In order to produce high quality single crystal, the solid liquid interface morphology must be smooth, even be plane.
为了获得高质量的单晶，固-液界面面必须平滑，甚至是平界面。
The influence of heat treatment temperature on the binding interface morphology and properties of explosive cladding steel plate was studied.
研究了不同热处理温度对爆炸焊接复合钢板结合界面组织和性能的影响。
The effects of temperature gradient and interfacial growth velocity on solid-liquid interface morphology were studied with succinonitrile under the unidirectional solidification system.
以琥珀腈为研究对象，用设计的定向凝固实验体系，研究了不同温度梯度和界面生长速度对固液界面形貌的影响。
As a result, the chemical coupling of compatible agent plays an important part in the amelioration of interface combination between two phases and micro-structure morphology of blands.
结果表明，界面相容剂的化学偶联对促进两相之间的界面结合和改善共混物的微观结构形态起着重要作用。
Furthermore, the crystal morphology and the growing interface were also discussed.
此外，我们对晶体的外形和生长界面作了讨论。
It is shown that morphology, phase interface structure and crystal structure were different with the change of the tested alloy component.
研究结果表明：合金成分不同，马氏体形态、亚结构及其晶体结构也不同。
It is shown that the interface linear graded DBR has the minimum roughness and better surface morphology, which can be used in the fabrication of vertical cavity surface emitting lasers.
结果表明，相同周期数情况下线性渐变dbr相对于其他两种结构粗糙度最小，具有良好的表面形貌，可以应用于垂直腔面发射激光器的研制。
A series of Al-Al explosive welding experiments were carried out to investigate the morphology characters of welding interface under the condition of different charge ratios.
对铝-铝同质金属爆炸焊接进行系列实验，研究不同装药比条件下焊接界面的变化特征。
In addition, the surface morphology of active composite layer and the interface modification between active layer and electrodes could also influence the power conversion efficiency of the solar cell.
通过对器件活性层和电极界面进行修饰和采用不同溶剂、不同给受体掺杂比例、不同活性层厚度成膜等方法对器件进行优化并研究其与器件性能之间的关系；
In addition, the surface morphology of active composite layer and the interface modification between active layer and electrodes could also influence the power conversion efficiency of the solar cell.
通过对器件活性层和电极界面进行修饰和采用不同溶剂、不同给受体掺杂比例、不同活性层厚度成膜等方法对器件进行优化并研究其与器件性能之间的关系；
应用推荐