This system consists of host computer and slave computer two levels system.
系统由上位机和下位机二级系统构成。
The interface can be used in embedded system which need fast switch between USB host mode and slave mode. And it can be communicated with U disk in host mode and PC in slave mode.
最终实现了嵌入式系统USB主从模式的快速切换以及在主机模式下与U盘、从机模式下与PC机的通信。
Software system includes host and slave computer software design.
系统软件包含下位机和上位机软件设计。
The control system composes a host computer and many slave computers, among them serial com - munication is adopted.
该系统包括一个主机和多个从机，主—从机间采用串行通讯。
The control system is realized by the host slave system, which consists of 486 computer and TMS320C25. Experimental results have demonstrated the effectiveness of this kind of control strategy.
控制系统由TMS320C25及486计算机组成的主从机系统实现。实验结果表明此种控制方法是有效的。
Secondly, Single-Chip computer system soft design under host and slave mode of CH375 is introduced, and the paper shows the flow chart, the program design in detail and some codes.
其次，介绍了CH375主从模式下单片机系统软件设计，并给出了部分源代码和程序流程图；
The proposal based on USB Host/Slave controller chip CH375A, realized a USB-Host embedded in CAN bus data acquisition system and stored acquisition data of each node in U flash disk under MCU control.
该方案基于USB主/从控制芯片CH375A，在单片机的控制下，实现了CAN总线数据采集系统中嵌入USB主机，从而完成把各节点采集的数据存入U盘，取代了现场数据采集系统必须有一台计算机的模式。
The whole system is made up of a main computer and many intelligent nodes. Each intelligent node takes on microcontroller AT89C51 as host processor and Neuron chip TMPN3120 as slave processor.
系统由一台上位机和多个智能节点组成，智能节点采用单片机at89c51为主处理器，神经元芯片TMPN3120为从处理器。
The whole system is made up of a main computer and many intelligent nodes. Each intelligent node takes on microcontroller AT89C51 as host processor and Neuron chip TMPN3120 as slave processor.
系统由一台上位机和多个智能节点组成，智能节点采用单片机at89c51为主处理器，神经元芯片TMPN3120为从处理器。
应用推荐