And in general the rod gets hot, and the work that you have done goes into heat and goes into the deformation of the rod.
通常棒子会变热，你做的功，变成热能，导致棒子的变形。
The microstructure evolution of Q235 plain carbon steel in multi-pass hot deformation was investigated by means of hot compression simulation.
利用热模拟压缩变形实验研究了Q 235碳素钢多道次热变形及后续处理过程的组织演变规律。
With up and down heating formed by 750W hot air handle on the top and 1500W preheater under PCB to have overall and even heating to avoid PCB deformation.
上下同步加热效果， 配备顶部的750W热风手柄及底部的1500W预热台， 有效防止线路板变形。
Vanward water heater tube explosion or hot water pipe deformation caused by water leakage; timely replacement.
万和热水器热水管爆管或热水管变形导致漏水；及时更换。
The effect of the whisker rotation on the hot compressive deformation behavior of the whisker reinforced aluminum matrix composite is investigated by the plane strain finite element method.
采用平面应变有限元方法研究了晶须转动对晶须增强铝基复合材料热压缩变形行为的影响。
By integrating the thermomechanical coupled FEM with mathematical model of microstructure evolution, the paper proposes a numerical prediction method for microstructure during hot deformation.
将热力耦合有限元方法与金属微观组织演变数学模型相结合，提出了热变形过程微观组织的数值预报方法。
This paper deals with the granular carbides formation from hot deformation in high chromium cast steel.
本文探讨了热变形高铬铸钢中颗粒状碳化物的形成。
Some problems of design for powder hot forging die have been discussed around the characteristics of forging deformation of powder preforms.
围绕粉未烧结体锻造变形的特点，讨论了粉末锻造模具设计的若干问题，并对一些粉末锻造模具进行了分析。
Some new secondary phases precipitates after hot deformation. The mechanical properties of the alloy after deformation treatment are improved.
合金在变形处理后有新的第二相析出，且合金的力学性能有很大提高。
To make measure and research on the infrared hot image in the deformation and destruction course under the function of pick cutting in order to analyze the deformation and destruction law.
对截齿截割煤体变形破坏过程的红外热像进行测量和研究，从而分析研究截齿截割作用下煤体变形破坏规律。
The simulation will help the hot plate leveling modeling and realize the law of leveling deformation.
该模拟结果对确定中厚板热矫直模型，掌握矫直变形规律具有一定的指导意义。
The coincidence of the predicted grain sizes with measured ones show that the method is able to successfully predict the microstructure of metals after hot deformation.
预报值与实测值吻合良好，表明本文方法已能成功预报热变形后的金属微观组织。
The effect of hot deformation amount on impact toughness for Vanadium white cast iron was studied.
研究了热变形量对钒白口铸铁冲击韧性的影响。
Direct quenching, n-in thermomechanical processing, quenching immediately following the final hot deformation.
直接淬火，名词，在形变热处理过程中，最终热变形之后立即进行淬火。
This paper researches the influence of technology parameters of hot deformation on the nonhomogeneous deformation between the austenitic grains and different zones within the grains.
本文研究了热形变工艺参数对奥氏体晶界和晶内不同区域的形变程度不均匀性的影响。
Pretreatment condition, i. e. cold or hot deformation, has important effects on microstructure evolution, and deformation of samples is a necessary step in SIMA process.
冷、热变形预处理条件对组织演变产生一定的影响，给试样施加变形是SIMA工艺的必要步骤。
The effect of carbon, molybdenum and rare earths on hot cracking susceptibility of austenitic stainless steel welds was studied with continuously variable deformation rate cracking test (VDR) method.
应用变形速率连续可变式热裂纹试验方法(VDR法)研究了碳、钼和稀土元素对奥氏体不锈钢焊缝热裂敏感性的影响。
The deformation resistance models of two steels during hot rolling have been established with regression analysis of reasonable structural formula.
用合理的模型结构形式回归了两钢种的热轧变形抗力模型。
In the paper, the hot deformation properties of sodium silicate shell in different temperature and different technology are studied.
研究了水玻璃型壳在不同温度下的热变形特征。
The hot deformation is one of the machine tool guideways deformations.
机床导轨热变形是导轨变形的一种形式。
Directional solidification could improve hot rolling formability of magnesium ingot effectively. The total deformation could reach 94% without cracking when hot rolling was held at 673k.
定向凝固工艺可有效提高镁合金铸锭的热轧成形能力，在轧制温度为673k的条件下进行热轧，总变形量可达94%以上而不出现裂纹。
For the experiment on the kinetics of strain-induced precipitation after hot deformation, steel-B was used.
样本钢b被用来做，经高温变形的沉淀物的动力张力实验。
B_2 phase in TAWY alloy contributes to hot processing and coordinate the deformation with absorbing and emitting the dislocations.
TAWY合金中的B_2相，通过吸收和发射位错来协调变形，对高温塑性变形有益。
BP neural network model for the study of constitutive relationship of the BT20 titanium alloy during hot deformation is constructed by the MATLAB program.
采用MA TLAB 程序建立BT20 钛合金高温变形时流变应力的神经网络模型，利用该模型对其他一些热力学状态下材料的流变应力进行了预测。
And has the high strength plastic, the middle steel wire support hot forming, arbitrary bending deformation characteristics.
内外有高强度塑料，中间有钢丝支撑热压成形，任意弯曲不变形等特点。
Error analysis shows that the constructed constitutive relationship has good accuracy and can preferably describe hot deformation behavior of TB6 titanium alloy.
误差分析表明，所建的本构关系具有较好的精度，能较好地反映TB 6钛合金的热变形行为特征。
The microstructure features at different hot deformation conditions were analyzed with optical microscope (OM) and transmission electron microscope (TEM).
利用光学显微镜（OM）和透射电子显微镜（TEM）观察合金不同热变形条件下的组织形貌特征。
Our main products are: E-Rally, electronic universal testing machine series; hot deformation.
公司主要产品有：电子拉力、电子万能试验机系列；热变形。
A three dimensional elastoplastic finite element model is presented for thermomechanical coupled finite deformation problems, and using the model, a slab hot rolling is computer simulated.
建立了三维热力耦合问题弹塑性有限变形有限元方法，并对板材热轧过程进行了计算机模拟。
A three dimensional elastoplastic finite element model is presented for thermomechanical coupled finite deformation problems, and using the model, a slab hot rolling is computer simulated.
建立了三维热力耦合问题弹塑性有限变形有限元方法，并对板材热轧过程进行了计算机模拟。
应用推荐