The current depends on the electron-injection angle.
平均电流对角度的依赖性很大；
The experimental results showed that about 30 degrees of injection angle gave the lowest consumption of fuel.
试验结果表明在30度左右喷油提前角时综合油耗最低。
Chuech, S. G. and Huang, Wu-Cheng, 2006, "The Effects of Injection Angle on the Shapes of Annular Liquid Films, " Proceedings of 6th Conference on Membrane Science and Technology, Chungli, Taiwan.
阙振庚、黄戊辰，2006，“环状液体膜幕之实验与数值模拟，”第十六届燃烧学术研讨会，基隆。
The influences of reducing the distance between the target and magnet exit and the effect of changing injection Angle of the magnet have been discussed to obtain the more compact deflecting magnet.
为实用需要，探讨了缩短靶与磁铁出口的距离和改变入射角所引起的影响，以便减少旋转治疗头的回转半径和设计更轻巧的偏转磁铁。
Objective to investigate the effect of air injection to the anterior chamber treating shallow anterior chamber after trabeculectomy in primary Angle closure glaucoma (PACG).
目的探讨应用前房注气术治疗原发性闭角型青光眼小梁切除术后浅前房的效果。
There are three parameters of fuel injection system: response pressure, injection-advanced angle, injection valve bulge high degree, the best match was found by adjusting them.
对于喷油系统参数：喷油压力、静态供油提前角和油嘴凸出高度，三个参数进行调整试验，找到它们的最佳匹配。
The impact of drift Angle on gas injection development of gas condensate reservoir is relatively large.
倾角对凝析气藏注气开发的影响比较大。
Conclusion the position of injection, the technique of inserting and removing needles from patients, the Angle and pace of injection are crucial to achieve painless injection.
结论注射部位的选择、进针拔针技巧、进针角度、针力和掌握好注射快慢对无痛注射至关重要。
It shows that the effects of back pressure on penetration, spray cone Angle, and decline rate of centerline velocity and concentration of the spray are greater than that of fuel injection pressure.
背压对贯穿距离、喷雾锥角、喷雾轴心速度和浓度衰减率的影响均大于启喷压力。
Soot formation can be restrained hence the emission of soot can be decreased with the increased injection advance Angle.
增大供油提前角可以减少燃烧过程前期的碳粒生成量，进而降低碳粒排放。
It's the first time to question extensively the influences of fuel delivery advance Angle and injection pressure on performance of E30 engine.
首次系统地研究了供油提前角、喷嘴启喷压力对E30混合燃料发动机性能的影响。
The effect of different diesel parameters such as spray impingement mode and fuel supply advanced Angle and injection opening pressure on the performance and emissions is compared and analyzed.
比较分析了柴油机不同参数，包括喷雾碰撞形式、供油提前角、启喷压力等对第三代伞喷燃烧性能和排放的影响。
The calculation result indicates that choose the appropriate compression ratio, the Angle of fuel injection can improve the cylinder burn and reduce the fuel exhaust.
计算结果表明，选择合适的压缩比、喷油提前角，可以改善缸内的燃烧过程，降低燃油消耗率。
The deflection angle of injection mainly depends on the valve port angle and almost has no relation to the valve size, but the reduction coefficient vavies with both of them.
射流的偏转角主要受阀口角度的影响，几乎与阀口尺寸无关；但射流的收缩系数则与两者都有关系。
Different forms of injection cone and different injection cone Angle have little influence on current heaters.
油嘴的喷油锥体形式及喷油锥角对现用加热器的性能影响不大。
The maximum network output error of fuel injection pulse width and ignition advance Angle is less than 1%, with an average error of less than 0.
喷油脉宽和点火提前角的网络输出最大误差小于1%，平均误差小于0。
At the end, an experimental research is carried out on the oil injectors used for injector heater with different oil-supply, different forms of injection cone and different injection cone Angle.
最后对喷射式燃油加热器所用油嘴进行了不同供油量、不同喷油锥体形式和不同喷油锥角台架试验研究。
Due to the smaller Angle of injection, the ratio of total pressure loss of aerodynamic ramp is less than the physical ramp and transverse injection stream.
由于喷流方向与主流方向夹角较小，总压损失也较物理斜坡、横向喷流等混合增强方式小。
The injection advance Angle is too large.
供油提前角太大。
And new viewpoints about the adjust of the fuel delivery advance Angle and fuel-injection pressure were put forward under the condition of plunger wear.
最后就柱塞副磨报后供油提前角和喷油压力的调整策略提出了新观点。
And new viewpoints about the adjust of the fuel delivery advance Angle and fuel-injection pressure were put forward under the condition of plunger wear.
最后就柱塞副磨报后供油提前角和喷油压力的调整策略提出了新观点。
应用推荐