A few kinds from meat on the overall proportion, which can be seen on the flesh of the initial cooling by bacteria phase of pseudomonas to advantage bacterium, the largest proportion.
从冷却肉上几大类菌的总体所占比例中可以看出，冷却肉上的初始菌相中以假单胞菌属为优势菌，所占比例最大。
Selecting technology that minimizes floor space, cooling, and power requirements will pay off in the long term and will likely reduce the initial hosting bill.
要选择能够最小化地面空间、制冷和电源消耗的技术方案，这将会使您在长远意义上受益并有可能会减少托管服务的初始费用。
That cooling off time allows me to give it a little more thought beyond my initial reaction. It allows logic to step in, past the emotion.
这段冷静时间使我在原始反应的基础上思考更多，它允许理智的介入，跨越情绪。
The optimization of Initial Temperature Difference (ITD) is the relatively key part in the process of the design of the direct air cooling power station.
初始换热温差ITD值的优化是直接空冷电站设计过程中较为关键的部分，关系到整个电站设计是否经济、合理。
Then the authors analyse the effect of initial temperature and cooling rate on thermal stress and the low temperature cracking performance of different asphalt cement.
然后探讨了初始温度和降温速率等对温度应力的影响以及不同材料的低温抗裂性能。
The finite element mould of the cast steel cooling stave of blast furnace was established and the initial conditions and boundary conditions were determined.
建立了高炉铸钢冷却壁的有限元模型，确定了冷却壁温度场模拟的初始条件和边界条件。
The application of water-cooling throat steel-brick instead of traditional one can not only avoid the initial weakness but also obtain remarkable result.
将传统的炉喉钢砖改造为水冷炉喉钢砖，在高炉上应用后，避免了传统炉喉钢砖的弱点，取得了较好的效果。
Therefore, it is of great significance to study the cooling tower shell with initial geometrical imperfections.
因此对有初始几何缺陷的冷却塔风筒壁的分析研究是很有必要的。
This essay mainly specifies the impacts of the blade cooling technique on the turbine initial temperature.
着重叙述的是叶片的冷却技术对提高透平初温的影响。
Faster injection (up to a point): less cooling during filling, hence a thinner initial frozen layer, lower viscosity due to shear thinning;
较快注塑（到点）：在填料过程中冷却较少，因此初始固化层较薄，由于剪应变稀少而粘性较低；
Also a closing course of initial crack and thermal cracking coming into being in the cooling process are observed in our experiment.
实验还观察到砂岩表面微缺陷发生闭合的全过程，在冷却过程也有微裂纹形成等现象。
The mould is the core component of continuous caster for primary cooling and initial shell forming of liquid steel.
结晶器是连铸机的核心部件，完成将钢液初步凝固成型的任务。
The mould is the core component of continuous caster for primary cooling and initial shell forming of liquid steel.
结晶器是连铸机的核心部件，完成将钢液初步凝固成型的任务。
应用推荐