• This technology can not only reduce the cost of producing lactide , but also solve the pollution problems from kitchen garbage.

    本工艺不但可降低丙交酯的生产成本,而且解决了厨房垃圾的环境污染问题。

    youdao

  • Meanwhile, the effect of lactide contents on copolymer was studied.

    本文同时考虑了乳酸单元含量对聚合物性能的影响。

    youdao

  • The synthesis and thermal stability of poly(L-lactide)were investigated.

    对聚丙交酯的合成和热稳定性进行了研究。

    youdao

  • The Clinical Application of Poly (lactide), Sichuan Biochem-ZX Research Co., Ltd, Minglong Yuan.

    聚乳酸制品在临床上的应用,四川琢新生物材料研究有限公司,袁明龙。

    youdao

  • Study on Blends of Poly (lactide) and Starch, Sichuan University, Yuan Minglong, Wang Guiheng, Deng Xianmo.

    聚乳酸与淀粉共混的研究,四川大学高分子材料学院,袁明龙,王贵恒,邓先模。

    youdao

  • Polylactic acid synthesis in two major ways:direct polymerization and lactate lactide ring-opening polymerization.

    聚乳酸的合成方法主要有两种:乳酸直接聚合和丙交酯开环聚合。

    youdao

  • This experiment aimed at investigating the effect of a kind of home bred poly DL lactide screws on fracture healing.

    本实验旨在研究一种自制PDLLA螺钉对骨折愈合的影响。

    youdao

  • Butyl lactate was synthesized by the ester exchange reaction of d, L-lactide and n-butanol under the catalysis of sulfuric acid.

    研究了D,L -丙交酯在浓硫酸催化作用下与正丁醇进行酯交换反应合成乳酸丁酯的条件。

    youdao

  • Poly(L-lactide)(PLLA) was synthesized by ring-opening polymerization of L-lactide using cyclic tin alkoxide compound as initiator.

    以环烷氧锡化合物引发L-丙交酯开环聚合制备高分子量聚L-乳酸。

    youdao

  • There are two main methods to synthesis PLA, condensation polymerization of lactic acid and ring-opening polymerization of lactide.

    聚乳酸的合成主要有两种方法:乳酸直接缩聚和丙交酯的开环聚合。

    youdao

  • OBJECTIVE To investigate the effect of adding ethanol in inner organic phase on the properties of poly (d, 1-lactide) microspheres.

    目的考察内相乙醇加入量及其他制备因素对聚丙交酯微球性质的影响。

    youdao

  • Objective To observe the effect of the poly dl lactide (PDLLA) used as cell culturing scaffold on the growth of rabbit chondrocytes.

    目的观察国产外消旋聚乳酸(PDLLA)材料为细胞载体对软骨细胞吸附生长增殖的影响。

    youdao

  • There are two main methods to synthesis PLA, ring - opening polymerization of lactide and condensation polymerization of lactic acid.

    聚乳酸的合成主要有两种方法:丙交酯的开环聚合和乳酸直接缩聚。

    youdao

  • Specific drug–polymer interactions are engineered by optimizing the lactide to glycolide ratio and including specific polymer end groups.

    通过优化丙交酯与乙交酯比例及加入特殊的聚合物末端基来获得特殊的药物-聚合物间相互作用。

    youdao

  • Specific drug–polymer interactions are engineered by optimizing the lactide to glycolide ratio (L:G ratio) and including specific polymer end groups.

    通过优化丙交酯与乙交酯比例(L:G比)及加入特殊的聚合物末端基来获得特殊的药物-聚合物间相互作用。

    youdao

  • In this paper, the polylactic acid is synthesized by two-step method from lactic acid to lactide, then open-ring polymerize to PLA (polylactic acid).

    采用二步法由乳酸制备丙交酯,由丙交酯的开环聚合制备高分子量的聚乳酸。

    youdao

  • Improved the method of purification, the structure of lactide was characterized by the melting point, IR, UV, Digital Automatic Polarimeter and HPLC.

    改进了提纯L -丙交酯的方法,采用熔点、红外光谱、紫外光谱、数字自动旋光仪及高效液相色谱对提纯后的L -丙交酯进行了表征。

    youdao

  • As its biodegradability and biocompatibility, poly(lactide) (PLA) has been wildly used in medical suture, tissue engineering scaffold and drug delivery carrier.

