This article elucidates the acceptance limit and dimension tolerance designing in the course of acceptance inspection.
工件在验收过程中的验收极限和设计中尺寸公差的极限尺寸不是同一个概念。
Fire extinguishing agent through the national fixed fire extinguishing systems and components tolerance of Quality Supervision, Inspection Centre competent examiner.
灭火剂通过国家固定灭火系统和耐构件质量监督检验中心合格检验。
With two meters by ruler of wall structure, inspection, shall not exceed 5 mm maximum deviation, cut or out-of-tolerance part should be picked with a than three repair cement mortar leveling.
对结构墙体，用两米靠尺检查，最大偏差不得超过五毫米，超差部分应剔凿或用一比三水泥砂浆修补平整。
With two meters by ruler of wall structure, inspection, shall not exceed 5 mm maximum deviation, cut or out-of-tolerance part should be picked with a than three repair cement mortar leveling.
对结构墙体，用两米靠尺检查，最大偏差不得超过五毫米，超差部分应剔凿或用一比三水泥砂浆修补平整。
应用推荐