In the first study, it 'recommend an initial ratio of repairing material based on system analysis by orthogonal test method which explore the general using scope about kinds of raw materials.
研究中，首先用正交试验方法探寻了各类原材料组成的大致范围，再基于试验结果的系统分析确定了裂缝修补材料的初步配合比。
On the other hand, if possible, a physical model to meet the product requirements, and according to the initial ratio of simplified, so that anyone can design and modeling of the correct evaluation.
另一方面，如果可能，一个物理模型以符合产品要求的方式，并且按初始比例简化，以便使任何人都能在设计和造型上做出正确的评价。
So ever fewer cases are going to trial: the ratio of federal trials to initial filings in 2009 was a twelfth of what it was in 1962.
如此一来，需要审理的案件越来越少：2009年开庭审理的联邦案件与原始诉讼案件的比例仅为1962年的十二分之一。
Because of the high compressible property of MSW, the influence of initial void ratio is very little.
由于MSW的高压缩性，初始孔隙比不同对试样的动力特性影响不大。
Initial analysis revealed that the presence of any pathogen was associated with an increased risk for asthma exacerbation, at an odds ratio (or) of 2.77.
初步分析显示，任何病原体的出现均与增加哮喘恶化风险相关，让步比(OR)为2.77。
The high compressive property of MSW makes the influence of the initial void ratio insignificant.
由于MSW的高压缩性，初始孔隙比不同对试样的动力特性影响不大。
This finite element method is employed to analyze the behavior of eccentrically loaded CFST columns, taking initial stress degree, slenderness ratio, and eccentric ratio as the parameters.
应用该方法，以长细比、偏心率和初应力度为主要参数对有初应力的钢管混凝土偏压构件进行了受力性能分析。
An effective way of obtaining high energy gain of MFCG is to increase the ratio of its initial inductance to load inductance by increasing the initial one.
通过增加MFCG的初始电感以增加其对负载电感的比值，是获得高能量放大系数的一个有效方法。
The initial estimation method of PU injecting dosage and application of different ratio of insufficient injection dosage in household refrigerator was introduced.
介绍了家用电冰箱注料量的初始估算方法和不同比例注料技术在家用电冰箱发泡上的应用。
The traditional dilatancy equation of Cam-clay model was modified and the relativity between the phase transformation stress ratio and initial effective pressure was considered.
模型对传统修正剑桥模型中的剪胀性公式进行了改进，考虑了状态转换应力比与初始有效围压的相关性。
The higher the initial relative peak power is, the higher the compression ratio and compressed peak power of the bright pulse are.
初始相对峰值功率愈高，亮脉冲的压缩比和压缩后的峰值功率愈高，同时所需的光纤长度愈短。
Numerical results show that the squeezing ratio decreases at some initial distance when the soliton source chirp is positive.
数值求解结果表明，孤子源正啁啾在初始一定距离范围内能减小压缩比。
Numerical results show that the squeezing ratio decrease at some initial distance when the amplitude increase and the squeezing was best if pluse wave shape near fundamental soliton.
数值结果表明，增大初始振幅在初始一定距离范围内能减小压缩比，接近理想光孤子的脉冲波形压缩效果最好。
Abrasion and mechanical properties test of concrete have shown that the degree of abrasion dependent on initial abrasion ratio, flexural strength and limit strain.
从混凝土磨蚀和力学性能试验得知，水工混凝土的磨蚀程度依赖于混凝土的初始磨损率，抗拉强度和极限拉伸变形值。
The results indicate that the stress path is not affected by changing the initial effective mean stress if the shear stress ratio remains the same.
如果保持相同的剪应力比，由初始有效平均正应力归一化的有效应力路径不受初始有效平均正应力的影响。
Concrete intensive grade is C25, the main variable parameters such as initial load and load history, CFRP amount, reinforcement ratio, anchor measure was adopted.
试验采用的混凝土强度等级为C25，主要变化参数为初始荷载及加载历史、CFRP加固量、纵筋配筋率、锚固措施等。
The relations between initial tangential modulus, confining pressure, over-consolidation ratio and initial void ratio were deduced, and were proved through triaxial compression test.
建立了初始切线模量与围压、超固结比、初始孔隙比之间的关系式，并通过三轴试验进行验证。
The effects of leaching temperature, initial KOH concentration, leaching time and mass ratio of alkali to ore on the leaching rate of Nb and Ta were investigated.
探讨了反应温度、初始KOH浓度、浸出时间和碱矿比等因素对铌和钽的浸出率的影响。
The selection of the initial shift register of M-sequence is a key technique in pulse compression waveform design whose pulse compression waveform must have low peak power and large compression ratio.
二相编码波形设计中初始移位寄存器的选择是个关键技术，它直接决定了信号波形在满足最小峰值功率下能否具有最大脉压比。
Results indicate the local high point height and additional tension stress of rolled strip are proportional to local high point initial height of strip, decrease as rolling reduction ratio increases.
研究结果表明：轧后带钢局部高点高度及附加张应力的大小与来料高点高度成正比，随总轧制压下率的增大而减小。
Though adopting two different calculation, the relation of initial gas and particle velocity ratio and movement time and kinematic range in accelerating zone was gained.
通过两种不同计算，得到气固速度比与固粒群的加速区的运动时间和距离的关系。
The effect of relative compaction, initial moisture content of specimens, strain rate, consolidation ratio and reconstitution of specimens and drainage condition are investigated.
对试样的相对压实度、初始含水量、应变速率、固结比、试样的重塑、排水条件因素等对稳定状态的影响进行了试验研究 。
It is obtained that initial water ratio, material figuration, specific heat and salt content are somewhat relative with microwave drying.
得出物料的初始含水率、物料形状、比热容与盐含量等对微波干燥影响有一定的相关性。
Aim To study the influence of initial concentration change of reactant on conversion ratio.
目的研究反应物初始浓度变化对转化率的影响。
The main variable parameters of beams are the reinforcement ratio, the initial cracks and the CFRP amount.
碳纤维加固混凝土梁的主要变化参数为配筋率、初始损伤和碳纤维粘粘量。
It shows the axial tension initial cracking strength of concrete increases with the increasing of steel fiber volume ratio and enhancing of concrete strength grade separately.
结果表明：混凝土轴拉初裂强度分别随钢纤维体积率的增大和混凝土强度等级的提高而增大。
With theoretical method based on the assumption of plane section, the influence of steel reinforcement ratio, CFRP amount and initial loading level on the flexural strength is analyzed.
利用基于平截面假定的正截面受弯承载力的计算理论，分析了配筋率、加固量及二次受力等因素的影响。
The experimental results show that the failure of specimens will be either hydraulic fracturing or shearing plastic flow, it depends on the initial principal stress ratio.
研究结果表明，在不同起始主应力比条件下，试件可以表现为水力劈裂破坏，也可以为剪切塑流破坏。
The experimental results show that the failure of specimens will be either hydraulic fracturing or shearing plastic flow, it depends on the initial principal stress ratio.
研究结果表明，在不同起始主应力比条件下，试件可以表现为水力劈裂破坏，也可以为剪切塑流破坏。
应用推荐