Unless it's corrected by "zeroing," the resulting offset produces an error by adding to the input signal.
如果不进行“调零”修正，所产生的偏置量就会叠加到输入信号上产生误差。
If the AC voltage at the input is large, part of this signal is rectified, producing an error in the DC signal being measured.
如果输入端的交流电压很大，其一部分信号被整流，于是在被测的直流信号中产生了误差。
Fast Fourier transform (FFT) is the main algorithm for harmonic analysis in electric power system, but when there is the decaying DC component in input signal, FFT algorithm will have higher error.
快速傅里叶变换(FFT)是电力系统进行谐波分析的主要算法，但当输入信号中含有衰减直流分量时，FFT算法会产生较大的误差。
The jitter error brought in by the aperture jitter increases as the frequency increase of the input signal in high speed data acquisition systems, thus it degrades the system's SNR.
结果表明，孔径抖动引起的孔径误差随着高速数据采集系统输入信号频率的升高而增大，由此将引起系统信噪比的下降。
The total error due to finite observation and bias is dependent on the limited level of the quantized input signal.
由偏差和测量时间有限而引起的总误差与量化输入信号限幅电平有关。
In multimedia signal processing, quantization error is a function of input signal and it results in the audible distortion and noise modulation in the audio signals.
在多媒体信号处理中，由于量化误差是输入信号的函数，使得语音信号产生信号失真和噪声调制。
It is proved that the proposed method can not only guarantee the bounded of the input signal, but also make the tracking error converge to a small neighborhood of the origin.
证明了该方法不但可以保证输入信号有界，而且可使跟踪误差收敛到原点的小邻域内。
This paper discusses the relationship among the correlation of input signal, weights number and steady state square error of the LMS algorithm in detail.
该文详细讨论了LMS算法中输入信号相关性、加权数目和稳态均方误差的关系。
As the charge exerted from input voltage source is dependent on quantization error and input noise voltage to a large extent, the circuit has high signal input impedance.
由于提取自输入电压源的电荷很大程度上仅取决于量化误差与输入噪声电压，所以电路具有高信号输入阻抗。
Training sample set inevitably contains gross error in input signal reconstruction of nonlinear multifunctional sensor.
在非线性多功能传感器的信号重构过程中，训练样本集不可避免地夹杂粗差数据。
The process-gains of the general receivers of DS/SS can't satisfy a low bit-error-rate if the signal-noise-ratio of input signal is very low.
在输入信噪比极低的直序扩频系统中，常规的接收机获得的处理增益难以满足系统低误码率的要求。
The process-gains of the general receivers of DS/SS can't satisfy a low bit-error-rate if the signal-noise-ratio of input signal is very low.
在输入信噪比极低的直序扩频系统中，常规的接收机获得的处理增益难以满足系统低误码率的要求。
应用推荐