偏航操纵面。
The effect of large deflection on the initial equilibrium configuration is studied.
讨论了斜拉桥几何非线性对初始平衡构型的影响。
A research method of the large deflection of the throttle slice of the hydropneumatic spring was presented.
提出了一种研究油气弹簧环形阀片大挠曲变形的方法。
The numerical examples in this paper show that the method can be used to analysis large deflection of space trusses.
计算表明本文方法可以有效用于空间桁架结构大位移问题分析。
The approach is based on large deflection characterisation of a curved beam, coupled with fracture mechanics concepts.
该方法是基于曲梁大变形理论及断裂力学而提出来的。
Comoving coordinate system and incremental process are adopted and the effect of large deflection on loads is also discussed.
采用拖带座标系和逐步增量法。还讨论了大挠度对载荷的影响。
This paper presents a new solution of the large deflection dynamic response of stiffened plates under lateral impact loading.
用半解析的方法分析了横向冲击载荷下加筋板的非线性瞬态响应。
A new approach to the solution of large deflection bending problem of thin plates is presented by using boundary element method.
本文提出一个用边界元法求解薄板大挠度弯曲问题的新途径。
The high specific weight tungsten alloy material has good plasticity, large strength, large deflection and small residual force.
本发明高比重钨合金材料塑性好、强度大、变形量大及残余力小。
We investigate the effect of nonlinear curvature on vibrations of an elastic simple supported beam and roller with large deflection.
本文研究由于大挠度引起的曲率非线性对简支梁振动的影响。
The development of flexure hinges with large deflection, low stress, small parasitic center shift has always been a difficult problem.
大变形、小应力、小中心漂移的柔性铰链的研制一直是柔性铰链研究的难题。
A position detection system is incorporated into a parallel plate interferometer in order to realize large deflection Angle measurement.
为了实现较大的偏转角度测量，该平行平板干涉仪引入了一位置探测系统。
The strain distribution based on small and large deflection theories of diamond square diaphragm was studied using theories of plate bend.
采用薄板弯曲理论研究了均匀载荷作用下多晶金刚石方膜在小挠度和大挠度下的应变分布情况。
A model for analyzing the large deflection of an elastic cantilever beam with constraint under uniformly distributed load was established.
建立了分析均布载荷作用下受约束悬臂梁的弹性大变形三阶段模型。
In this paper, we analyse the large deflection problem of the shallow spherical shells with variable thickness by means of boundary element method.
本文利用边界元方法分析了变厚度扁球壳的大挠度问题。
The large deflection buckling deformation of cold rolled strip acted on by residual stress is studied by using 3-Power spline function energy method.
采用三次样条函数能量法，对冷轧轧后带材在纵向残余应力作用下的大挠度屈曲变形和临界失稳问题进行了研究。
A simplified analytical method for the elastoplastic dynamic large deflection response of portal frames under impact loading is reported in this paper.
本文报道一种求解门式刚架在冲击载荷作用下动态弹塑性大变形响应的简便分析方法。
This paper gives the exact solution of large deflection of circular sandwich plate under the action of uniform lateral load by the method of power series.
本文应用幂级数方法求出了在均布载荷作用下夹层圆板大挠度问题的精确解。
Considering the residual stress, the total stress analytical solutions for square-shaped boron-doped silicon diaphragms with large deflection are presented.
考虑残余应力的情况下，薄膜在大挠度时总应力的解析表达式。
The influence of large deflection on the stress and displacement of the thin-walled box continuous girder with variable cross - sections depends on the load.
大挠度对变截面连续梁箱梁内力、位移的影响程度取决于荷载。
A new approximate formula for the large deflection problem of compression bar with two ends are simply supported is obtained, by the use of Ritz-Galerkin method.
通过非线性振动中常用的里兹-伽辽金法，推出了两端铰支压杆大挠度问题的一个新近似公式，计算结果表明具有较高的精度。
Basing on the elastic bending theory of beams in large deflection, the non-linear shearing behavior of cellular materials under large deformation is studied in the paper.
将梁的弹性大挠度弯曲理论应用于蜂窝壁板，研究了大变形条件下蜂窝材料的非线性剪切变形行为。
The problem of solving large deflection plate by the variational method is changed into that of solving systems of cubic algebraic equations with multi-unknown quantities.
采用变分法求解薄板大挠度问题的高级近似解时将导致多元三次代数方程组。
To begin with, in this paper, the displacement governing equations and the boundary conditions of nousymmetrical large deflection problem of circular thin plates are derived.
本文首先导出圆薄板非轴对称大变形问题的位移基本方程及边界条件。
The large deflection problems of the symmetrically laminated cross-ply circular plates of fiber reinforced composites are investigated in this paper by using Galerkins procedure.
本文探讨了纤维增强复合材料正交对称铺设层合圆板的大挠度弯曲问题。
In this paper, the elastic rod theory is applied to establish a static analytical mechanical model for a small strain, large deflection Marine pipeline during installation in ocean.
本文运用弹性杆理论建立了小应变、大挠度铺设过程中海底管道的静态分析力学模型。
The solutions of a large deflection problem of thin orthotropic circular plates with variable thickness under uniform pressure and under concentrated load are obtained in this paper.
本文给出了正交各向异性变厚度圆薄板在均布载荷与集中载荷作用下大挠度问题的解。
On the basis of classical lamination theory and large deflection hypotheses of plate, the equilibrium and compatibility equations of simply supported composite laminated plates were obtained.
基于经典的层合板理论及板的大挠度基本假设，得到四边简支层合板的非线性运动方程及变形协调方程；
The solution of large deflection problem of thin orthotropic circular plates with variable thickness under uniform pressure under simply supported boundary condition is obtained in this paper.
本文给出了正交各向异性变厚度周边简支圆薄板在均布载荷下大挠度问题的解。
The numerical experiments show that the high order polynomial analytic method can quickly, efficiently and reliably design high performance supersonic large deflection Angle preliminary profiles.
数值模拟实例表明，高次多项式解析造型方法能快速、高效、可靠地设计出高性能的超音速大转折初始叶型。
应用推荐