The uniquely designed intel control system has a servo cylinder that can regulate the inlet volume between 0~100% and is an effective way to save energy.
设计独特的进气控制系统，伺服气缸调节进气量从0~100%，是节省能源的有效措施。
The effects of intake chamber volume, diameter and length of inlet duct and inlet manifold on volumetric efficiency were analyzed.
分析了进气总管和进气支管的管长、管径以及进气腔容积对充气系数的影响规律。
With adoption of the typical flue gas inlet parameter for FGD, this article completes above calculation with humidity and pressure volume heat concept, and analyzes the relative changing rules.
计算采用典型F GD入口烟气参数，应用烟气湿度和定压容积热容的概念计算了吸收塔出口烟气温度及塔内蒸发水量，并分析了其变化规律。
The air inlet and the air outlet of each section are provided with a regulating valve to adjust the air volume.
在每节的进风口与出风口处都设有调节阀，调节风量的大小。
Gas composition, volume flow rate, axial power, pressure and temperature of inlet and discharge gases of the compressor have been evaluated with the international general standard.
采用国际通用标准对压缩机气体组成、容积流量、轴功率、进排气压力和进排气温度等指标进行了测定。
The influence of flowing area, structural of valve head, inlet density and outlet specific volume to mass flow coefficient were studied.
得到了膨胀阀的流通面积、阀头结构、膨胀阀入口密度、阀后比容对流量特性的影响，并拟合了流量系数关联式。
The air exhaust pipe is sleeved on the air inlet pipe, so that the air inlet pipe is located in the center of the whole tank, so as to reduce piping space and reduce the volume of the whole device.
抽气管套在进气管上，使进气管位于整个罐体的中心位置，缩减了管排布空间，减小了整个装置的体积。
The volume of liquid inlet chamber is increased through the rotation of push rod, and the polymer liquid enters through the self pressure.
通过推杆的旋转使进液腔的体积增加，聚合物溶液通过自身压力进入。
It also has wind volume adjuster to change the wind of inlet from emitting into inhaling, which make sure it can deduct collectively to prevent environmental pollution.
设有风量调节器，入料口变排风为吸风，能集中除尘，防止污染。
Traditional bin pump using the double gate valve as inlet valve. After material filled with large volume vessel, this system using a strong air flow to blow the material into silo.
传统的仓式泵一般采用双闸阀作为进料阀，在输送过程中采用“集中一次输送”，即使用大容积的发送罐，然后通过较大的气耗量将物料吹至接受仓。
GPA-1 oil inlet will be installed with an adverse proof valve to avoid the dripping of oil when the processing stops. Thus there is no need to reset the volume of oil spray for the next process.
入油口加装止逆阀，可避免加工停止时油品垂滴，及不需于下次加工时重复设置油雾量。
GPA-1 oil inlet will be installed with an adverse proof valve to avoid the dripping of oil when the processing stops. Thus there is no need to reset the volume of oil spray for the next process.
入油口加装止逆阀，可避免加工停止时油品垂滴，及不需于下次加工时重复设置油雾量。
应用推荐