    聚乳酸的生物降解率较高且其降解产物无毒,已被广泛用作医用缝线、组织工程支架和药物控释载体。

    youdao

  • Recently, poly (d, l-lactide) -poly (ethylene glycol) (PLA-PEG) block copolymers have been widely applied owing to the favorable biodegradability and biocompatibility.

    聚乳酸-聚乙二醇嵌段共聚物因具备良好的生物可降解性和相容性而得到广泛应用。

    youdao

  • The effects of the synthesis conditions such as monomer(lactide) purity, catalyst(stannous octoate) concentration, vacuum level, reaction time and temperature, were discussed.

    探讨了单体丙交酯纯度、催化剂辛酸亚锡用量、反应时间、反应温度及真空度对聚合物相对分子质量的影响。

    youdao

  • The resulted D, L-lactide and glycolide were found to have ring structure by fourier transform infrared spectrometry and proton nuclear magnetic resonance(1H NMR) spectrometry.

    通过傅立叶红外光谱和氢核磁谱(1H NMR)测试表明所合成的丙交酯和乙交酯具有环状结构。

    youdao

  • The influence of melt polycondensation and solvent refluxing methods of lactide polymerization and chain extension agents on relative molecular weight of polylactide was studied.

    研究了乳酸熔融缩聚和溶剂回流脱水缩聚两种聚合方法及几种扩链剂对乳酸聚合物相对分子质量的影响。

    youdao

  • Using the difference of the hydrolysis speed in the water between meso-lactide and other lactides, high pure L-lactide was obtained by water washing-four times recrystallization.

    利用内消旋丙交酯在水中水解的速度大于其它丙交酯的特点,用水洗和四次重结晶相结合的提纯方法,获得了高纯的L-丙交酯。

    youdao

  • The test showed that both methods were suitable for the quantitative determination of residual lactic acid and water in lactide, they were simple, convenient and easily applicable.

    实验表明,这两种方法可分别定量测定丙交酯中残存乳酸和水,且简捷实用。

    youdao

  • Lactide monomer was obtained by vacuum distillation of lactic acid. After purification by recrystallization, the lactide was polymerized to polylactic acid with zinc oxide as the catalyst.

    乳酸经减压蒸馏制得单体丙交酯,再以氧化锌为催化剂聚合得到聚乳酸。

    youdao

  • Lactide is the intermediate for preparing of polylactic acid from lactic acid. The yield of lactide is the key factor to influence the extensive production and low the cost of polylactic acid.

    丙交酯是以乳酸为原料制备高分子量聚乳酸的中间体,因此丙交酯的收率是影响聚乳酸大规模生产及其生产成本的关键因素。

    youdao

  • The invention discloses a method for continuously rectifying and purifying the lactide with high yield rate, which belongs to the field of chemical and industrial rectification and purification.

    本发明公开了一种高收率连续化精馏提纯丙交酯的方法,属于化工精馏提纯领域。

    youdao

  • Disclosed is a means for producing lactide efficiently in the production of a poly(lactic acid) by depolymerizing a lactic acid oligomer to produce lactide and ring-opening-polymerizing lactide.

    本发明在对乳酸低聚物进行解聚并对得到的丙交酯进行开环聚合的聚乳酸的制造中,提供一种高效地得到丙交酯的方法。

    youdao

  • The Ring-opening polymerization(ROP) of D-lactide(D-LA) catalyzed by bifunctional thiourea catalyst has been studied by performing density functional theory calculations at the B3LYP/6-31G(d) level.

    用密度泛函理论在B3LYP/6-31G(d)水平上研究了双官能团硫脲催化丙交酯开环聚合反应的微观机理。

    youdao

  • The Ring-opening polymerization(ROP) of D-lactide(D-LA) catalyzed by bifunctional thiourea catalyst has been studied by performing density functional theory calculations at the B3LYP/6-31G(d) level.

    用密度泛函理论在B3LYP/6-31G(d)水平上研究了双官能团硫脲催化丙交酯开环聚合反应的微观机理。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定